Search NASA⌕ Search

Engineering topics

Mease, K. D.

Publications and source records attributed to Mease, K. D..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1988

Optimization of aeroassisted orbital transfer - Current status

This paper presents the theory of optimal aeroassisted orbital transfer, with special consideration given to the transfer about a central body with an atmosphere, with propulsive maneuvers in space modeled as instantaneous changes in the velocity vector. It is shown that there are four potentially optimal transfer modes, two aeroassisted and two all-propulsive, for each point in the two-dimensional transfer space. Aeroassisted orbital transfer introduces a strong coupling between the trajectory design and the vehicle design; a trajectory that minimizes fuel mass without attention to heating may require the vehicle to have a heavy thermal protection system. It is emphasized that, if aeroassisted transfer is to be preferred to all-propulsive transfer, it must offer a reduction in fuel mass greater than the increase in thermal protection mass.

Mease, K. D.↗
NASA NTRS1988

Nearly-grazing optimal trajectories for noncoplanar, aeroassisted orbital transfer

This paper discusses aeroassisted orbital transfer maneuvers under the assumption that the terminal orbital inclinations are different. Both GEO-to-LEO and LEO-to-LEO transfers are considered in connection with a spacecraft which is controlled during the atmospheric pass via the angle of attack and the angle of bank. Within the framework of classical optimal control, the following problems are studied: the minimization of the total characteristic velocity (P1); the minimization of the time integral of the square of the path inclination (P5); and the minimization of the peak heating rate (Q1). Numerical solutions are obtained by means of the sequential gradient-restoration logarithm for optimal control problems under the conditions that, for the problem (P1), the plane change components are optimized, while for the problems (P5) and (Q1), the plane change components are kept at the levels determined for problem (P1). The engineering implications of the solutions are discussed, in order to determine the most useful solutions in the light of energy requirements and heat transfer requirements.

Miele, A.↗
NASA NTRS1988

Error analysis for a Mars landing

This paper presents the methodology and preliminary results of a Mars landing error study. Aeromaneuvering was used to reduce the effects of errors. The guidance and navigation techniques used were based on those used for the Space Shuttle. A simulation was built to determine the performance of these techniques in a realistic Mars landing scenario. The results indicate that knowledge errors dominate, and that terminal three-sigma errors of between 1 and 15 kilometers can be achieved depending on the data types available. The data types studied were restricted to those currently under consideration for the Mars Rover/Sample Return Mission.

Mceneaney, W. M.↗
NASA NTRS1988

Optimal plane change during constant altitude hypersonic flight

Future spacecraft operating in the vicinity of the earth may have resort to the atmosphere as an aid in effecting orbital change. While a previous treatment of this technique chose constant altitude, speed, and angle-of-attack values in order to maximize the plane change for a fixed amount of propellant consumption during hypersonic flight, the former two parameters are presently released from the constraint of constancy. The general characteristics of the optimal controls are described on the basis of the domain of maneuverability, and numerical solutions are obtained for several specific cases. Under the condition of constant-altitude flight, it is generally not optimal to fly at constant angle-of-attack.

Mease, K. D.↗
NASA NTRS1987

Optimal trajectories for aeroassisted, noncoplanar orbital transfer. II - LEO-to-LEO transfer

Both classical and minimax problems of optimal control arising in the study of noncoplanar, aeroassisted orbital transfer are considered and are illustrated with the example of LEO-to-LEO transfer. Trajectory control is achieved by modulation of the lift coefficient and the angle of bank. Problems considered include the minimization of the energy required for orbital transfer, maximization of the flight time during the atmospheric portion of the trajectory, and minimization of the peak heating rate. The near-grazing solution is found to be a good compromise between energy and heating requirements.

Miele, A.↗
NASA NTRS1986

Autonomous Orbital Calculation for Satellites

Onboard orbital navigation system reduces dependence on Earth-tosatellite links. Report discusses mathematics of proposed navigation subsystem that keeps geostationary satellite in proper orbit without ground control. Subsystem uses data from Earth and Sun sensors to activate thrusters for station-keeping maneuvers. With sensors already on satellites for determining attitude, subsystem maintains satellite within 3 degrees of specified equatorial longitude for up to 6 months. With more accurate sensors, subsystem able to maintain orbit within 0.1 degrees.

Mease, K. D.↗
NASA NTRS1986

Nearly-grazing optimal trajectories for aeroassisted orbital transfer

In the present treatment of optimal control problems arising in the study of coplanar aeroassisted orbital transfer, the hybrid combination of propulsive parameters in space and aerodynamic maneuvers employing lift modulation in the sensible atmosphere indicates that the optimal energy-viewpoint solution is the grazing trajectory; this trajectory is characterized by favorable values of the peak heating rate and the peak dynamic pressure. Numerical solutions are obtained by means of the sequential gradient restoration algorithm for optimal control problems. It is found that nearly-grazing trajectories yielding the least-square value of the path inclination have desirable characteristics from the standpoints of energy, heating rate, and dynamic pressure.

Miele, A.↗
NASA NTRS1985

Effect of maximum lift to drag ratio on optimal aeroassisted plane change

The influence of the maximum lift-to-drag ratio on the turning performance of an Orbital Transfer Vehicle is analyzed. Chapman's variables are used to formulate the equations of motion which are valid for both atmospheric flight and flight in a vacuum in a Newtonian gravitational field. Of the six adjoint variables involved in the variational formulation, four exact integrals and two approximate relations are obtained. This leads to an approximate but explicit control law for the lift and bank control. The control law is tested numerically for a whole range of entry speeds, from parabolic entry to near-circular entry with several values of maximum lift-to-drag ratio. The extensive numerical results, which are very accurate as compared to the exact optimal values, show that the maximum plane change for any speed ratio V(entry)/V(final) is simply proportional to the maximum lift-to-drag ratio, and depends solely on this parameter.

Johannesen, J. R.↗
NASA NTRS1985

Atmospheric guidance law for planar skip trajectories

The applicability of an approximate, closed-form, analytical solution to the equations of motion, as a basis for a deterministic guidance law for controlling the in-plane motion during a skip trajectory, is investigated. The derivation of the solution by the method of matched asymptotic expansions is discussed. Specific issues that arise in the application of the solution to skip trajectories are addressed. Based on the solution, an explicit formula for the approximate energy loss due to an atmospheric pass is derived. A guidance strategy is proposed that illustrates the use of the approximate solution. A numerical example shows encouraging performance.

Mease, K. D.↗
NASA NTRS1984

An approach to autonomous, onboard orbit determination

An orbit determination subsystem that will operate as an integral part of an autonomous, onboard navigation system is presented and analyzed. The navigation system is required to interface solely with the downlink telemetry stream and uplink command stream of an existing class of geostationary satellites. In particular, the orbit will be determined from a set of onboard sensors, which previously were used only for attitude determination. The design of the orbit determination subsystem is described in detail. The rationale behind the choice of each component of the design is given. Finally, the performance of the orbit determination subsystem, under a variety of assumptions, is determined by a combination of numerical simulation and analytical methods.

Mease, K. D.↗
NASA NTRS1984

Autonomous navigation - The ARMMS concept

A conceptual design is outlined for the navigation subsystem of the Autonomous Redundancy and Maintenance Management Subsystem (ARMMS). The principal function of this navigation subsystem is to maintain the spacecraft over a specified equatorial longitude to within + or - 3 deg. In addition, the navigation subsystem must detect and correct internal faults. It comprises elements for a navigation executive and for orbit determination, trajectory, maneuver planning, and maneuver command. Each of these elements is described. The navigation subsystem is to be used in the DSCS III spacecraft.

Wood, L. J.↗
NASA NTRS1984

Explicit guidance of drag modulated aeroassisted transfer between elliptical orbits

This paper presents the complete analysis of the problem of minimum-fuel aeroassisted transfer between coplanar elliptical orbits in the case where the orientation of the final orbit is free for selection in the optimization process. The comparison between the optimal pure propulsive transfer and the idealized aeroassisted transfer, by several passages through the atmosphere, is made. In the case where aeroassisted transfer provides fuel saving, a practical scheme for its realization by one passage is proposed. The maneuver consists of three phases: a deorbit phase for nonzero entry angle, followed by an atmospheric fly-through with variable drag control and completed by a postatmospheric phase. An explicit guidance formula for drag control is derived and it is shown that the required exit speed for ascent to the final orbit can be obtained with a very high degree of accuracy.

Vinh, N. X.↗
NASA NTRS1983

Minimum-fuel aeroassisted coplanar orbit transfer using lift-modulation

Minimum-fuel trajectories and lift controls are computed for aeroassisted coplanar transfer from high orbit to low orbit. The optimal aeroassisted transfer requires less fuel than the all-propulsive Hohmann transfer for a wide range of high orbit to low orbit transfers. The optimal control program for the atmospheric portion of the transfer is to fly at maximum positive L/D initially to recover from the downward plunge, and then, to fly at negative L/D to level off the flight, such that the vehicle skips out of the atmosphere with a flight path angle near zero degrees. To avoid excessive heating rates, the vehicle flies initially at high angle of attack in order to slow down higher in the atmosphere, allowing recovery from the downward plunge, which occurs subsequently using the maximum positive L/D, to take place at a lower atmospheric density, or equivalently, at a higher altitude.

Mease, K. D.↗
NASA NTRS1982

Aerocapture - Guidance, navigation, and control

Aerocapture is a concept for inserting a spacecraft into orbit about a target planet. The energy required for orbit insertion is obtained from natural resources present at or near the target body, thereby reducing the amount of propellant which must be carried onboard. Specifically, the transfer from a hyperbolic flyby trajectory to a desired bound orbit is effected by aerodynamic lift and drag forces acting on the spacecraft during controlled flight through the atmosphere of either the target planet or a nearby satellite. A survey is provided of the trajectory guidance, navigation, and control aspects of aerocapture, and a summary is given of the results of a number of preliminary studies concerning certain of these aspects. The investigation has additional significance in connection with the current interest in aeroassisted orbital transfer vehicles, which may be used in conjunction with the Space Shuttle.

Mease, K. D.↗
NASA NTRS1982

Tests of general relativity using Starprobe radio metric tracking data

The potential of a proposed spacecraft mission, called Starprobe, for testing general relativity and providing information on the interior structure and dynamics of the sun is investigated. Parametric, gravitational perturbation terms are derived which represent relativistic effects and effects due to spatial and temporal variations in the solar potential at a given radial distance. A covariance analysis based on Kalman filtering theory predicts the accuracies with which the free parameters in the perturbation terms can be estimated with radio metric tracking data through the process of trajectory reconstruction. It is concluded that Starprobe can contribute significant information on both the nature of gravitation and the structure and dynamics of the solar interior.

Mease, K. D.↗