Milind A Bakhle | Search NASA

NASA NTRS2024

Tail-Cone Thruster Fan Rotor Flutter Analysis

The aeroelastic stability of a tail cone thruster fan was analyzed for three structural modes and various nodal diameter patterns. Computational fluid dynamics modeling with blade vibrations was used in the analyses performed at design (peak-efficiency) and two near-stall conditions at the design rotational speed. Aerodynamic damping was used to assess flutter since this integrally bladed rotor design will have minimal structural damping. Aerodynamic damping was found to be low at the design condition. For the first mode, aerodynamic damping was seen to decrease towards stall, vanishing for a zero nodal diameter pattern. Further decrease in mass flow led to negative aerodynamic damping (flutter) for the first and second nodal diameters in the near stall condition. The flowfield at this lowest mass flow rate exhibited some additional unsteadiness at higher frequency. The sensitivity of results to time step and amplitudes of vibration was examined and found to be very satisfactory. The largest uncertainty in the results comes from the observed sensitivity of the aerodynamic damping to details of the variation of grid deformations in the blade passage mesh from the blade passage to the boundaries. For the parametric variations analyzed, the calculated aerodynamic damping is lower if the grid deformations near the blade surface are higher. Further work is needed to understand the cause of this sensitivity and find possible solutions to reduce the effects on flutter predictions.

Fan↗

NASA NTRS2020

TURBOMAT-FR: Turbomachinery Aeroelastic Forced Response Analysis Automation Using MATLAB® Part 2

The primary aim of this effort is to develop a software tool named “Turbomachinery Aeroelastic Analysis Tool for Forced Response (TURBOMAT-FR)” using MATLAB® (The MathWorks, Inc.) scripts. The tool will aid in performing routine forced response analysis of turbomachinery fan blades with the aid of the modal summation method (MSUM). The MSUM approach requires a modal solution consisting of modal displacements, frequencies, and stresses. The MATLAB® scripts facilitate easy extraction of the required quantities from the computational fluid dynamics (CFD) and MSC Nastran (Hexagon AB) solution files. These quantities are subsequently utilized by the MSUM approach to perform a complete forced response analysis using the MATLAB® scripts. The MATLAB® scripts in TURBOMAT-FR are utilized in postprocessing of the MSC Nastran finite element analysis outputs in three types of solutions or steps, namely (1) stresses and displacements from static or steady response solution, (2) unsteady stresses and displacements from direct forced response solution, and (3) modal solution containing modal displacements and modal stresses. In step (4), separate MATLAB® scripts are also developed to read the processed outputs in step (3) and perform forced response analysis using MSUM. It should be noted that the direct forced response solution from step (2) will provide for a comparison with those obtained from the MSUM approach in steps (3) and (4). The TURBOMAT-FR MATLAB® scripts mentioned previously are presented in two reports designated Parts 1 and 2. Part 1 presents the scripts needed to accomplish steps (1) and (2). The current report, Part 2, presents the scripts needed to accomplish steps (3) and (4), noted previously. The TURBOMAT-FR MATLAB® scripts provided here in Part 2 facilitate the calculation of unsteady stresses using MSUM and provide an automated procedure associated with aeroelastic forced response analysis with different pressure files. The unsteady stresses calculated using MSUM can be compared with those presented in Part 1. A cantilevered blade-alone model subjected to a realistic pressure loading to a boundary was used for static and unsteady direct forced response analysis to demonstrate the effectiveness of the TURBOMATFR MATLAB® scripts.

T S R Reddy↗