Engineering topics

Mckenzie, Dan

Publications and source records attributed to Mckenzie, Dan.

5 records

NASA NTRS1992

Dike emplacement on Venus and on earth

Attention is given to long linear features visible in SAR images of the surface of Venus. They are shallow graben a few kilometers across. Calculations show that dike emplacement can account for such features if the top of the dikes is a few kilometers below the surface of the planet. The dikes are often curved near their probable sources, and the magnitude of the regional stress field estimated from this curvature is about 3 MPa, or similar to that of earth. On both Venus and earth, dikes often form intersecting patterns. Two-dimensional calculations show that this behavior can occur only if the stress field changes with time. Transport of melt over distances as large as 2000 km in dikes whose width is 30 m or more occurs in some continental shields on earth and can also account for linear features on Venus that extend for comparable distances. Such transport is possible because the viscosity and thermal conductivity of both the melt and the wall rock are small.

Mckenzie, Dan↗

NASA NTRS1992

Features on Venus generated by plate boundary processes

Various observations suggest that there are processes on Venus that produce features similar to those associated with plate boundaries on earth. Synthetic aperture radar images of Venus, taken with a radar whose wavelength is 12.6 cm, are compared with GLORIA images of active plate boundaries, obtained with a sound source whose wavelength is 23 cm. Features similar to transform faults and to abyssal hills on slow and fast spreading ridges can be recognized within the Artemis region of Venus but are not clearly visible elsewhere. The composition of the basalts measured by the Venera 13 and 14 and the Vega 2 spacecraft corresponds to that expected from adiabatic decompression, like that which occurs beneath spreading ridges on earth. Structures that resemble trenches are widespread on Venus and show the same curvature and asymmetry as they do on earth. These observations suggest that the same simple geophysical models that have been so successfully used to understand the tectonics of earth can also be applied to Venus.

Mckenzie, Dan↗

NASA NTRS1992

Pancakelike domes on Venus

The shape of seven large domes on the plains of Venus, with volumes between 100 and 1000 cu km, is compared with that of an axisymmetric gravity current spreading over a rigid horizontal surface. Both the altimetric profiles and the horizontal projection of the line of intersection of domes on the SAR images agree well with the theoretical similarity solution for a newtonian fluid, but not with the shape calculated for a rigid-plastic rheology, nor with that for a static model with a strong skin. As a viscous current spreads, it generates an isotropic strain rate tensor whose magnitude is independent of radius. Such a flow can account for the randomly oriented cracks that are uniformly distributed on the surface of the domes. The stress induced by the flow in the plains material below is obtained, and is probably large enough to produce the short radial cracks in the surface of the plains beyond the domes. The viscosity of the domes can be estimated from their thermal time constants if spreading is possible only when the fluid is hot, and lies between 10(exp 14) and 10(exp 17) Pa s. Laboratory experiments show that such viscosities correspond to temperatures of 610 - 690 C in dry rhyolitic magmas. These temperatures agree with laboratory measurements of the solidus temperature of wet rhyolite. These results show that the development of the domes can be understood using simple fluid dynamical ideas, and that the magmas involved can be produced by wet melting at depths below 10 km, followed by eruption and degassing.

Mckenzie, Dan↗

NASA NTRS1991

Venus tectonics - Initial analysis from Magellan

The styles of lithospheric deformation, the inferred mechanical properties of the lithosphere, and their implications for the tectonic history of Venus are discussed on the basis of radar imaging and altimetry data from Magellan. Observations of the planet plains reveal a superposition of different episodes of deformation and volcanism, strain both distributed and concentrated into zones of extension and shortening, and features reflecting a crustal response to mantle dynamic processes. Lithospheric shortening and crustal thickening are represented by ridge belts and mountain belts. The latter show the evidence for extension and collapse both during and following crustal compression. Venus displays quasi-circular coronae and broad rises with linear rift zones, associated with significant volcanism. Large-offset strike-slip faults have not been observed, although horizontal shear is accommodated across broad zones of crustal shortening. On Venus strain is distributed across zones that are one to a few hundred kilometers wide, and separated by stronger and less deformed blocks hundreds of kilometers in width, as in actively deforming continental regions on earth.

Solomon, Sean C.↗

NASA NTRS1987

Surface deformation, gravity and the geoid from a three-dimensional convection model at low Rayleigh numbers

The two-dimensional surface deformation, gravity field, and geoid are calculated from the temperature fields of a number of numerical models of constant-viscosity three-dimensional convective flows, heated from within and from below. The surface deformation and the geoid are insensitive to the short-wavelength features of the temperature variation; the gravity field is less smooth, although it still does not clearly indicate the narrowness of the upwelling and downwelling regions at large Rayleigh numbers. The results indicate that the convective upwelling beneath regions showing positive geoid and residual depth anomalies is more localized than the horizontal extent of these features would suggest. The results are relevant to attempts to understand the behavior of the earth mantle.

Craig, Claire Harvey↗