Search NASA⌕ Search

Engineering topics

Merrill, G. L.

Publications and source records attributed to Merrill, G. L..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2003

Efficient, Low-Cost Fan System Research for General Aviation and Commuter Aircraft

This document reports research investigations into efficient, low-cost fan system concepts for high bypass turbofans for future general aviation and commuter aircraft. The research specifically addressed lower pressure ratio fans for good propulsive efficiencies in the 200 to 400 knot flight speed regime. Aerodynamic design analyses yielded predicted efficiency in area of 91 to 92 percent (adiabatic). Low-cost manufacturing studies yielded an aluminum blisk rotor and investment cast stator having lowest cost. Structural design analyses yielded a design having excellent vibratory characteristics and the ability to pass One- and Four-pound bird strikes satisfactorily. The low speed and low pressure fans of the study are estimated to have 24 to 30 EPNdB lower community noise levels than larger, high pressure ratio transonic fans.

Merrill, G. L.↗
NASA NTRS1976

Study of small turbofan engines applicable to single-engine light airplanes

The design, efficiency and cost factors are investigated for application of turbofan propulsion engines to single engine, general aviation light airplanes. A companion study of a hypothetical engine family of a thrust range suitable to such aircraft and having a high degree of commonality of design features and parts is presented. Future turbofan powered light airplanes can have a lower fuel consumption, lower weight, reduced airframe maintenance requirements and improved engine overhaul periods as compared to current piston engined powered airplanes. Achievement of compliance with noise and chemical emission regulations is expected without impairing performance, operating cost or safety.

Merrill, G. L.↗
NASA NTRS1975

Study of small civil turbofan engines applicable to military trainer airplanes

Small turbofan engine design concepts were applied to military trainer airplanes to establish the potential for commonality between civil and military engines. Several trainer configurations were defined and studied. A ""best'' engine was defined for the trainer mission, and sensitivity analyses were performed to determine the effects on airplane size and efficiency of wing loading, power loading, configuration, aerodynamic quality, and engine quality. It is concluded that a small civil aircraft is applicable to military trainer airplanes. Aircraft designed with these engines are smaller, less costly, and more efficient than existing trainer aircraft.

Heldenbrand, R. W.↗
NASA NTRS1973

Study of small turbofan engines applicable to general-aviation aircraft

The applicability of small turbofan engines to general aviation aircraft is discussed. The engine and engine/airplane performance, weight, size, and cost interrelationships are examined. The effects of specific engine noise constraints are evaluated. The factors inhibiting the use of turbofan engines in general aviation aircraft are identified.

Merrill, G. L.↗
NASA NTRS1972

Feasibility study of a bidirectional jet flap device for application to helicopter rotor blades. Phase 2: Lift controller development

A bidirectional jet flap device called the variable deflection thruster (VDT) has been investigated for possible application to helicopter rotors. This investigation included the development and testing of a fluidic lift control system for the VDT-blade model making use of the test result that VDT-blade lift can be sensed from the differential pressure at midchord. This study constitutes a long-range program to develop blown control techniques for stabilizing the higher harmonic modes of helicopter rotors. Wind tunnel tests were conducted using a three-sectioned, two-dimensional VDT-blade model having individually controlled VDT jet flaps in each section. Steady-state tests were conducted without the fluidic lift controller (open loop) for both full-span blowing and for the model center section blowing only. Steady-state tests were conducted with the center section blowing only using the fluidic lift controller (close-loop) to control the lift on the model center section. Dynamic tests were conducted using the complete model with the VDT jet in the model center section oscillating at various frequencies and also using the model center section alone on a single endplate to obtain finite-aspect-ratio effects. Fair agreement was obtained between theory and experimental results.

Rose, R. E.↗