Engineering topics

Michael D. Cahn

Publications and source records attributed to Michael D. Cahn.

3 records

NASA NTRS2022

Evapotranspiration Based Irrigation Trials Examine Water Requirement, Nitrogen Use, and Yield of Romaine Lettuce in the Salinas Valley

Cool season vegetables require adequate soil moisture to assure that maximum yield and quality are achieved. On California’s central coast, where the majority of cool season vegetables are produced in the US, long-term overpumping of irrigation water has reduced groundwater levels and led to environmental degradation. Two evapotranspiration (ET) based irrigation field trials were performed near Salinas CA (USA) to determine if ET-based irrigation scheduling could conserve water while producing romaine lettuce (cv. Sun Valley) of commercially viable yield. Sprinklers were used for seed germination and crop establishment. Four drip irrigation treatments were then imposed using a randomized complete block design with six replications. The CropManage decision support model was used to estimate the full (100%) crop water requirement based mainly on ET replacement. Other treatments included 50% 75% and 150% of the full water requirement. The 100% treatment received 185 mm of water in 2015 and 247 mm in 2016, both of which were well below prior guidance and grower reports. Yields from the 100% and 150% treatments were not significantly different and were similar to industry average, while yields were significantly lower for the 50% and 75% treatments. The 100% treatment had the highest water use efficiency, and the 100% and 150% treatments together had the highest nitrogen recovery efficiency. Irrigation of romaine near the 100% ET replacement level can potentially reduce environmental impacts associated with nitrate leaching and surface runoff.

CropManage decision support system↗

NASA NTRSDate not supplied

Using Weather-Based Irrigation Scheduling to Optimize Red Cabbage Production

A replicated field trial was performed on a Chualar sandy loam in California’s Salinas Valley during 2020 to investigate the yield response of drip-irrigated red cabbage to applied water volume. The crop was transplanted on 29-April and established with approximately 4 inches of water uniformly applied by overhead sprinklers. At 22 days after transplanting (DAT), five drip-irrigation treatments were established at 50, 75, 100, 125, and 150% of estimated daily crop evapotranspiration (ETc). The treatments were replicated 6 times following a randomized complete block design. The 100% crop water requirement was specified by CropManage, an irrigation scheduling application that combines a crop coefficient approach with reference evapotranspiration data from the California Irrigation Management Information System. The crop was irrigated 3 times per week. Nitrogen fertilizer, totaling 320 lbs/ac, was applied through the drip system once per week. Commercial carton yields were evaluated 85 DAT. The 100% ETc treatment received a total of 18.3 inches of water including sprinkler establishment and had the highest yield at 57 tons/ac, while the 50% treatment (11.5 inches) yielded a low of 32 tons/ac. For reference, average applied water reported for this crop on the Central Coast is about 22.5 inches by way of a variety of irrigation methods including drip, sprinkler, and furrow. Aboveground biomass was evaluated 91 DAT. The 100% treatment had the highest fresh (105 tons/ac) and dry (7.7 tons/ac) biomass yield. Commercial bulk yields at 98 DAT and were maximized by 20-24 inches of water (100%, 125% treatments) and ranged from a high of 67 tons/ac for 125% ETc treatment (24.3 inches of water) to 35 tons/ac for the 50% treatment (12.6 inches). The results demonstrated that yield and quality targets for this crop can be met by drip irrigation, and CropManage is an effective decision support tool for evaluating crop water requirements based on weather data.

Weather-Based↗

NASA NTRSDate not supplied

Initial Evaluation of CropManage Decision-Support Model for Vineyard ET Estimation

The CropManage(CM) decision-support web application was originally developed by U.C. Cooperative Extension to support evapotranspiration (ET) based irrigation scheduling and nutrient management of cool-season vegetables. The model uses prescribed crop phenology curves to develop daily estimates of fractional green canopy cover (Fc) within the field. Periodic Fc observations acquired by ground-based methods or imported from NASA’s Satellite Irrigation Management Support (SIMS) can be used to adjust the prescribed timeseries for such factors as weather anomalies or non-standard agronomic practice, as needed. Fc is then converted to daily crop coefficient (fraction of reference ET) values. The crop coefficient is combined with reference evapotranspiration, collected by the California Irrigation Management Information System, to derive daily ET estimates for the given field. Irrigation runtime recommendations are issued for a given date based on total ET since the last irrigation event (less any rainfall), and corrected for distribution uniformity of the water delivery system. In this project, CM was adapted to vineyards by adding sub-models to account for early-season depletion of stored soil moisture, cover crop presence, and intentional water stress. An initial trial was performed on a Central Coast winegrape vineyard, where an eddy covariance tower measured daily ET during from May-Dec 2020. Total ET for the period showed strong agreement between the tower-based measurements (443 mm) and the CM model (431 mm). The model tended to overestimate cumulative ET during mid-June by up to 30 mm (about 15%) and later underestimated cumulative ET by as much as 65 mm (about 23%) in late September, suggesting that additional model calibration is needed to improve simulation of within-season variability. Results will be reported for trials on additional vineyard sites conducted during the 2021 season.

Evaluation↗