Engineering topics
Meehan, Thomas K.
Publications and source records attributed to Meehan, Thomas K..
New Science Opportunities on COSMIC-2/FORMOSAT-7
COSMIC-2 Polar (second launch) is an excellent opportunity to extend SSAEM capabilities to global coverage. Enhanced ionospheric remote sensing via oceanic TEC and DORIS. Science: lower-upper atmosphere coupling. Additional payloads are being considered by NSPO/Taiwan.
Next Generation Scalable Spaceborne GNSS Science Receiver
This paper will describe the TriG architecture, and how the new features will benefit the next-generation of global network instruments, as well as current test results.
TriG: Next Generation Scalable Spaceborne GNSS Receiver
TriG is the next generation NASA scalable space GNSS Science Receiver. It will track all GNSS and additional signals (i.e. GPS, GLONASS, Galileo, Compass and Doris). Scalable 3U architecture and fully software and firmware recofigurable, enabling optimization to meet specific mission requirements. TriG GNSS EM is currently undergoing testing and is expected to complete full performance testing later this year.
Kalman Orbit Optimized Loop Tracking
Under certain conditions of low signal power and/or high noise, there is insufficient signal to noise ratio (SNR) to close tracking loops with individual signals on orbiting Global Navigation Satellite System (GNSS) receivers. In addition, the processing power available from flight computers is not great enough to implement a conventional ultra-tight coupling tracking loop. This work provides a method to track GNSS signals at very low SNR without the penalty of requiring very high processor throughput to calculate the loop parameters. The Kalman Orbit-Optimized Loop (KOOL) tracking approach constitutes a filter with a dynamic model and using the aggregate of information from all tracked GNSS signals to close the tracking loop for each signal. For applications where there is not a good dynamic model, such as very low orbits where atmospheric drag models may not be adequate to achieve the required accuracy, aiding from an IMU (inertial measurement unit) or other sensor will be added. The KOOL approach is based on research JPL has done to allow signal recovery from weak and scintillating signals observed during the use of GPS signals for limb sounding of the Earth s atmosphere. That approach uses the onboard PVT (position, velocity, time) solution to generate predictions for the range, range rate, and acceleration of the low-SNR signal. The low- SNR signal data are captured by a directed open loop. KOOL builds on the previous open loop tracking by including feedback and observable generation from the weak-signal channels so that the MSR receiver will continue to track and provide PVT, range, and Doppler data, even when all channels have low SNR.
Towards new scientific observations from GPS occultations: advances in retrieval methods
We will present recent innovations in extracting scientifically useful information from the phase and amplitude of received GPS transmissions, and discuss the technical challenges that need to be overcome to achieve new scientific results.
The NASA/JPL BlackJack GPS receiver on CONAE's SAC-C mission
Explore the source record for details and available documents.
P-code enhanced method for processing encrypted GPS signals without knowledge of the encryption code
In the preferred embodiment, an encrypted GPS signal is down-converted from RF to baseband to generate two quadrature components for each RF signal (L1 and L2). Separately and independently for each RF signal and each quadrature component, the four down-converted signals are counter-rotated with a respective model phase, correlated with a respective model P code, and then successively summed and dumped over presum intervals substantially coincident with chips of the respective encryption code. Without knowledge of the encryption-code signs, the effect of encryption-code sign flips is then substantially reduced by selected combinations of the resulting presums between associated quadrature components for each RF signal, separately and independently for the L1 and L2 signals. The resulting combined presums are then summed and dumped over longer intervals and further processed to extract amplitude, phase and delay for each RF signal. Precision of the resulting phase and delay values is approximately four times better than that obtained from straight cross-correlation of L1 and L2. This improved method provides the following options: separate and independent tracking of the L1-Y and L2-Y channels; separate and independent measurement of amplitude, phase and delay L1-Y channel; and removal of the half-cycle ambiguity in L1-Y and L2-Y carrier phase.
Processing In A GPS Receiver To Reduce Multipath Errors
Four techniques of ancillary real-time digital processing of signals in Global Positioning System, GPS, receiver introduced reducing effects of multipath propagation of signals on position estimates produced by receiver. Multipath range errors halved. Applied in addition to other signal-processing techniques and to other techniques designing as receiving antenna to make it insensitive to reflections of GPS signals from nearby objects.
Multipath noise reduction spread spectrum signals
The concepts of early-prompt delay tracking, multipath correction of early-prompt delay tracking from correlation shape, and carrier phase multipath correction are addressed. In early-prompt delay tracking, since multipath is always delayed with respect to the direct signals, the system derives phase and pseudorange observables from earlier correlation lags. In multipath correction of early-prompt delay tracking from correlation shape, the system looks for relative variations of amplitude across the code correlation function that do not match the predicted multipath-free code cross-correlation shape. The system then uses deviations from the multipath-free shape to infer the magnitude of multipath, and to generate corrections pseudorange observables. In carrier phase multipath correction, the system looks for variations of phase among plural early and prompt lags. The system uses the measured phase variations, along with the general principle that the multipath errors are larger for later lags, to infer the presence of multipath, and to generate corrections for carrier-phase observables.
One Millimeter Horizontal Precision Over a 41 Km Baseline Using P-Codeless Data
High accuracy geodetic solutions at the few ppb level have become fairly standard with data from a global network of P-code Global Positioning System (GPS) receivers. Used as a measurement tool, it has numerous scientific applications including the monitoring of crustal motion, volcanic and post-seismic uplift, co- and post-seismic displacements in fault zones and media delay calibration and monitoring.
Counterrotator And Correlator For GPS Receivers
Accurate, all-digital, high-speed processor comprising correlator and down-converter developed for receivers in Global Positioning System (GPS). Processor reduces roundoff and commensurability errors to extremely small values. Use of digital chip and phase advancers provides outstanding control and accuracy in phase and feedback. Great flexibility imparted by provision for arbitrary starting time and integration length. Minimum-bit design requires minimum number of logical elements, thereby reducing size, power, and cost.
Chip Advancer For GPS Receiver
Instrument errors made negligible. For each integration interval, both delay and rate of change of delay initialized to small fraction of chip - for example, to order of 10 to the negative 7th power - thereby making feedback control and extraction of delay highly accurate and flexible. With appropriate selection of sampling rate relative to chip rate, commensurability errors reduced to extremely small levels. In Global Positioning System (GPS) receiver, pseudorandom code sequence generated by simple digital logic incorporating effects of time, delay, and rate of change of delay. Flexibility in starting time and sum interval very useful in aligning correlation interval with beginnings and endings of data bits.
Operational aspects of CASA UNO '88-The first large scale international GPS geodetic network
For three weeks, from January 18 to February 5, 1988, scientists and engineers from 13 countries and 30 international agencies and institutions cooperated in the most extensive GPS (Global Positioning System) field campaign, and the largest geodynamics experiment, in the world to date. This collaborative eperiment concentrated GPS receivers in Central and South America. The predicted rates of motions are on the order of 5-10 cm/yr. Global coverage of GPS observations spanned 220 deg of longitude and 125 deg of latitude using a total of 43 GPS receivers. The experiment was the first civilian effort at implementing an extended international GPS satellite tracking network. Covariance analyses incorporating the extended tracking network predicted significant improvement in precise orbit determination, allowing accurate long-baseline geodesy in the science areas.