Engineering topics

Medina-Rodriguez, Bryan X.

Publications and source records attributed to Medina-Rodriguez, Bryan X..

5 records

DOE OSTI2022

Dynamic stability of a crude oil/brine interface: Effect of anion type

The chemical composition of the aqueous phase plays an essential role in water-based enhanced-oil recovery processes. The aqueous phase ionic profile affects the snap-off response of a crude oil-brine system by linking it to the brine-crude oil interfacial rheology. In this work, we focus on the effect of the anion on the snap-off response. To this end, a sample of crude oil from the Minnelusa Sandstone formation in Wyoming was selected, and several aqueous solutions were prepared with salts containing sodium cation and different anions (chlorides, sulfates, and phosphates) at two ionic strength values, 0.6 M and 6 mM, as cases of high- and low-salinity water. Interfacial tension, interfacial viscoelasticity and interface stability were analyzed as functions of aging time using pendant drop, dilatational rheology, and liquid bridge techniques, respectively. Here the results show that solutions with higher ionic strength led to the formation of more rigid interfaces, i.e. higher elastic modulus, and faster formation kinetics. In the low-salinity regime, solutions with polyvalent anions produce more viscoelastic interfaces at faster rates than solutions with monovalent anions. Finally, an excellent correlation (R 2 greater than 0.97) between the relative stability of the interfacial film, predicted in liquid bridge tests, and the ratio of interfacial tension and interfacial elastic modulus was found.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2022

Multimodal study of the impact of stimulation pH on shale pore structure, with an emphasis on organics behavior in alkaline environments

The tight nature of shale formations calls for hydraulic fracturing techniques able of altering the pore architecture to facilitate the production of hydrocarbon resources. The composition, pH, salinity, density and chemistry of Hydraulic Fracturing Fluids (HFF) vary substantially depending on reservoir characteristics. pH is among the most important stimulation fluid properties, ranging from very acidic, for carbonate reservoirs, to basic, in the case of clay-rich formations. pH regulates what geochemical reactions take place between the stimulation fluid and shale, as well as pore architecture alteration. The dissolution of carbonates and pyrite, and the precipitation of common minerals such as barite, gypsum and iron oxides in acidic environments have been extensively documented. In contrast, alkali stimulation environments and the role of organic components have received less attention. This research provides insight into the role of both minerals and organic components during alkaline stimulation, and the resulting pore architecture alterations. Here, a set of reactive experiments are performed using three different shales, with varying organic matter (OM) content, at different pH (3, 6, 8, 10, 12). The analysis of pore architecture alteration induced by the reaction was performed via nitrogen (N2) gas adsorption and Time-Domain Nuclear Magnetic Resonance (TD-NMR). Inductively Coupled Plasma - Optical Emission Spectrometry (ICP-OES) was used to measure the composition of the stimulation fluid post-reaction. The system with a larger impact on the pore architecture (pH 12) underwent a more extensive analysis through the application of Focused Ion Beam Scanning Electron Microscopy (FIB-SEM) and x-ray Diffraction (XRD). Results show that mineral dissolution contributed to the creation of secondary porosity, mainly through dissolution of clays and silicates. We show that the abundance and distribution of organic matter both play a significant role in changes in pore architecture. Most samples showed an increase in inter-organic porosity, likely due to the organic acids within kerogen reacting with the stimulation fluid. Samples with a larger amount and more widespread distribution of organic matter show the most significant alterations. Finally, we also highlight the dissolution process of iron-rich minerals, including framboidal pyrite, as another important source of secondary porosity.

04 OIL SHALES AND TAR SANDS↗

DOE OSTI2021

Unveiling stimulation fluid-driven alterations in shale pore architecture through combined interpretation of TD-NMR and multi-component gas adsorption

The hydraulic fracturing stimulation process can alter petrophysical and flow properties of the shale matrix in unconventional reservoirs. These alterations can result from interactions with native and exogenous fluids, and can be detrimental to reservoir productivity. Different experimental procedures have been proposed to study reactive processes and thereby understand the aforementioned interactions. Most published works do not consider the rock initial saturation with formation fluid, or the effect of organic matter (OM). To gain insights into these effects, two reactive experimental sets, differing in experimental conditions, were conducted. In the first set, at 125°C and 45 MPa, a stimulation fluid surrogate was put in contact with Baxter Shale samples, previously saturated and equilibrated with synthetic formation fluid. A baseline consisted of exposure to formation fluid exclusively. In the second set, at 0.08 MPa and 25°C, contact with stimulation fluid took place as in the first set. Two additional assays in this second set either skipped the initial formation fluid saturation or removed the OM, respectively. Petrophysical properties analyses, focused on the pore architecture, relied on the combined interpretation of gas adsorption and Time-Domain Nuclear Magnetic Resonance (TD-NMR). Results show that the presence of the formation fluid significantly restricts pore space accessibility to the stimulation fluid and mitigates the pore-architecture alteration to the macro-pore region. Mineral dissolution and precipitation dominate over surface or wettability alteration. Next, results suggest that the OM restricts accessibility to some pores. Ultimately, the equilibration process with synthetic formation fluid drives mainly surface alteration, unhindered by OM.

58 GEOSCIENCES↗

DOE OSTI2021

Use of Gas Adsorption and Inversion Methods for Shale Pore Structure Characterization

The analysis of porosity and pore structure of shale rocks has received special attention in the last decades as unconventional reservoir hydrocarbons have become a larger parcel of the oil and gas market. A variety of techniques are available to provide a satisfactory description of these porous media. Some techniques are based on saturating the porous rock with a fluid to probe the pore structure. In this sense, gases have played an important role in porosity and pore structure characterization, particularly for the analysis of pore size and shapes and storage or intake capacity. In this review, we discuss the use of various gases, with emphasis on N2 and CO2, for characterization of shale pore architecture. We describe the state of the art on the related inversion methods for processing the corresponding isotherms and the procedure to obtain surface area and pore-size distribution. The state of the art is based on the collation of publications in the last 10 years. Limitations of the gas adsorption technique and the associated inversion methods as well as the most suitable scenario for its application are presented in this review. Finally, we discuss the future of gas adsorption for shale characterization, which we believe will rely on hybridization with other techniques to overcome some of the limitations.

04 OIL SHALES AND TAR SANDS↗

DOE OSTI2020

Time-Domain Nuclear Magnetic Resonance Determination of Wettability Alteration: Analysis for Low-Salinity Water

Wettability has been shown to influence oil recovery. This property has become central to low-salinity (LSW) and smart (SWF) water flooding recovery mechanisms research. The challenge lies in the fact that oil recovery results from the combined effects of solid-liquid and liquid-liquid interactions. This demands methods that allow an independent interpretation of wettability alteration contributions. The primary objective of this work is to assess changes in wettability through the application of Time-Domain Nuclear Magnetic Resonance (TD-NMR) T 2 distribution and diffusion coefficient, starting with a well-controlled porous system, that is, glass beads, and then a model rock (Berea), in the presence of one phase, either oil or brine exclusively. Subsequently, two-phase fluid saturation was tested. For the glass beads, dimethyldichlorosilane was used to induce a hydrophobic response, as confirmed by contact angle experiments on slides of the same material. Sodium sulfate was used for its known positive influence on oil recovery during LSW and SWF. In cases where alteration of surface properties was expected, a leftward shift of the average T 2 distribution curve modes, accompanied by a reduction on the diffusion coefficient during the aging process was observed. The results of this work confirm that fluid-solid interactions during LSW and SWF, namely a shift in wettability, take place after the injection of low-salinity water.

42 ENGINEERING↗