Engineering topics

Mercer, Charles E.

Publications and source records attributed to Mercer, Charles E..

5 records

NASA NTRS1992

Data reduction formulas for the 16-foot transonic tunnel: NASA Langley Research Center, revision 2

The equations used by the 16-Foot Transonic Wind Tunnel in the data reduction programs are presented in nine modules. Each module consists of equations necessary to achieve a specific purpose. These modules are categorized in the following groups: (1) tunnel parameters; (2) jet exhaust measurements; (3) skin friction drag; (4) balance loads and model attitudes calculations; (5) internal drag (or exit-flow distribution); (6) pressure coefficients and integrated forces; (7) thrust removal options; (8) turboprop options; and (9) inlet distortion.

Mercer, Charles E.↗

NASA NTRS1987

Computations for the 16-foot transonic tunnel, NASA, Langley Research Center, revision 1

The equations used by the 16 foot transonic tunnel in the data reduction programs are presented in eight modules. Each module consists of equations necessary to achieve a specific purpose. These modules are categorized in the following groups: tunnel parameters; jet exhaust measurements; skin friction drag; balance loads and model attitudes calculations; internal drag (or exit-flow distributions); pressure coefficients and integrated forces; thrust removal options; and turboprop options. This document is a companion document to NASA TM-83186, A User's Guide to the Langley 16 Foot Transonic Tunnel, August 1981.

Mercer, Charles E.↗

NASA NTRS1960

Static Thrust of an Annular Nozzle with a Concave Central Base

A static test of an annular nozzle with a concave central base, producing a jet in which tangents to the jet streamlines at the exit converged toward a region on the axis of symmetry downstream of the exit, has indicated good thrust performance. A value of nozzle-flow coefficient only slightly less than unity indicates the internal loss to be small. Pressures on the concave central base are relatively large and positive, and a predictable portion of the total thrust of the jet is exerted on the central base.

Corson, Blake W., Jr.↗

NASA NTRS1960

Effect of Afterbody Terminal Fairings on the Performance of a Pylon-Mounted Turbojet-Nacelle Model

An investigation of the effect of afterbody terminal fairings on the performance of a pylon-mounted turbojet-nacelle model has been conducted in the Langley 16-foot transonic tunnel. A basic afterbody having a boattail angle of 16 deg was investigated with and without terminal fairings. The equivalent boattail angle, based on the cross-sectional area of the afterbody and terminal fairings, was 8 deg. Therefore, a simple body of revolution with a boattail angle of 8 deg was included for comparison. The tests were made at an angle of attack of 0 deg, Mach numbers of 0.80 to 1.05, jet total-pressure ratio of 1 to approximately 5, and an average Reynolds number per foot of 4.1 x 10(exp 6). A hydrogen peroxide jet simulator was used to supply the hot-jet exhaust. The results indicate that addition of terminal fairings to a 16 deg boattail afterbody increased the thrust-minus-drag coefficients and provided the lowest effective drag of the three configurations tested.

Willis, Conrad M.↗

NASA NTRS1959

Effect of Afterbody-Ejector Configurations on the Performance at Transonic Speeds of a Pylon-Supported Nacelle Model having a Hot-Jet Exhaust

An investigation of several afterbody-ejector configurations on a pylon-supported nacelle model has been completed in the Langley 16-foot transonic tunnel at Mach numbers from 0.80 to 1.05. The propulsive performance of two nacelle afterbodies with low boattailing and long ejector spacing was compared with a configuration corresponding to a turbojet-engine installation having a highly boattailed afterbody with a short ejector. The jet exhaust was simulated with a hydrogen peroxide turbojet simulator. The angle of attack was maintained at 0 deg, and the average Reynolds number based on body length was 20 x 10(exp 6). The results of the investigation indicated that the configuration with a conical afterbody with smooth transition to a 15 deg boattail angle had large beneficial jet effects on afterbody pressure-drag coefficient and had the best thrust-minus-drag performance of the afterbody-ejector configurations investigated.

Swihart, John M.↗