Search NASASearch

Engineering topics

Miller, L. S.

Publications and source records attributed to Miller, L. S..

At least 19 records

Correction of Sampling Errors in Ocean Surface Cross-Sectional Estimates from Nadir-Looking Weather Radar

The return from the ocean surface has a number of uses for airborne meteorological radar. The normalized surface cross section has been used for radar system calibration, estimation of surface winds, and in algorithms for estimating the path-integrated attenuation in rain. However, meteorological radars are normally optimized for observation of distributed targets that fill the resolution volume, and so a point target such as the surface can be poorly sampled, particularly at near-nadir look angles. Sampling the nadir surface return at an insufficient rate results in a negative bias of the estimated cross section. This error is found to be as large as 4 dB using observations from a high-altitude airborne radar. An algorithm for mitigating the error is developed that is based upon the shape of the surface echo and uses the returned signal at the three range gates nearest the peak surface echo.

Caylor, I. Jeff

Doppler global velocimeter measurements of the vortical flow above a thin delta wing

Doppler global velocimetry, currently under development by NASA for the measurement of off-surface flow fields, will allow quantification of complex, 3D flow fields at video-camera rates and accomplish the simultaneous measurement of an entire flow field structure within the given plane. In order to assess the performance capabilities of the technique, velocity measurements of the vortical flow field above a thin, 75-deg delta wing were conducted at NASA-Langley and compared with results obtained via three-component laser velocimeter. The achievement of performance goals is confirmed.

Usry, Jimmy W.

The effects of blowing on delta wing vortices during dynamic pitching at high angles of attack

An experimental investigation was conducted in a water tunnel to identify the effects of apex blowing on two delta-wing models undergoing constant pitch-rate motion. One wing was of 60-degree sweep and the other was of 76-degree sweep. Flow visualization methods were utilized to determine vortex burst locations for a wide range of pitch-up (nose up) and plunge (nose down) rates, apex jet strengths, and blowing directions. Results indicate that blowing along the 60-degree wing vortex core or along the 76-degree wing centerline results in a notable improvement in vortex behavior under both static and dynamic conditions. The results are most dramatic during dynamic plunging (nose down) conditions, where blowing resulted in the reformation of vortices with significant length.

Miller, L. S.

The effect of microwave backscatter uncertainty on satellite radar altimeter accuracy

The effect of variations in ocean surface roughness characteristics with upwind/downwind direction, reported by other investigators, is used to compute radar cross section (RCS) and to assess the errors which may arise in present and planned altimeter sensors. Based on an analysis of the rough surface impulse response, the uncertainty between attitude angle and RCS asymmetry is found to cause height errors as large as 12 cm, depending on off-nadir angles and sea state. Additionally, the previously reported data in conjunction with computed facet backscatter are found to produce RCS characteristics at large off-nadir angles which are in better agreement with experimental results than those predicted by physical optics Gaussian theory.

Miller, L. S.

The application of near-nadir Delta-k radar techniques to geodetic altimetry and oceanographic remote sensing

This paper first examines the extension of two-frequency, or Delta-k near-nadir remote sensing techniques to off-nadir radar altimetry. A different approach to sea state sensing is investigated which appears to offer much higher accuracy. The second section examines the Delta-k method of sensing rough surface area correlation or ocean wavenumber spectrum. The technique shows promise of directly sensing this parameter, in contrast with synthetic-aperture radar methods which are based on complex wave interaction mechanisms and mathematical transformations requiring the acquisition of voluminous data.

Miller, L. S.

Oceanic geoid and tides derived from GEOS 3 satellite data in the Northwestern Atlantic Ocean

Two sets of GEOS 3 altimeter data which fall within about a 2.5-deg width are analyzed for ocean geoid and tides. One set covers a path from Newfoundland to Cuba, and the other a path from Puerto Rico to the North Carolina coast. Forty different analyses using various parameters are performed in order to investigate convergence. Profiles of the geoid and four tides, M2, O1, S2, and K1, are derived along the two strips. While the analyses produced convergent solutions for all 40 cases, the uncertainty caused by the linear orbital bias error of the satellite is too large to claim that the solutions represent the true ocean tides in the area. A spot check of the result with the Mode deep-sea tide gauge data shows poor agreement. A positive conclusion of this study is that despite the uncertain orbital error the oceanic geoid obtained through this analysis can improve significantly the short-wavelength structure over existing spherical harmonic geoid models.

Won, I. J.

An investigation of the observability of ocean-surface parameters using GEOS-3 backscatter data

The degree to which ocean surface roughness can be synoptically observed through use of the information extracted from the GEOS-3 backscattered waveform data was evaluated. Algorithms are given for use in estimating the radar sensed waveheight distribution or ocean-surface impulse response. Other factors discussed include comparisons between theoretical and experimental radar cross section values, sea state bias effects, spatial variability of significant waveheight data, and sensor-related considerations.

Miller, L. S.

Oceanic Geoid and Tides Obtained from GEOS-3 Satellite Data in the Northwestern Atlantic Ocean

Two sets of GEO-3 altimeter data which fall within about a 2.5 degree width are analyzed for ocean geoid and tides. One set covers a linear path from Newfoundland to Cuba and the other from Puerto Rico to the North Carolina coast. Forty different analyses using various parameters are performed in order to investigate convergence. Profiles of the geoid and four tides, M sub 2 O sub 1, S sub 2, and K sub 1, are obtained along the two strips. The results demonstrate convergent solutions for all forty cases and show, within expectation, fair agreement with those obtained from the MODE deep-sea tide gauge. It is also shown that the oceanic geoid obtained through this analysis can potentially improve the short wavelength structure over existing geoid models.

Won, I. J.

Microwave backscattering theory and active remote sensing of the ocean surface

The status is reviewed of electromagnetic scattering theory relative to the interpretation of microwave remote sensing data acquired from spaceborne platforms over the ocean surface. Particular emphasis is given to the assumptions which are either implicit or explicit in the theory. The multiple scale scattering theory developed during this investigation is extended to non-Gaussian surface statistics. It is shown that the important statistic for the case is the probability density function of the small scale heights conditioned on the large scale slopes; this dependence may explain the anisotropic scattering measurements recently obtained with the AAFE Radscat. It is noted that present surface measurements are inadequate to verify or reject the existing scattering theories. Surface measurements are recommended for qualifying sensor data from radar altimeters and scatterometers. Additional scattering investigations are suggested for imaging type radars employing synthetically generated apertures.

Brown, G. S.

Investigation of the applications of GEOS-3 radar altimeter data in remote sensing of land and sea features

A number of GEOS-3 passes over the Atlantic Ocean and Southeastern U.S. are examined. Surface-truth and radar altimeter data comparisons are given in terms of surface correlation length, signal fluctuation characteristics, and altitude tracker dynamic response. Detailed analyses are given regarding spatial resolution and its dependency on angular backscatter behavior. These analyses include data from passes over ocean (diffuse scatter), land (large body scatter), and mirror-like inland water areas (pseudo-specular scatter). Altimeter data are examined for a pass over a large reservoir and marsh area of differing water levels; this geometry represents a stepchange in altitude which is usable in determination of the transient response of the tracker. The extent to which pulse-length limited operation pertains over-land is examined. A Wiener filter altitude algorithm is discussed which permits specification of tracker variance and geoidal spectral characteristics during operation.

Miller, L. S.

Altimeter waveform software design

Techniques are described for preprocessing raw return waveform data from the GEOS-3 radar altimeter. Topics discussed include: (1) general altimeter data preprocessing to be done at the GEOS-3 Data Processing Center to correct altimeter waveform data for temperature calibrations, to convert between engineering and final data units and to convert telemetered parameter quantities to more appropriate final data distribution values: (2) time "tagging" of altimeter return waveform data quantities to compensate for various delays, misalignments and calculational intervals; (3) data processing procedures for use in estimating spacecraft attitude from altimeter waveform sampling gates; and (4) feasibility of use of a ground-based reflector or transponder to obtain in-flight calibration information on GEOS-3 altimeter performance.

Hayne, G. S.

Skylab altimeter applications and scientific results

Analysis of the Skylab S-193 Altimeter Experiment data has produced many significant results. The purpose of this paper is to present some of these results which illustrate the programmatic altimeter technology gained and show the scientific potential of altimetry for various applications, including correlation with existing topographic features, geoids and physical models. It will be shown that there exists a very strong correlation between subsurface topography in the broad ocean area and the shape of the ocean surface as determined from the altimeter. Modeled scattering waveforms will be correlated with Skylab Altimeter waveforms. The agreement of a variety of existing geoid models with the altimeter data will be shown. In addition the calibration, accuracy and stability of the S-193 altimeter instrumentation will be discussed.

Mcgoogan, J. T.

The S-193 radar altimeter experiment

The Skylab S-193 altimeter experiment utilizes a 10- and 100-ns pulse length, 13.9-GHz earth-pointed radar system to obtain earth-surface backscatter measurements from the Skylab spacecraft. Objectives of the experiment are to obtain precision measurements of surface profile for uses in geodesy, oceanography, and earth physics, and to measure radar-signal characteristics from an earth-orbit geometry to provide design information for future radar remote-sensors. The technical approach is that of measuring the power impulse response of the scattering surface. The hardware is designed to operate in five modes: waveform or impulse-response measurement and altitude determination; radar cross-section experiment; signal correlation experiment; 10-nsec pulse-compression evaluation; and nadir-seeker experiment.

Mcgoogan, J. T.

Engineering studies related to the GEOS-C radar altimeter

Experiment requirements, technical characteristics, and GEOS-C radar altimeter related analyses are discussed along with results of a study on engineering test data requirements. Statistical analyses related to determination of wave height resolution achievable as a function of system characteristics and averaging period are described, in addition to a discussion on the desirability of using computer procedures to compensate for altitude tracker time-jitter. Data processing considerations for the GEOS-C system are examined. An extensive analysis of the spatial filter effect is given and results of a computation of geoidal power spectral density, based on Skylab altimeter data, is displayed and interpreted in terms of projected GEOS-C random errors. This information is then used in deriving minimum-mean-square filter procedures for both geoid undulation and slope data. The characteristics of mean received waveforms as a function of off-nadir angle are used to obtain tracker bias as a function of sea state and pointing angle. The angle estimation process proposed by the GEOS-C hardware contractor is also investigated from a standpoint of achievable angular resolution.

Miller, L. S.

Skylab S-193 altimeter experiment performance, results and applications

A description of the Skylab altimeter instrument system along with the appropriate system error model is presented. The data processing flow, orbit computation, and topographic recovery techniques are discussed. Some data analysis results are presented which indicate excellent correlation with underwater topographic features. In addition, results are shown which indicate that the instrument performance was as expected.

Mcgoogan, J. T.