Engineering topics

Mehta, R. D.

Publications and source records attributed to Mehta, R. D..

25 records · Page 2

NASA NTRS1985

Aerodynamics of sports balls

Research data on the aerodynamic behavior of baseballs and cricket and golf balls are summarized. Cricket balls and baseballs are roughly the same size and mass but have different stitch patterns. Both are thrown to follow paths that avoid a batter's swing, paths that can curve if aerodynamic forces on the balls' surfaces are asymmetric. Smoke tracer wind tunnel tests and pressure taps have revealed that the unbalanced side forces are induced by tripping the boundary layer on the seam side and producing turbulence. More particularly, the greater pressures are perpendicular to the seam plane and only appear when the balls travel at velocities high enough so that the roughness length matches the seam heigh. The side forces, once tripped, will increase with spin velocity up to a cut-off point. The enhanced lift coefficient is produced by the Magnus effect. The more complex stitching on a baseball permits greater variations in the flight path curve and, in the case of a knuckleball, the unsteady flow effects. For golf balls, the dimples trip the boundary layer and the high spin rate produces a lift coefficient maximum of 0.5, compared to a baseball's maximum of 0.3. Thus, a golf ball travels far enough for gravitational forces to become important.

Mehta, R. D.↗

NASA NTRS1985

Aspects of the design and performance of a 3-component LDV system

A conventional two color, two component Laser Doppler Velocimeter (LDV) has been converted into one capable of measuring all three components of velocity simultaneously in low-speed flows. All the Reynolds stresses and higher-order products can then be evaluated. The approach followed is to split one of the two colors and to focus a third pair of beams from an off axis direction. The third velocity component is computed from the known geometry of the system. This paper contains details of the system design with emphasis on the additional problems that are encountered through the introduction of the third component. Some preliminary measurements obtained in a vortex/mixing layer interaction are presented and compared directly with those obtained with a cross-wire system.

Bell, J. H.↗

NASA NTRS1984

Flow visualization study of a vortex-wing interaction

A flow visualization study in water was completed on the interaction of a streamwise vortex with a laminar boundary layer on a two-dimensional wing. The vortex was generated at the tip of a finite wing at incidence, mounted perpendicular to the main wing, and having the same chord as the main wing. The Reynolds number based on wing chord was about 5000. Two different visualization techniques were used. One involved the injection of two different colored dyes into the vortex and the boundary layer. The other technique utilized hydrogen bubbles as an indicator. The position of the vortex was varied in a directional normal to the wing. The angle of attack of the main wing was varied from -5 to +12.5 deg. The vortex induced noticeable cross flows in the wing boundary layer from a distance equivalent to 0.75 chords. When very close to the wing, the vortex entrained boundary layer fluid and caused a cross flow separation which resulted in a secondary vortex.

Mehta, R. D.↗

NASA NTRS1984

An experimental study of a vortex/mixing-layer interaction

The first phase of a subsonic experimental investigation of the structure of a longitudinal vortex and the effect of the vortex on a two-stream turbulent mixing layer has been completed. A stable and well-defined longitudinal vortex was generated by mounting a half-delta-wing vortex generator in the wind-tunnel settling chamber. A detailed flow-visualization study, using the smoke-laser technique, was conducted, and X-wire probes were used to measure the mean-flow and turbulence quantities. At the upstream locations, the vortex was found to develop some normal stresses within the core region. The vortex also induced strong secondary motions and small increases in the normal stresses within the mixing layer. The normal stresses then combined with the appropriate mean-velocity gradients to generate shear stresses farther downstream. The results indicate that more sophisticated turbulence models will have to be developed if such complex interactions are to be computed accurately.

Mehta, R. D.↗

NASA NTRS1984

Crossed hot-wire data acquisition and reduction system

The report describes a system for rapid computerized calibration acquisition, and processing of data from a crossed hot-wire anemometer is described. Advantages of the system are its speed, minimal use of analog electronics, and improved accuracy of the resulting data. Two components of mean velocity and turbulence statistics up to third order are provided by the data reduction. Details of the hardware, calibration procedures, response equations, software, and sample results from measurements in a turbulent plane mixing layer are presented.

Westphal, R. V.↗

NASA NTRS1984

Near-field turbulence properties of single- and two-stream plane mixing layers

Detailed mean-flow and turbulence measurements have been made in the near-field of two plane mixing layers in air with a maximum velocity of 21 m/s. The experimental rig enabled mixing layers of velocity ratios 0 and 0.46 to be generated simultaneously. Cases with both tripped and untripped initial boundary layers were studied. In all cases, it was found that the two-stream layer developed to the self-preserving state in a distance much shorter than the single-stream layer which followed accepted criteria for the development distance. The asymptotic levels of the turbulence quantities in the two-stream layer, and the development of the single-stream layer showed agreement with existing data. The results suggest that the two-stream mixing layer should provide a better test case for the development of turbulence models and calculation methods than the single-stream mixing layer.

Mehta, R. D.↗

NASA NTRS1984

Turbulent flow through screens

A detailed experimental investigation has been carried out on the effects of different types of screens on turbulent flow, in particular turbulent boundary layers. The effect of a screen on a turbulent boundary layer is to give it a 'new lease of life'. The boundary layer turbulence is reorganized and the thickness reduced, thus making it less susceptible to separation. The aerodynamic properties of plastic screens are found to differ significantly from those of the conventional metal screens, evidently because of differences in the weaving properties. The 'overshoot' in mean velocity profile near the boudnary layer edge is shown to be a result of the effect of screen inclination on pressure drop coefficient. A more accurate formulation for the deflection coefficient of a screen is also proposed.

Mehta, R. D.↗