Search NASA⌕ Search

Engineering topics

Mclachlan, B. G.

Publications and source records attributed to Mclachlan, B. G..

16 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

Surface pressure field mapping using luminescent coatings

In recent experiments we demonstrated the feasibility of using the oxygen dependence of luminescent molecules for surface pressure measurement in aerodynamic testing. This technique is based on the observation that for many luminescent molecules the light emitted increases as the oxygen partial pressure, and thus the air pressure, the molecules see decreases. In practice the surface to be observed is coated with an oxygen permeable polymer containing a luminescent molecule and illuminated with ultraviolet radiation. The airflow induced surface pressure field is seen as a luminescence intensity distribution which can be measured using quantitative video techniques. Computer processing converts the video data into a map of the surface pressure field. The experiments consisted of evaluating a trial luminescent coating in measuring the static surface pressure field over a two-dimensional NACA-0012 section model airfoil for Mach numbers ranging from 0.3 and 0.66. Comparison of the luminescent coating derived pressures were made to those obtained from conventional pressure taps. The method along with the experiment and its results will be described.

Mclachlan, B. G.↗
NASA NTRS1993

Boundary layer transition detection by luminescence imaging

In recent experiments we have demonstrated the feasibility of a new approach to boundary layer transition detection. This new approach employs the temperature dependence of certain photoluminescent materials in the form of a surface coating or 'paint' to detect the change in heat transfer characteristics that accompany boundary layer transition. The feasibility experiments were conducted for low subsonic to transonic Mach numbers on two-dimensional airfoil and flat plate configurations. Paint derived transition locations were determined and compared to those obtained from Preston pressure probe measurements. Artificial heating of the models was used to obtain transition temperature signatures suitable for the instrumentation available to us. Initial estimates show, however, that passive kinetic heating at high Mach numbers is a promising alternative.

Mclachlan, B. G.↗
NASA NTRS1992

Flight testing of a luminescent surface pressure sensor

NASA ARC has conducted flight tests of a new type of aerodynamic pressure sensor based on a luminescent surface coating. Flights were conducted at the NASA ARC-Dryden Flight Research Facility. The luminescent pressure sensor is based on a surface coating which, when illuminated with ultraviolet light, emits visible light with an intensity dependent on the local air pressure on the surface. This technique makes it possible to obtain pressure data over the entire surface of an aircraft, as opposed to conventional instrumentation, which can only make measurements at pre-selected points. The objective of the flight tests was to evaluate the effectiveness and practicality of a luminescent pressure sensor in the actual flight environment. A luminescent pressure sensor was installed on a fin, the Flight Test Fixture (FTF), that is attached to the underside of an F-104 aircraft. The response of one particular surface coating was evaluated at low supersonic Mach numbers (M = 1.0-1.6) in order to provide an initial estimate of the sensor's capabilities. This memo describes the test approach, the techniques used, and the pressure sensor's behavior under flight conditions. A direct comparison between data provided by the luminescent pressure sensor and that produced by conventional pressure instrumentation shows that the luminescent sensor can provide quantitative data under flight conditions. However, the test results also show that the sensor has a number of limitations which must be addressed if this technique is to prove useful in the flight environment.

Mclachlan, B. G.↗
NASA NTRS1991

Processing Particle-Streak Imagery On A Personal Computer

Report describes simple flow experiment in which streak images of particles suspended in fluid and illuminated for short times processed into maps of velocity vectors. In experiment, semiautomatic data-reduction scheme used which recovers significant image data more efficiently than currently available automatic scheme.

Cho, Y. C.↗
NASA NTRS1988

Experimental and computational studies of unsteady viscous flows

This paper describes progress in validating incompressible Navier-Stokes codes using image-processed flow-field data. Solutions of the Navier-Stokes equations using a predictor/corrector scheme are compared directly with experimental data. A uniform asymptotic expansion is used as an initial condition in order to correctly capture the initial growth of the vortex sheet. With the aid of an experimental study in a tow tank using the particle streak visualization method, measured and computed velocity vectors are compared directly. Comparison of the velocity data with computations shows little effect of initial conditions and varying grid geometry on the predictive capabilities.

Davis, S.↗
NASA NTRS1987

Personal Computer (PC) based image processing applied to fluid mechanics

A PC based image processing system was employed to determine the instantaneous velocity field of a two-dimensional unsteady flow. The flow was visualized using a suspension of seeding particles in water, and a laser sheet for illumination. With a finite time exposure, the particle motion was captured on a photograph as a pattern of streaks. The streak pattern was digitized and processed using various imaging operations, including contrast manipulation, noise cleaning, filtering, statistical differencing, and thresholding. Information concerning the velocity was extracted from the enhanced image by measuring the length and orientation of the individual streaks. The fluid velocities deduced from the randomly distributed particle streaks were interpolated to obtain velocities at uniform grid points. For the interpolation a simple convolution technique with an adaptive Gaussian window was used. The results are compared with a numerical prediction by a Navier-Stokes computation.

Cho, Y.-C.↗
NASA NTRS1987

Slender delta wing at high angles of attack - A flow visualization study

The flow past a delta wing of aspect ratio one is examined at angles of attack ranging from 25 deg to 90 deg. On the basis of detailed observations of the flow in a water channel, using laser-induced fluorescence, four angle of attack flow regimes are identified, in addition to the well known regime of a stable pair of leading edge vortices. These are: a regime where the two leading edge vortices break down independently, primarily into the spiral form; a regime where spiral and bubble breakdowns alternate periodically on the two sides of the wing, accompanied by an antisymmetric motion in the chordwise direction of the two points of breakdown; a regime where a single streamwise vortex springing from the wing apex alternates in sign at irregular intervals; and finally, a regime dominated by a wake bubble and the relatively small scale vortices arising from the instability of its boundary.

Ayoub, A.↗
NASA NTRS1987

Cellular automatons applied to gas dynamic problems

This paper compares the results of a relatively new computational fluid dynamics method, cellular automatons, with experimental data and analytical results. This technique has been shown to qualitatively predict fluidlike behavior; however, there have been few published comparisons with experiment or other theories. Comparisons are made for a one-dimensional supersonic piston problem, Stokes first problem, and the flow past a normal flat plate. These comparisons are used to assess the ability of the method to accurately model fluid dynamic behavior and to point out its limitations. Reasonable results were obtained for all three test cases, but the fundamental limitations of cellular automatons are numerous. It may be misleading, at this time, to say that cellular automatons are a computationally efficient technique. Other methods, based on continuum or kinetic theory, would also be very efficient if as little of the physics were included.

Long, Lyle N.↗
NASA NTRS1987

On the effect of leading edge blowing on circulation control airfoil aerodynamics

In the present context the term circulation control is used to denote a method of lift generation that utilizes tangential jet blowing over the upper surface of a rounded trailing edge airfoil to determine the location of the boundary layer separation points, thus setting an effective Kutta condition. At present little information exists on the flow structure generated by circulation control airfoils under leading edge blowing. Consequently, no theoretical methods exist to predict airfoil performance under such conditions. An experimental study of the flow field generated by a two dimensional circulation control airfoil under steady leading and trailing edge blowing was undertaken. The objective was to fundamentally understand the overall flow structure generated and its relation to airfoil performance. Flow visualization was performed to define the overall flow field structure. Measurements of the airfoil forces were also made to provide a correlation of the observed flow field structure to airfoil performance. Preliminary results are presented, specifically on the effect on the flow field structure of leading edge blowing, alone and in conjunction with trailing edge blowing.

Mclachlan, B. G.↗
NASA NTRS1987

A study of a circulation control airfoil with leading/trailing edge blowing

An experimental study of the flow past a two-dimensional circulation control airfoil under steady leading/trailing edge blowing was conducted. The effect of varying jet momentum on the flow field was determined through the use of flow visualization and airfoil force measurements. The flow patterns associated with leading edge blowing, alone and simultaneously with trailing edge blowing, are described and correlated with the lift measurements.

Mclachlan, B. G.↗
NASA NTRS1987

Personal computer (PC) based image processing applied to fluid mechanics research

A PC based image processing system was employed to determine the instantaneous velocity field of a two-dimensional unsteady flow. The flow was visualized using a suspension of seeding particles in water, and a laser sheet for illumination. With a finite time exposure, the particle motion was captured on a photograph as a pattern of streaks. The streak pattern was digitized and processsed using various imaging operations, including contrast manipulation, noise cleaning, filtering, statistical differencing, and thresholding. Information concerning the velocity was extracted from the enhanced image by measuring the length and orientation of the individual streaks. The fluid velocities deduced from the randomly distributed particle streaks were interpolated to obtain velocities at uniform grid points. For the interpolation a simple convolution technique with an adaptive Gaussian window was used. The results are compared with a numerical prediction by a Navier-Stokes commputation.

Cho, Y.-C.↗
NASA NTRS1985

An experimental study of airfoil-spoiler aerodynamics

The steady/unsteady flow field generated by a typical two dimensional airfoil with a statically deflected flap type spoiler was investigated. Subsonic wind tunnel tests were made over a range of parameters: spoiler deflection, angle of attack, and two Reynolds numbers; and comprehensive measurements of the mean and fluctuating surface pressures, velocities in the boundary layer, and velocities in the wake. Schlieren flow visualization of the near wake structure was performed. The mean lift, moment, and surface pressure characteristics are in agreement with previous investigations of spoiler aerodynamics. At large spoiler deflections, boundary layer character affects the static pressure distribution in the spoiler hingeline region; and, the wake mean velocity fields reveals a closed region of reversed flow aft of the spoiler. It is shown that the unsteady flow field characteristics are as follows: (1) the unsteady nature of the wake is characterized by vortex shedding; (2) the character of the vortex shedding changes with spoiler deflection; (3) the vortex shedding characteristics are in agreement with other bluff body investigations; and (4) the vortex shedding frequency component of the fluctuating surface pressure field is of appreciable magnitude at large spoiler deflections. The flow past an airfoil with deflected spoiler is a particular problem in bluff body aerodynamics is considered.

Mclachlan, B. G.↗
NASA NTRS1984

Effects of Mach number on the development of a subsonic multiple jet

Results of an experimental study of the flow structure of a subsonic jet issuing from an array of rectangular lobes, equally spaced with their small dimensions in a line, are presented. The tests determined the affect of jet exit Mach number variations (0.3 to 0.8) on the flow field. Measurements of the mean velocity field and centerline rms velocity, along with schlieren flow visualization, were made. It was found that Mach number had no significant affect on the general flow field characteristics; and, that the flow field far downstream resembles that of a jet exiting from a two-dimensional nozzle with its short dimension being the long dimension of the lobe.

Mclachlan, B. G.↗
NASA NTRS1984

Flow structure within a heated rectangular jet ejector

Preliminary results of an experimental study of the flow field structure within a rectangular jet ejector are presented. The tests determined the effect of primary jet heating and ejector duct width on the flow field at a fixed jet exit Mach number of 0.3. For comparison the rectangular jet without the presence of the ejector shroud was also studied. Measurements of the mean velocity field, total temperature field, and ejector shroud surface pressure distribution, along with schlieren flow visualization, were made. It was found that: the ejector did not enhance centerline temperature decay in comparison to the free jet; the presence of the ejector shroud significantly reduced jet growth; and, the ejector centerline velocity/temperature decay was not sensitive to duct width variations.

Mclachlan, B. G.↗
NASA NTRS1983

A study of the unsteady flow field of an airfoil with deflected spoiler

The flow field generated by a two-dimensional airfoil with a statically deflected flap type spoiler has been experimentally studied. Subsonic tests ascertained the effect of varying spoiler deflection and angle of attack on the flow field at two Reynolds numbers. Measurements of the mean and fluctuating surface pressures and velocities in the wake, along with schlieren flow visualization of the near wake, were made. The results pertaining to the unsteady characteristics of the spoiler flow field are presented. It is shown that vortex shedding characterized the spoiler wake and determines the unsteady nature of the overall flow field; the character of the vortex shedding changes with spoiler deflection; and the fluctuating surface pressure field (vortex shedding frequency component) is of appreciable magnitude at large spoiler deflections.

Mclachlan, B. G.↗