Search NASA⌕ Search

Engineering topics

Miller, G. K., Jr.

Publications and source records attributed to Miller, G. K., Jr..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1982

Comparison of analytical predictions of longitudinal short period pilot-induced oscillations with results from a simulation study of the space shuttle orbiter

An analytical analysis of conditions producing pilot induced oscillations (PIO's) was made for the space shuttle orbiter in a landing approach configuration for the task of milling the elevation angle of the line of sight to a target vehicle. The analysis yielded a value of PIO frequency and a value for the amount of total system time delay (pilot + control system) that can be tolerated before instability results. Calculations were performed showing the effect of varying the range to the target and of varying the handling qualities of the orbiter vehicle. Analytical predictions were compared with simulation results obtained using a visual motion simulator.

Riley, D. R.↗
NASA NTRS1982

An analytical technique for the analysis of airplane spin entry and recovery

The dynamic equations of motion for a spinning airplane are simplified to facilitate the analysis of spin entry and recovery maneuvers. Solutions of a nonlinear, first order equation for spin rate enable calculation of spin entry and recovery times and control required for recovery. The analysis is applied to a light airplane for which both aerodynamic data, rotory balance wind tunnel tests, and spin flight test data have been obtained. A comparison of predicted and actual transient spin responses is made which supports the validity of the analytical approach taken but which also illustrates the difficulty in obtaining accurate aerodynamic data for spinning airplanes. Certain normalized parameters of the reduced state spin equation suggest criteria for assessing the transient spin characteristics of light airplanes.

Taylor, L. W., Jr.↗
NASA NTRS1981

Simulator evaluation of the effects of reduced spoiler and thrust authority on a decoupled longitudinal control system during landings in wind shear

The effect of reduced control authority, both in symmetric spoiler travel and thrust level, on the effectiveness of a decoupled longitudinal control system was examined during the approach and landing of the NASA terminal configured vehicle (TCV) aft flight deck simulator in the presence of wind shear. The evaluation was conducted in a fixed-base simulator that represented the TCV aft cockpit. There were no statistically significant effects of reduced spoiler and thrust authority on pilot performance during approach and landing. Increased wind severity degraded approach and landing performance by an amount that was often significant. However, every attempted landing was completed safely regardless of the wind severity. There were statistically significant differences in performance between subjects, but the differences were generally restricted to the control wheel and control-column activity during the approach.

Miller, G. K., Jr.↗
NASA NTRS1981

A decoupled control system for improved flight performance in wind shear

A fixed-base simulation study has been made to compare the approach and landing performance of a decoupled longitudinal control system and the velocity-vector control-wheel steering (VCWS) system that currently exists on the NASA Terminal Configured Vehicle (TCV). The decoupled control system employed constant prefilter and feedback gains to provide steady-state decoupling of flight-path angle, pitch angle, and forward velocity using symmetric spoilers, throttle, and elevator as active control elements. In severe wind shear, of the Kennedy-type, the decoupled control system improved both approach performance and touchdown performance even when the spoiler deflection was limited to 16 deg. On a 10-point rating scale, three research pilots rated the approach and landing task with decoupled controls as much as 3 to 4 increments better than the use of the VCWS system in severe winds

Miller, G. K., Jr.↗
NASA NTRS1980

Simulator study of the effect of control-system time delays on the occurrence of pilot-induced oscillations and on pilot tracking performance with a space-shuttle-orbiter configuration

Using a six degree-of-freedom motion-base simulator, the effect of control-system time delays on the occurrence of pilot-induced oscillations (PIO's) on the vehicle handling qualities and on pilot tracking performance for a landing-approach configuration of the Space Shuttle orbiter was studied. A linearized math model was employed which represented a 300-knot orbiter with almost all time delays removed. Additional time delays were then inserted following the pilot's hand-controller signals. Only pitch and roll commands were used for vehicle control. The simulation employed an air to air tracking task as a means of emphasizing PIO tendencies. Two astronauts, two research pilots, and one simulation engineer served as test subjects. Results showed that PIO's occurred when the amount of added time delay approximated that existing for the orbiter configuration flown in the approach and landing tests. Increasing the amount of delay increased PIO occurrences and resulted in degraded tracking performance. Decreasing the amount of time delay eliminated the PIO's.

Riley, D. R.↗
NASA NTRS1979

Fixed-base simulation study of decoupled longitudinal controls during approach and landing of a medium jet transport in the presence of wind shear

The use of decoupled longitudinal controls during the approach and landing of a typical twin-engine jet transport in the presence of wind shear was studied. The simulation included use of a localizer and flight director to capture and maintain a 3 deg glide slope. The pilot then completed the landing by using visual cues provided below an altitude of 200 m by closed-circuit television and a terrain model. The decoupled controls used constant prefilter and feedback gains to provide steady state decoupling of flight path angle, pitch angle, and forward velocity. The use of the decoupled control system improved pilot performance during the approach and at touchdown in the presence of wind shears. The pilots preferred the decoupled controls and rated the task 1 to 3 increments better on a pilot rating scale, depending on wind conditions, than was the case when conventional controls were used.

Miller, G. K., Jr.↗
NASA NTRS1979

Decoupled longitudinal controls for shear penetration in the terminal area environment

The use of decoupled longitudinal controls is simulated for the approach and landing of a twin engine jet transport in the presence of wind shear. Decoupled or independent control of pitch angle, flight-path angle and forward velocity using constant prefilter and feedback gains was compared to conventional control of a B-737 aircraft simulator. It is found that the mean flight-path angle, the mean glideslope error and the mean deviation in indicated airspeed generally improved when decoupled controls were used in the approach. An improvement in touchdown parameters was also observed, especially in strong shear, when 44% of conventionally-controlled flights impacted short of the runway. Simulator pilots reported improved approach performance and a reduced workload when decoupled controls were used.

Miller, G. K., Jr.↗
NASA NTRS1978

Evaluation of several secondary tasks in the determination of permissible time delays in simulator visual and motion cues

The effect of secondary tasks in determining permissible time delays in visual-motion simulation of a pursuit tracking task was examined. A single subject, a single set of aircraft handling qualities, and a single motion condition in tracking a target aircraft that oscillates sinusoidally in altitude were used. In addition to the basic simulator delays the results indicate that the permissible time delay is about 250 msec for either a tapping task, an adding task, or an audio task and is approximately 125 msec less than when no secondary task is involved. The magnitudes of the primary task performance measures, however, differ only for the tapping task. A power spectraldensity analysis basically confirms the result by comparing the root-mean-square performance measures. For all three secondary tasks, the total pilot workload was quite high.

Miller, G. K., Jr.↗
NASA NTRS1978

Simulator study of the effect of visual-motion time delays on pilot tracking performance with an audio side task

The effect of time delay was determined in the visual and motion cues in a flight simulator on pilot performance in tracking a target aircraft that was oscillating sinusoidally in altitude only. An audio side task was used to assure the subject was fully occupied at all times. The results indicate that, within the test grid employed, about the same acceptable time delay (250 msec) was obtained for a single aircraft (fighter type) by each of two subjects for both fixed-base and motion-base conditions. Acceptable time delay is defined as the largest amount of delay that can be inserted simultaneously into the visual and motion cues before performance degradation occurs. A statistical analysis of the data was made to establish this value of time delay. Audio side task provided quantitative data that documented the subject's work level.

Riley, D. R.↗
NASA NTRS1977

The effect of visual-motion time-delays on pilot performance in a simulated pursuit tracking task

An experimental study was made to determine the effect on pilot performance of time delays in the visual and motion feedback loops of a simulated pursuit tracking task. Three major interrelated factors were identified: task difficulty either in the form of airplane handling qualities or target frequency, the amount and type of motion cues, and time delay itself. In general, the greater the task difficulty, the smaller the time delay that could exist without degrading pilot performance. Conversely, the greater the motion fidelity, the greater the time delay that could be tolerated. The effect of motion was, however, pilot dependent.

Miller, G. K., Jr.↗
NASA NTRS1976

The effect of visual-motion time delays on pilot performance in a pursuit tracking task

A study has been made to determine the effect of visual-motion time delays on pilot performance of a simulated pursuit tracking task. Three interrelated major effects have been identified: task difficulty, motion cues, and time delays. As task difficulty, as determined by airplane handling qualities or target frequency, increases, the amount of acceptable time delay decreases. However, when relatively complete motion cues are included in the simulation, the pilot can maintain his performance for considerably longer time delays. In addition, the number of degrees of freedom of motion employed is a significant factor.

Miller, G. K., Jr.↗
NASA NTRS1976

Study of an aircraft decoupled longitudinal control system for approach and landing

A series of ground-based and in-flight simulation studies of the application of steady-state decoupled longitudinal controls to a short take-off and landing (STOL) transport have been made. The externally blown flap STOL was selected for study because it was considered to be a worst-case situation from the control viewpoint. The decoupled longitudinal control system used constant prefilter and feedback gains to provide independent control of flight-path angle, pitch angle, and forward velocity during landing approach. The decoupled controls were compared to a more conventional stability augmentation system. The pilots were enthusiastic about the decoupled controls; the pilot workload was reduced and the landing performance significantly improved. The benefit of the decoupled controls was more dramatic during in-flight simulation using a variable stability airplane than was the case with either fixed- or moving-base, ground-based simulators.

Miller, G. K., Jr.↗
NASA NTRS1975

Moving-base visual simulation study of decoupled controls during approach and landing of a STOL transport aircraft

The simulation employed all six rigid-body degrees of freedom and incorporated aerodynamic characteristics based on wind-tunnel data. The flight instrumentation included a localizer and a flight director which was used to capture and to maintain a two-segment glide slope. A closed-circuit television display of a STOLport provided visual cues during simulations of the approach and landing. The decoupled longitudinal controls used constant prefilter and feedback gains to provide steady-state decoupling of flight-path angle, pitch angle, and forward velocity. The pilots were enthusiastic about the decoupled longitudinal controls and believed that the simulator motion was an aid in evaluating the decoupled controls, although a minimum turbulence level with root-mean-square gust intensity of 0.3 m/sec (1 ft/sec) was required to mask undesirable characteristics of the moving-base simulator.

Miller, G. K., Jr.↗
NASA NTRS1974

A motion-constraint logic for moving-base simulators based on variable filter parameters

A motion-constraint logic for moving-base simulators has been developed that is a modification to the linear second-order filters generally employed in conventional constraints. In the modified constraint logic, the filter parameters are not constant but vary with the instantaneous motion-base position to increase the constraint as the system approaches the positional limits. With the modified constraint logic, accelerations larger than originally expected are limited while conventional linear filters would result in automatic shutdown of the motion base. In addition, the modified washout logic has frequency-response characteristics that are an improvement over conventional linear filters with braking for low-frequency pilot inputs. During simulated landing approaches of an externally blown flap short take-off and landing (STOL) transport using decoupled longitudinal controls, the pilots were unable to detect much difference between the modified constraint logic and the logic based on linear filters with braking.

Miller, G. K., Jr.↗
NASA NTRS1974

Fixed-base simulation study of decoupled controls during approach and landing of a STOL transport airplane

A fixed-base visual simulation study has been conducted to evaluate the use of decoupled controls as a means for reducing pilot workload during approach and landing of an externally blown jet-flap short take-off and landing (STOL) transport. All six rigid-body degrees of freedom were employed with the aerodynamic characteristics based on wind-tunnel data. The primary piloting task was to use a flight director to capture and maintain a two-segment glide slope, with a closed-circuit television display of a STOL airport used during simulations of the flare and landing. The decoupled longitudinal controls used constant prefilter and feedback gains to provide steady-state decoupling of flight-path angle, pitch angle, and forward velocity. The pilots were enthusiastic about the decoupled longitudinal controls but believed the decoupled concept offered no significant advantage over conventional controls in the lateral mode.

Miller, G. K., Jr.↗