Search NASASearch

Engineering topics

Meyer, Paul J.

Publications and source records attributed to Meyer, Paul J..

At least 19 records

Forecasting and Monitoring Intense Thunderstorms in the Hindu Kush Himalayan Region: Spring 2018 Forecasting Experiment

Some of the most intense thunderstorms on the planet occur in the Hindu Kush Himalayan (HKH) region of South Asia - where many organizations lack the capacity needed to predict, observe and/or effectively respond to the threats associated with high-impact convective weather. Among the hazards include tornadoes, damaging straight-line winds (known as Nor'westers in the HKH region), large hail, and flash flooding, which typically peak in the pre-wet-monsoon season. Previous studies have documented a disproportionately large number of casualties associated with intense thunderstorms in this region; therefore, the goal of this project is to increase situational awareness of these hazards through short-term modeling and satellite assessment tools.

remote sensing

Urban Heat Wave Hazard Assessment

Heat waves are the largest cause of environment-related deaths globally. On average, over 6,000 people in the United States alone are hospitalized each summer due to excessive heat. Key elements leading to these disasters are elevated humidity and the urban heat island effect, which act together to increase apparent temperature and amplify the effects of a heat wave. Urban demographics and socioeconomic factors also play a role in determining individual risk. Currently, advisories of impending heat waves are often too generalized, with limited or no spatial variability over urban regions. This frequently contributes to a lack of specific response on behalf of the population. A goal of this project is to develop a product that has the potential to provide more specific heat wave guidance invoking greater awareness and action.

Urban

Phased Array Radiometer Calibration Using a Radiated Noise Source

Electronic beam steering capability of phased array antenna systems offer significant advantages when used in real aperture imaging radiometers. The sensitivity of such systems is limited by the ability to accurately calibrate variations in the antenna circuit characteristics. Passive antenna systems, which require mechanical rotation to scan the beam, have stable characteristics and the noise figure of the antenna can be characterized with knowledge of its physical temperature [1],[2]. Phased array antenna systems provide the ability to electronically steer the beam in any desired direction. Such antennas make use of active components (amplifiers, phase shifters) to provide electronic scanning capability while maintaining a low antenna noise figure. The gain fluctuations in the active components can be significant, resulting in substantial calibration difficulties [3]. In this paper, we introduce two novel calibration techniques that provide an end-to-end calibration of a real-aperture, phased array radiometer system. Empirical data will be shown to illustrate the performance of both methods.

Srinivasan, Karthik

Video Image Stabilization and Registration

A method of stabilizing and registering a video image in multiple video fields of a video sequence provides accurate determination of the image change in magnification, rotation and translation between video fields, so that the video fields may be accurately corrected for these changes in the image in the video sequence. In a described embodiment, a key area of a key video field is selected which contains an image which it is desired to stabilize in a video sequence. The key area is subdivided into nested pixel blocks and the translation of each of the pixel blocks from the key video field to a new video field is determined as a precursor to determining change in magnification, rotation and translation of the image from the key video field to the new video field.

Hathaway, David H.

Video Image Stabilization and Registration

A method of stabilizing and registering a video image in multiple video fields of a video sequence provides accurate determination of the image change in magnification, rotation and translation between video fields, so that the video fields may be accurately corrected for these changes in the image in the video sequence. In a described embodiment, a key area of a key video field is selected which contains an image which it is desired to stabilize in a video sequence. The key area is subdivided into nested pixel blocks and the translation of each of the pixel blocks from the key video field to a new video field is determined as a precursor to determining change in magnification, rotation and translation of the image from the key video field to the new video field.

Hathaway, David H.

Inter-Comparison of CHARM Data and WSR-88D Storm Integrated Rainfall

A localized precipitation network has been established over a 4000 sq km region of northern Alabama in support of local weather and climate research at the Global Hydrology and Climate Center (GHCC) in Huntsville. This Cooperative Huntsville-Area Rainfall Measurement (CHARM) network is comprised of over 80 volunteers who manually take daily rainfall measurements from 85 sites. The network also incorporates 20 automated gauges that report data at 1-5 minute intervals on a 24 h a day basis. The average spacing of the gauges in the network is about 6 kin, however coverage in some regions benefit from gauges every 1-2 km. The 24 h rainfall totals from the CHARM network have been used to validate Stage III rainfall estimates of daily and storm totals derived from the WSR-88D radars that cover northern Alabama. The Stage III rainfall product is produced by the Lower Mississippi River Forecast Center (LMRFC) in support of their daily forecast operations. The intercomparisons between the local rain gauge and the radar estimates have been useful to understand the accuracy and utility of the Stage III data. Recently, the Stage III and CHARM rainfall measurements have been combined to produce an hourly rainfall dataset at each CHARM observation site. The procedure matches each CHARM site with a time sequence of Stage III radar estimates of precipitation. Hourly stage III rainfall estimates were used to partition the rain gauge values to the time interval over which they occurred. The new hourly rain gauge dataset is validated at selected points where 1-5 minute rainfall measurements have been made. This procedure greatly enhances the utility of the CHARM data for local weather and hydrologic modeling studies. The conference paper will present highlights of the Stage III intercomparison and some examples of the combined radar / rain gauge product demonstrating its accuracy and utility in deriving an hourly rainfall product from the 24 h CHARM totals.

Jedlovec, Gary J.

Interactive Sectoring and Animation of Global Change Data

In order to analyze and share results of global change data sets, scientists require a venue in which to exchange their results. One appropriate medium for these collaborative efforts is the world wide web. Intuitive and efficient user interfaces, and background processes have been developed at the Global Hydrology and Climate Center to interactively view weather satellite, radar, global temperature anomaly, and model output data using the world wide web. These tools combine scripts, Java and C code which allows the user to easily interact with data, to create high resolution sector images, and sectored animation sequences. This paper examines the architecture and interfaces and how they are used for collaborative research.

Meyer, Paul J.

Interactive Sectoring and Animation of Global Change Data

In order to analyze and share results of global change climate data sets, scientists require a venue in which to exchange their results. The perfect medium for these collaborative efforts is the world wide web. Intuitive and efficient user interfaces, and background processes were developed at the Global Hydrology and Climate Center to interactively view weather satellite, radar, global temperature anomaly, and model output data using the world wide web. These tools combine scripts, Java, and C code, which allows the end user to easily interact with data, to create high resolution sector images, and sectored animation sequences. This paper examines the architecture and interfaces which were designed at the Global Hydrology and Climate Center and how they are used for collaborative research.

Meyer, Paul J.

Lightning trends as a precursor to microbursts

The feasibility of using lightning-rate data to aid in the early warning of microburst occurrence in moist environments is illustrated. Convective tendency images were generated for a small microburst-producing storm that developed in northern Alabama on July 20, 1986 during the Cooperative Huntsville Meteorological Experiment. Radar observations were obtained from the NCAR CP2 10-cm dual-polarization Doppler radar, while the measurements of total lightning activity were provided by the National Severe Storm Laboratory, a mobile laboratory that was located under the storm throughout its lifetime. The scenario for the evolution of wet microburst producing thunderstorms is described.

Buechler, Dennis E.

Storm diagnostic/predictive images derived from a combination of lightning and satellite imagery

A technique is presented for generating trend or convective tendency images using a combination of GOES satellite imagery and cloud-to-ground lightning observations. The convective tendency images can be used for short term forecasting of storm development. A conceptual model of cloud electrical development and an example of the methodology used to generate lightning/satellite convective tendency imagery are given. Successive convective tendency images can be looped or animated to show the previous growth or decay of thunderstorms and their associated lighting activity. It is suggested that the convective tendency image may also be used to indicate potential microburst producing storms.

Goodman, Steven J.