Search NASA⌕ Search

Engineering topics

Miao, P.

Publications and source records attributed to Miao, P..

First operation of a multi-channel Q-Pix prototype: measuring transverse electron diffusion in a gas time projection chamber

We report measurements of the transverse diffusion of electrons in P-10 gas (90% Ar, 10% CH 4 ) in a laboratory-scale time projection chamber (TPC) utilizing a novel pixelated signal capture and digitization technique known as Q-Pix. The Q-Pix method incorporates a precision switched integrating transimpedance amplifier whose output is compared to a threshold voltage. Upon reaching the threshold, a comparator sends a 'reset' signal, initiating a discharge of the integrating capacitor. The time difference between successive resets is inversely proportional to the average current at the pixel in that time interval, and the number of resets is directly proportional to the total collected charge. We developed a 16-channel Q-Pix prototype fabricated from commercial off-the-shelf components and coupled them to 16 concentric annular anode electrodes to measure the spatial extent of the electron swarm that reaches the anode after drifting through the uniform field of the TPC. The swarm is produced at a gold photocathode using pulsed UV light. The measured transverse diffusion agrees with simulations in PyBoltz across a range of operating pressures (200–1500 Torr). These results demonstrate that a Q-Pix readout can successfully reconstruct the ionization topology in a TPC.

47 OTHER INSTRUMENTATION↗

The New Small Wheel electronics

The increase in luminosity, and consequent higher backgrounds, of the LHC upgrades require improved rejection of fake tracks in the forward region of the ATLAS Muon Spectrometer. The New Small Wheel upgrade of the Muon Spectrometer aims to reduce the large background of fake triggers from track segments that don't originate from the interaction point. The New Small Wheel employs two detector technologies, the resistive strip Micromegas detectors and the “small” Thin Gap Chambers, with a total of 2.45 million electrodes to be sensed. The two technologies require the design of a complex electronics system given that it consists of two different detector technologies and is required to provide both precision readout and a fast trigger. It will operate in a high background radiation region up to about 20 kHz/cm 2 at the expected HL-LHC luminosity of $\mathcal{L}$= 7.5 × 10 34 cm -2 s -1 . The architecture of the system is strongly defined by the GBTx data aggregation ASIC, the newly-introduced FELIX data router and the software based data handler of the ATLAS detector. The electronics complex of this new detector was designed and developed in the last ten years and consists of multiple radiation tolerant Application Specific Integrated Circuits, multiple front-end boards, dense boards with FPGA's and purpose-built Trigger Processor boards within the ATCA standard. The New Small Wheel has been installed in 2021 and is undergoing integration within ATLAS for LHC Run 3. It should operate through the end of Run 4 (December 2032). In this manuscript, the overall design of the New Small Wheel electronics is presented.

47 OTHER INSTRUMENTATION↗

Successive magnetic orderings in the Ising spin chain magnet DyNi 5 Ge 3

In this report, we investigated a new rare-earth-based one-dimensional Ising spin chain magnet DyNi 5 Ge 3 by means of magnetization, specific heat, and powder neutron diffraction measurements. Due to the crystalline electrical field splitting, the magnetic Dy ions share an Ising-like ground doublet state. Owning to the local point symmetry, these Ising moments form into two canted magnetic sublattices, which were further confirmed by the angle-dependent magnetization measurement. In zero fields, two successive antiferromagnetic phase transitions were found at temperatures T N1 =6K and T N2 =5K, respectively. Only part of the moments are statically ordered in this intermediate state between T N1 and T N2 . Powder neutron diffraction experiments at different temperatures were performed as well. Further, an incommensurate magnetic propagation vector of k m =(0.5,0.4,0.5) was identified. The refined spin configurations through the irreducible representation analysis confirmed that these Ising spins are canted in the crystal ab plane.

36 MATERIALS SCIENCE↗

Crystal and magnetic structures of Cr{sub 1∕3}NbSe{sub 2} from neutron diffraction

Neutron diffraction measurements of the Cr intercalated niobium diselenide Cr{sub 1∕3}NbSe{sub 2} together with magnetization measurements have revealed that this compound exhibits ferromagnetic ordering below T{sub C} = 96 K unlike a chiral helimagnetic order observed in the sulfide compound Cr{sub 1∕3}NbS{sub 2}. As derived from neutron diffraction data, the Cr magnetic moments μ{sub Cr} = 2.83 ± 0.03 μ{sub B} in Cr{sub 1∕3}NbSe{sub 2} are aligned within basal plane. The discrepancy in the magnetic states of Cr{sub 1∕3}NbS{sub 2} and Cr{sub 1∕3}NbSe{sub 2} is ascribed to the difference in the preferential site occupation of Cr ions in crystal lattices. In Cr{sub 1∕3}NbSe{sub 2}, the Cr ions are predominantly distributed over 2b Wyckoff site, which determines a centrosymmetric character of the crystal structure unlike Cr{sub 1∕3}NbS{sub 2}, where the Cr ions are mainly located in 2c position and the crystal structure is non-centrosymmetric.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗