Search NASA⌕ Search

Engineering topics

Meeker, Don

Publications and source records attributed to Meeker, Don.

Low-adiabat rugby hohlraum experiments on the National Ignition Facility: Comparison with high-flux modeling and the potential for gas-wall interpenetration

Rugby-shaped gold hohlraums driven by a nominal low-adiabat laser pulse shape have been tested on the National Ignition Facility. The rugby affords a higher coupling efficiency than a comparably sized cylinder hohlraum or, alternatively, improved drive symmetry and laser beam clearances for a larger hohlraum with similar cylinder wall area and laser energy. A first (large rugby hohlraum) shot at low energy (0.75 MJ) to test laser backscatter resulted in a moderately oblate CH capsule implosion, followed by a high energy shot (1.3 MJ) that gave a highly oblate compressed core according to both time-integrated and –resolved x-ray images. These implosions used low wavelength separation (1.0 Å) between the outer and inner cones to provide an alternative platform free of significant cross-beam energy transfer for simplified hohlraum dynamics. Post-shot 2- and 3-D radiation-hydrodynamic simulations using the high-flux model [M. D. Rosen et al., High Energy Density Phys. 7, 180 (2011)], however, give nearly round implosions for both shots, in striking contrast with observations. An analytic assessment of Rayleigh-Taylor hydrodynamic instability growth on the gold–helium gas-fill interface shows the potential for significant linear growth, saturation and transition to a highly nonlinear state. Candidate seeds for instability growth include laser speckle during the early-time laser picket episode in the presence of only partial temporal beam smoothing (1-D smoothing by spectral dispersion and polarization smoothing) and intensity modulations from quad-to-quad and beam overlap. Radiation-hydrodynamic 2-D simulations adapted to include a dynamic fall-line mix model across the unstable Au-He interface show good agreement with the observed implosion symmetry for both shots using an interface-to-fall-line penetration fraction of 100%. Physically, the potential development of an instability layer in a rugby hohlraum is tantamount to an enhanced wall motion leading to hindered inner-beam propagation, due largely to the confluence of rugby shape and low ray angles relative to the hohlraum symmetry axis. A significant inward pointing shift of 500 μm in the outer cones for the third (full energy) shot of the series was used to improve the inner-beam propagation, resulting in a nearly symmetric x-ray self-emission image of the compressed core and reduced sensitivity to mix. Comparatively low time-dependent symmetry swings were also measured, and a significantly lower hot electron fraction was measured for potentially favorable fuel adiabat control. The outer cone stimulated Brillouin scatter levels jumped significantly, but remedial measures such as the use of a boron dopant in the Au wall are planned. A continuing trend of delayed implosion times is found in rugby hohlraums, suggesting levels of unaccounted hohlraum energy (∼150–200 kJ) similar to what is inferred in cylinder hohlraums. A mix-based physical scenario is described, based on suppressed channel heat flux to the dense gold wall from a temperature-gradient reversal induced by a multispecies plasma lapse rate [P. Amendt, C. Bellei, and S. C. Wilks, Phys. Rev. Lett. 109, 075002 (2012)].

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Fast Ignition Target Compression Campaign

We propose an experimental campaign on the NIF to validate key elements of the fast ignition target design. Experimental measurements will provide feedback for refinement of the target design. In lieu of the cryogenic DT target, which requires ongoing target fabrication R&D, the initial experiments will use a surrogate target design consisting of a cryogenic H/He gas-filled hohlraum with CH capsule. In the first year we will validate hohlraum energetics, symmetry tuning, and measure peak ρR with spherical capsule implosions, for each of our two candidate pulse shapes, with the aim of down selecting to a preferred drive pulse. In the second year we will progress to cone-in-shell implosions, using x-ray radiography and Streaked Optical Pyrometry (SOP) inside the cone to measure and optimize the ρR and shape of the compressed core and the timing between optimum fuel compression and shock breakout in the cone. Our goal is to establish an indirect drive fast ignition compression platform that will demonstrate the validity of the implosion scheme, and provide a basis for future core heating experiments using the 10 kJ, 10 ps Advanced Radiographic Capability (ARC) short-pulse NIF beam line.

42 ENGINEERING↗