Search NASA⌕ Search

Engineering topics

Melnik, W. L.

Publications and source records attributed to Melnik, W. L..

4 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Wall region of a relaxing three-dimensional incompressible turbulent boundary layer

A three-dimensional turbulent boundary layer relaxing behind a transverse hump (shaped as a 30-deg swept 5-ft chord wing-type model) was studied in a low-speed wind tunnel. Data obtained with hot-wire probes showed that the apparent dimensionless velocity profiles in the viscous sublayer prevail universally; evidence for wall similarity in the relaxing flow field was confirmed in the form of a log law. An unusual region of slightly decreasing cross-flow angle was found in collateral regions, and a near-wall noncollateral flow was posited. Streamwise relaxation of the mean flow field was also investigated.

Hebbar, K. S.↗
NASA NTRS1976

An experimental investigation of a two and a three-dimensional low speed turbulent boundary layer

Experimental studies of a two and a three-dimensional low speed turbulent boundary layer were conducted on the side wall of a boundary layer wind tunnel. The 20 ft. long test section, with a rectangular cross section measuring 17.5 in. x 46 in., produced a 3.5 in. thick turbulent boundary layer at a free stream Reynolds number. The three-dimensional turbulent boundary layer was produced by a 30 deg swept wing-like model faired into the side wall of the test section. Preliminary studies in the two-dimensional boundary layer indicated that the flow was nonuniform on the 46 in. wide test wall. The nonuniform boundary layer is characterized by transverse variations in the wall shear stress and is primarily caused by nonuniformities in the inlet damping screens.

Winkelmann, A. E.↗
NASA NTRS1976

Measurements in the near-wall region of a relaxing three-dimensional low speed turbulent air boundary layer

An experimental investigation was conducted at selected locations of the near-wall region of a three dimensional turbulent air boundary layer relaxing in a nominally zero external pressure gradient behind a transverse hump (in the form of a 30 deg swept, 5-foot chord wing-type model) faired into the side wall of a low speed wind tunnel. Wall shear stresses measured with a flush-mounted hot-film gage and a sublayer fence were in very good agreement with experimental data obtained with two Preston probes. With the upstream unit Reynolds number held constant at 325,000/ft. approximately one-fourth of the boundary layer thickness adjacent to the wall was surveyed with a single rotated hot-wire probe mounted on a specially designed minimum interference traverse mechanism. The boundary layer (approximately 3.5 in thick near the first survey station where the length Reynolds number was 5.5 million) had a maximum crossflow velocity ratio of 0.145 and a maximum crossflow angle of 21.875 deg close to the wall.

Hebbar, K. S.↗