Search NASA⌕ Search

Engineering topics

Migliori, Albert

Publications and source records attributed to Migliori, Albert.

14 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2021

Elastic and thermodynamic properties of cerium-doped yttrium aluminum garnets

Cerium-doped yttrium aluminum garnets (Y 3-x Ce x Al 5 O 12 , Ce:YAGs) are promising yellow light-emitting components of solid-state white light-emitting diodes. Although there have been numerous studies examining the effects of Ce concentrations on the luminescent properties of Y 3-x Ce x Al 5 O 12 , the impacts of Ce dopant on the elastic and thermodynamic properties are not well understood. In this work, we used resonant ultrasound spectroscopy (RUS) to determine the effects of Ce doping (0.025, 0.1, 1 at. %) on the elastic and thermodynamic properties of Y 3-x Ce x Al 5 O 12 . The elastic moduli calculated via the Voigt–Reuss–Hill (VRH) method demonstrated that low Ce dopant concentrations (≤0.1 at. %) induced negligible effects on the elasticity of the YAG host matrix, while a high Ce concentration (1 at. %) yielded significant softening. RUS spectral analysis and SEM images suggested that the elastic softening originated from microstructural differences induced at higher Ce dopant concentrations. Additionally, we demonstrated an increase in elastic anisotropy at higher Ce concentrations, which further elucidated the correlations between structure and elasticity of Y 3-x Ce x Al 5 O 12 . Debye temperatures ($θ_D$), heat capacities ($C_p$), and thermal conductivities ($\mathit{κ}$) were calculated for Ce:YAGs through the relations of RUS-derived parameters (sound velocities, elastic moduli) and previously determined thermal expansion coefficients. Ce:YAG was found to have a significant reduction in $θ_D$, Cp, and $\mathit{κ}$ at Ce concentrations ≥1 at. %. Lastly, extrapolation of $C_p$ and $\mathit{κ}$ to higher temperatures allowed the modeling of thermal stress experienced by Y 3-x Ce x Al 5 O 12 disks up to 1073.15 K.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Skyrmion lattice creep at ultra-low current densities

Abstract Magnetic skyrmions are well-suited for encoding information because they are nano-sized, topologically stable, and only require ultra-low critical current densities j c to depin from the underlying atomic lattice. Above j c skyrmions exhibit well-controlled motion, making them prime candidates for race-track memories. In thin films thermally-activated creep motion of isolated skyrmions was observed below j c as predicted by theory. Uncontrolled skyrmion motion is detrimental for race-track memories and is not fully understood. Notably, the creep of skyrmion lattices in bulk materials remains to be explored. Here we show using resonant ultrasound spectroscopy—a probe highly sensitive to the coupling between skyrmion and atomic lattices—that in the prototypical skyrmion lattice material MnSi depinning occurs at $${j}_{c}^{* }$$ j c * that is only 4 percent of j c . Our experiments are in excellent agreement with Anderson-Kim theory for creep and allow us to reveal a new dynamic regime at ultra-low current densities characterized by thermally-activated skyrmion-lattice-creep with important consequences for applications.

36 MATERIALS SCIENCE↗
DOE OSTI2019

Resonant ultrasound spectroscopy: The essential toolbox

Resonant Ultrasound Spectroscopy (RUS) is an ultrasound-based minimal-effort high-accuracy elastic modulus measurement technique. RUS as described here uses the mechanical resonances (normal modes of vibration or just modes) of rectangular parallelepiped or cylindrical specimens with a dimension of from a fraction of a millimeter to as large as will fit into the apparatus. Provided here is all that is needed so that the reader can construct and use a state-of-the-art RUS system. Included are links to open-source circuit diagrams, links to download Los Alamos National Laboratory open-source data acquisition software, links to request free analysis software, procedures for acquiring measurements, considerations on building transducers, 3-D printed stage designs, and a full mathematical explanation of how the analysis software extracts elastic moduli from resonances.

47 OTHER INSTRUMENTATION↗
DOE OSTI2019

Sample seal-and-drop device and methodology for high temperature oxide melt solution calorimetric measurements of PuO 2

Thermodynamic properties of refractory materials, such as standard enthalpy of formation, heat content, and enthalpy of reaction, can be measured by high temperature calorimetry. In such experiments, a small sample pellet is dropped from room temperature into a calorimeter operating at high temperature (often 700 °C) with or without a molten salt solvent present in an inert crucible in the calorimeter chamber. However, for hazardous (radioactive, toxic, etc.) and/or air-sensitive (hygroscopic, sensitive to oxygen, pyrophoric, etc.) samples, it is necessary to utilize a sealed device to encapsulate and isolate the samples, crucibles, and solvent under a controlled atmosphere in order to prevent the materials from reactions and/or protect the personnel from hazardous exposure during the calorimetric experiments. We have developed a sample seal-and-drop device (calorimetric dropper) that can be readily installed onto the dropping tube of a calorimeter such as the Setaram AlexSYS Calvet-type high temperature calorimeter to fulfill two functions: (i) load hazardous or air-sensitive samples in an air-tight, sealed container and (ii) drop the samples into the calorimeter chamber using an “off-then-on” mechanism. As a case study, we used the calorimetric dropper for measurements of the enthalpy of drop solution of PuO 2 in molten sodium molybdate (3Na 2 O · 4MoO 3 ) solvent at 700 °C. The obtained enthalpy of –52.21 ± 3.68 kJ/mol is consistent with the energetic systematics of other actinide oxides (UO 2 , ThO 2 , and NpO 2 ). In conclusion, this capability has thus laid the foundation for thermodynamic studies of other Pu-bearing phases in the future.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2019

Toward an understanding of aging in plutonium from direct measurements of stored energy

We present here the first direct measurement of the radiation-damage-induced energy stored in δ-phase plutonium. The primary mode of radioactive decay of 239 Pu occurs with a time constant of τ=1.1x10 12 s. Each decay imparts about 86 keV of recoil energy to the uranium byproduct, 5.2 Mev to the alpha particle, and a spectrum of mostly low energy gamma rays with the most probable at 51 keV 1 . Most of the decay energy is converted immediately to heat, releasing about 1.9 mW/g. However, some thermallyrecoverable energy remains trapped. Reported here are measurements of that stored energy using differential scanning calorimetry (DSC) applied to 239 Pu-2.0 at. % Ga δ- phase alloy. Retained energy of ~2 J/g saturates at about 5 months and is unchanged after 30 years. The magnitude of the stored energy agrees with a short-bond defect model that that we present here. That model treats radiation damage as a Pu impurity with shortened bond lengths. It explains the change in known properties with age and predicts that density increases with age, contrary to current thinking. The short-bond impurities proposed are expected to act like any other impurity, affecting strength, phase transitions, grain boundaries and other metallurgical properties.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗
DOE OSTI2017

Elastic moduli of δ-Pu 239 reveal aging in real time

We study the time evolution (aging) of the elastic moduli of an eight-year-old polycrystalline δ- Pu 2.0 at % Ga alloy (δ-Pu:Ga ) from 295K to nearly 500K in real time using Resonant Ultrasound Spectroscopy (RUS). After 8 years of aging at 295K, the bulk and shear moduli increase at a normalized rate of 0.2%/year and 0.6%/year respectively. As the temperature is raised, two time dependences are observed, an exponential one of about a week, followed by a linear one (constant rate). The linear rate is thermally activated with an activation energy of 0.33+0.06 eV. Above 420K a qualitative change in the time evolution is observed; the bulk modulus decreases with time while the shear modulus continues to stiffen. No change is observed as the α-β transition temperature is crossed as would be expected if a decomposition of δ-Pu:Ga to α-Pu and Pu 3 Ga occurred over the temperature range studied. Our results indicate that the main mechanism of aging is creation of defects that are partially annealed starting at T = 420 K.

36 MATERIALS SCIENCE↗
DOE OSTI2017

Plutonium metal

Explore the source record for details and available documents.

Plutonium metal tutorial↗
DOE OSTI2017

Experimental Physical Sciences Vistas Performance through Science Winter 2017

This issue of Experimental Physical Sciences Vistas focuses on the integrated science that plays a critical role in Los Alamos National Laboratory’s support of the nation’s nuclear deterrent. I hope you will enjoy reading about these accomplishments, opportunities, and challenges.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗