Engineering topics
Publications and source records attributed to Michl, Josef.
Singlet fission and its potential utility in solar photoconversion is a rapidly expanding field of scientific research. The workshop funded by this award was for facilitating collaboration and for open sharing of recent experimental or theoretical results on topics relevant to singlet fission. It took place at Estes Park Colorado at the Dao House resort on June 17 -20, 2023.
Two-dimensional materials have unusual properties and promise applications in nanoelectronics, spintronics, photonics, (electro)catalysis, separations, and elsewhere. Most are inorganic and their properties are difficult to tune. Here we report the preparation of Zn porphene, a member of the previously only hypothetical organic metalloporphene family. Similar to graphene, these also are fully conjugated two-dimensional polymers, but are composed of fused metalloporphyrin rings. Zn porphene is synthesized on water surface by two-dimensional oxidative polymerization of a Langmuir layer of Zn porphyrin with K 2 IrCl 6 , reminiscent of known one-dimensional polymerization of pyrroles. It is transferable to other substrates and bridges μm-sized pits. Contrary to previous theoretical predictions of metallic conductivity, it is a p-type semiconductor due to a predicted Peierls distortion of its unit cell from square to rectangular, analogous to the appearance of bond-length alternation in antiaromatic molecules. The observed reversible insertion of various metal ions, possibly carrying a fifth or sixth ligand, promises tunability and even patterning of circuits on an atomic canvas without removing any π centers from conjugation.
Not Available
Not Available
Symmetry breaking charge transfer (SBCT) is a process in which a pair of identical chromophores absorb a photon and use its energy to transfer an electron from one chromophore to the other, breaking the symmetry of the chromophore pair. This excited state phenomenon is observed in photosynthetic organisms where it enables efficient formation of separated charges that ultimately catalyze biosynthesis. SBCT has also been proposed as a means for developing photovoltaics and photocatalytic systems that operate with minimal energy loss. It is known that SBCT in both biological and artificial systems is in part made possible by the local environment in which it occurs, which can move to stabilize the asymmetric SBCT state. However, how environmental degrees of freedom act in concert with steric and structural constraints placed on a chromophore pair to dictate its ability to generate long-lived charge pairs via SBCT remain open topics of investigation. In this work we compare a broad series of dipyrrin dimers that are linked by distinct bridging groups to discern how the spatial separation and mutual orientation of linked chromophores and the structural flexibility of their linker each impact SBCT efficiency. Across this material set, we observe a general trend that SBCT is accelerated as the spatial separation between dimer chromophores decreases, consistent with the expectation that the electronic coupling between these units varies exponentially with their separation. However, one key observation is that the rate of charge recombination following SBCT was found to slow with decreasing interchromophore separation, rather than speed up. This stems from an enhancement of the dimers’ structural rigidity due to increasing steric repulsion as the length of their linker shrinks. This rigidity further inhibits charge recombination in systems where symmetry has already enforced zero HOMO-LUMO overlap. Additionally, for the forward transfer the active torsion is shown to increase LUMO-LUMO coupling, allowing for faster SBCT within bridging groups. Further, by understanding trends for how rates of SBCT and charge recombination depend on a dimer’s internal structure and their environment, we identify design guidelines for creating artificial systems for driving sustained light-induced charge separation. Such systems can find application in solar energy technologies and photocatalytic applications but can serve as a model for light-induced charge separation in biological systems.
Singlet fission (kSF) and excimer formation (kEXC) rate constants along with other photophysical properties of thin solid layers of 1,3-diphenylisobenzofuran and 11 of its fluorinated derivatives have been determined. The molecular properties of these compounds are similar, but their crystal packing varies widely. Most of them undergo singlet fission whereas excitation in others is trapped in excimers. The trend in rate constants kSF agrees qualitatively with results of calculations by a simplified version of the frontier orbital model for a molecular pair. The main shortcoming of the model is discussed.
The singlet fission (SF) process discovered in bis(thienyl)diketopyrrolopyrroles (TDPPs) can boost their potential for photovoltaics (PV). The crystal structures of TDPP analogs carrying n-hexyl, n-butyl, or 2-(adamant-1-yl)ethyl substituents are similar, but contain increasingly slipped stacked neighbor molecules. The observed SF rate constants, k SF , (7±4), (9±3) and (5.6±1.9) ns –1 for thin films of the three compounds, respectively, are roughly equal, but the triplet quantum yields vary strongly: (120±40), (160±40) and (70±16), respectively. The recent molecular pair model reproduces the near equality of all three k SF at the crystal geometries and identifies all possible pair arrangements in which SF is predicted to be faster, by up to two orders of magnitude. Furthermore, it is also clear that the presently non-existent ability to predict the rates of processes competing with SF is pivotal for providing a guide for efforts to optimize the materials for PV.