Engineering topics

Mclean, W. J.

Publications and source records attributed to Mclean, W. J..

4 records

NASA NTRS1979

Hydrogen-fueled diesel engine without timed ignition

Experiments were carried out to investigate the feasibility of converting a diesel engine to hydrogen-fueled operation without providing a timed ignition system. Use was made of a glow plug and a multiple-strike spark plug. The glow plug was found to provide reliable ignition and smooth engine operation. It caused the hydrogen to ignite almost immediately upon the start of injection. Indicated mean effective pressures were on the order of 1.3 MPa for equivalence ratios between 0.1 and 0.4 at a compression ratio of 18. This is significantly higher than the corresponding result obtained with diesel oil (about 0.6 MPa for equivalence ratios between 0.3 and 0.9). Indicated thermal efficiencies were on the order of 0.4 for hydrogen and 0.20-0.25 for diesel oil. Operation with the multiple-strike spark system yielded similar values for IMEP and efficiency, but gave rise to large cycle-to-cycle variations in the delay between the beginning of injection and ignition. Large ignition delays were associated with large amplitude pressure waves in the combustion chamber. The measured NO(x) concentrations in the exhaust gas were of the order of 50-100 ppm. This is significantly higher than the corresponding results obtained with premixed hydrogen and air at low equivalence ratios. Compression ignition could not be achieved even at a compression ratio of 29.

Homan, H. S.↗

NASA NTRS1979

Temperature and species concentration measurements in a swirl-stabilized combustor

An experimental evaluation of a swirl-stabilized combustor is presented. The combustor is composed of two confined, concentric, swirling jets. The inner jet flow is lean premixed methane and air; the outer flow is air. Combustion is stabilized on a swirl-induced recirculation zone. Mean temperature and mean concentrations of major species are measured throughout the combustor, including the recirculation zone. Fine wire thermocouples are used to measure temperature. A gas chromatograph and a chemi-luminescence analyzer are employed to analyze samples extracted by a water-cooled gas-sampling probe. Results are presented in the form of isotherms and isopleths of species concentration in the combustor for two swirl conditions: co-swirl and counter-swirl. The effects of swirl on the combustion are discussed in light of flame quenching due to rapid dilution and cooling of the reacting inner jet flow by mixing with the outer flow. Evidence for probe induced perturbations of the combustion process is observed.

Oven, M. J.↗

NASA NTRS1977

NO-NO2 measurements in a methane-fueled swirl-stabilized combustor

Exhaust plane measurements of NO and NO2 emissions from a methane-fueled swirl-stabilized combustor are reported. Samples were obtained by water-cooled probes and analyzed by chemiluminescent and UV absorption techniques. The combustor consists of two confined concentric jets having swirl. The inner jet flows premixed fuel and air, the outer jet is air. Variable outer jet swirl allows operation with jets swirling either in the same or opposite directions (co- or counter-swirl), and the combustion is stabilized by the resulting recirculation zone formed on the combustor centerline. Swirl conditions strongly affect the NOx emissions because of the influence of swirl on the combustion process. In the co-swirl conditions, the inner flow reaches high temperatures, and the correspondingly high NOx emissions are primarily NO. Under counter-swirl conditions much lower values of total NO are found, and these emissions are almost entirely NO2. In this case vigorous mixing in the inter-jet shear layer leads to severe flame quenching and lower temperatures. Formation of NO2 is associated with quenching processes in the combustor and is thought to be formed via NO oxidation by HO2 free radicals.

Oven, M. J.↗

NASA NTRS1975

Experimental results with hydrogen fueled internal combustion engines

The paper focuses on the most important experimental findings for hydrogen-fueled internal combustion engines, with particular reference to the application of these findings to the assessment of the potential of hydrogen engines. Emphasis is on the various tradeoffs that can be made, such as between maximum efficiency, maximum power, and minimum NO emissions. The various possibilities for induction and ignition are described. Some projections are made about areas in which hydrogen engines may find their initial application and about optimum ways to design such engines. It is shown that hydrogen-fueled reciprocal internal combustion engines offer important advantages with respect to thermal efficiency and exhaust emissions. Problems arising from preignition can suitably be avoided by restricting the fuel-air equivalence ratio to values below about 0.5. The direct cylinder injection appears to be a very attractive way to operate the engine, because it combines a wide range of possible power outputs with a high thermal efficiency and very low NO emissions at part loads.

De Boer, P. C. T.↗