Search NASA⌕ Search

Engineering topics

Midden, R. E.

Publications and source records attributed to Midden, R. E..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1983

An experimental investigation of control surface effectiveness and real-gas simulation for biconics

Aerodynamic coefficients, pressure distributions, and oil-flow patterns measured on spherically blunted, 13 degrees/7 degrees on-axis and bent biconics at Mach 6 and 10 in air are compared. Angle of attack, referenced to the axis of the aft cone, was varied from zero to 40 degrees. The effect of deflection of base-mounted flaps on aerodynamic characteristics was examined at Mach 10. Real-gas effects on aerodynamic coefficients, pressure distributions and shock detachment distance were simulated by testing the biconic models in Mach 6 air and Mach 6 CF4 flows. (Density ratio equal to 5.3 for air and 12 for CF4.) The on-axis biconic is stable but cannot be trimmed at angles of attack above zero with the assumed center of gravity and flap configuration. Flaps on the bent biconic produced a stable and trim configuration for angles of attack from zero to 23 degrees. A significant effect of density ratio on aerodynamic coefficients, pressure distribution, and shock detachment distance was observed.

Miller, C. G.↗
NASA NTRS1978

Description and preliminary calibration results for the Langley hypersonic CF4 tunnel

A detailed description of the hypersonic CF4 tunnel is presented along with discussion of the basic components, instrumentation, and operating procedure. Operational experience with the CF4 reclaimer and lead-bath heater is discussed. Comparison of measured and predicted shock detachment distance on a sphere and pressure distributions measured on a sharp leading-edge flat plate revealed the absence of significant flow nonuniformity and lent creditability to predicted free stream flow conditions. The economic operation of this facility centers about the CF4 reclaimer, which was designed to operate at an efficiency of 90 to 95 percent. A number of modifications were made to the reclaimer system to improve its performance, and presently, the system reclaims approximately 75 percent of the test gas. Even with current budgetary constraints, this efficiency permits the CF4 tunnel to be operated as a viable research wind tunnel.

Midden, R. E.↗
NASA NTRS1977

Holographic flow visualization at the Langley CF4 tunnel

A holographic flow visualization system was used to obtain shadowgraph, schlieren, and interferograms of the flow field at Langley's hypersonic (Mach 6) CF4 tunnel. The dual hologram technique which was used makes it possible to vary focusing, knife-edge position, and the orientation and spacing of the interference fringes after a tunnel run. The experimental arrangement necessary to produce high quality interferograms is discussed. Typical shadowgraphs, schlieren pictures, and interferograms are presented.

Burner, A. W.↗
NASA NTRS1976

Mach 4 free-jet tunnel starting experiments for a hypersonic research engine model causing high blockage

Tests of a full scale hypersonic research engine (HRE) were conducted in the hypersonic tunnel facility at Mach numbers of 5, 6, and 7. Since the HRE would cause a rather high blockage (48.83 percent of the nozzle area), subscale tests were conducted in various available small wind tunnels prior to the full scale tests to study the effects of model blockage on tunnel starting. The results of the Mach 4 subscale tests which utilized a model system at 0.0952 scale which simulated the HRE in the test section of the tunnel are presented. A satisfactory tunnel starting could not be achieved by varying the free jet length or diffuser size nor by inserting the model into the test stream after tunnel starting. However, the installation of a shroud around the HRE model allowed the tunnel to start with the model preset in the tunnel at a tunnel stagnation pressure to atmospheric exit pressure ratio of 13.4. The simulation of the discharge of instrumentation cooling water and the addition of test hardware at the aft end of the HRE model did not have a significant effect on the tunnel starting.

Carson, G. T., Jr.↗
NASA NTRS1974

Simulation of real-gas effects for Mars entry

The changes in aerodynamic characteristics due to real-gas effects associated with high speed flight (characterized by large shock density ratios) are primarily the result of changes in surface pressures acting on the forebody. The surface pressures are affected by a change in shock density ratio (real-gas effects) in two ways. First, the level of pressure at the stagnation point relative to freestream dynamic pressure is changed, and second, the distribution of surface pressure relative to stagnation-point pressure is changed. The density-ratio effect on the stagnation point pressure level can be estimated by considering the flow of a perfect gas about a blunt body.

Hunt, J. L.↗