Search NASA⌕ Search

Engineering topics

Miller, S.

Publications and source records attributed to Miller, S..

At least 19 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Persistent Hot-Spot Mix in Cryogenic Direct-Drive Fusion Experiments

We show that an x-ray emission signature associated with acceleration phase mass injection correlates with poor experimental hot-spot convergence and a reduced neutron production relative to expectations. It is shown that with increased target mass as well as with higher-design adiabats, this signature is reduced, whereas with increased debris on the target the signature is increased. Here, we estimate that the vapor region in typical best designs may have up to 2x the assumed hydrogen mass at the start of deceleration.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2024

Acceleration of uranium beam to record power of 10.4 kW and observation of new isotopes at Facility for Rare Isotope Beams

The Facility for Rare Isotope Beams (FRIB) is a major nuclear physics facility for research with fast, stopped, and reaccelerated beams that was successfully commissioned in May 2022. A key capability of FRIB is the production of an acceleration of the uranium beam, but this capability requires the facility to work at the design limits of the lowest charge-to-mass ratio and the highest power density on the beam intercepting devices. This paper presents techniques for overcoming the significant challenges in accelerating the uranium beam, culminating in the demonstration of 10.4 kW on target, and the discovery of three new isotopes. The high-power uranium beam enabled us to produce and identify G 88 a , A 93 s , and S 96 e , within the first 24 h of operation. The successful uranium operation at FRIB sets a new record for accelerated uranium beam power above 10 kW and opens a new avenue of research with rare isotopes. Published by the American Physical Society 2024

43 PARTICLE ACCELERATORS↗
DOE OSTI2024

Technological developments and accelerator improvements for the FRIB beam power ramp-up

The Facility for Rare Isotope Beams (FRIB) began operation with 1 kW beam power for scientific users in May 2022 upon completion of 8 years of project construction. The ramp-up to the ultimate beam power of 400 kW, planned over a 6-year period, will enable the facility to reach its full potential for scientific discovery in isotope science and applications. In December 2023, a record-high beam power of 10.4 kW uranium was delivered to the target. Technological developments and accelerator improvements are being made over the entire facility and are key to completion of the power ramp-up. Major technological developments entail the phased deployment of high-power beam-intercepting systems, including the charge strippers, the charge selection systems, the production target, and the beam dump, along with support systems, including non-conventional utilities (NCU) and remote handling facilities. Major accelerator improvements include renovations to aging legacy systems associated with experimental beam lines and system automation for improved operational efficiency and better machine availability. Experience must be gained to safely handle the increased radiological impacts associated with high beam power; extensive machine studies and advanced beam tuning procedures are needed to minimize uncontrolled beam losses for the desired operating conditions. This paper discusses the technological developments and accelerator improvements with emphasis on major R&D efforts.

43 PARTICLE ACCELERATORS↗
DOE OSTI2024

Validation of implosion modeling through direct-drive shock timing experiments at the National Ignition Facility

Precise modeling of shocks in inertial confinement fusion implosions is critical for obtaining the desired compression in experiments. Shock velocities and post-shock conditions are determined by laser-energy deposition, heat conduction, and equations of state. This paper describes experiments at the National Ignition Facility (NIF) where multiple shocks are launched into a cone-in-shell target made of polystyrene, using laser pulse shapes with two or three pickets and varying on-target intensities. Shocks are diagnosed using the Velocity Interferometric System for Any Reflector diagnostic. Simulated and inferred shock velocities agree well for the range of intensities studied in this work. These results are the first shock-velocity measurements using direct drive on the NIF and provide a good measure of early-time, directly driven laser-energy coupling. Furthermore, the validated models add to the credibility of direct-drive-ignition designs at the megajoule scale.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

EMPIRE User Manual

This is the user manual for EMPIRE, a simulation code for electromagnetics and plasma physics.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

Accelerator commissioning and rare isotope identification at the Facility for Rare Isotope Beams

In 2008, Michigan State University was selected to establish the Facility for Rare Isotope Beams (FRIB). Construction of the FRIB accelerator was completed in January 2022. Phased accelerator commissioning with heavy ion beams started in 2017 with the normal-conducting ion source and radio-frequency quadrupole. In April 2021, the full FRIB driver linear accelerator (linac) was commissioned, with heavy ion beams accelerated to energies above 200 MeV/nucleon by 324 superconducting radiofrequency (SRF) resonators operating at 2 K and 4 K with liquid-helium cooling. Further, in preparation for high-power operation, a liquid lithium charge stripper was commissioned with heavy ion beams up to uranium-238, followed by the simultaneous acceleration of multiple-charge-state heavy ion beams to energies above 200 MeV/nucleon. In December 2021, selenium-84 was produced with the FRIB target using a krypton-86 primary beam, demonstrating FRIB’s capability for scientific discovery.

07 ISOTOPE AND RADIATION SOURCES↗
DOE OSTI2022

Saturn's Weather‐Driven Aurorae Modulate Oscillations in the Magnetic Field and Radio Emissions

Abstract The Cassini spacecraft revealed that Saturn's magnetic field displayed oscillations at a period originally thought to match the planetary rotation rate but later found not to. One of many proposed theories predicts that a polar twin‐cell neutral weather system drives this variation, producing observable differences in flows within Saturn's ionosphere. Here, using spectral observations of auroral emission lines taken by the Keck Observatory's Near Infrared Echelle Spectrograph (Keck‐NIRSPEC) in 2017, we derive ion line‐of‐sight velocity maps after grouping spectra into rotational quadrants matching phases of the planetary magnetic field. We measure 0.5 km s −1 wind systems in the ionosphere consistent with predicted neutral twin‐vortex flow patterns. These findings demonstrate that neutral winds in Saturn's polar regions cause the rotational period, as determined via the magnetic field, to exhibit differences and time variabilities relative to the planet's true period of rotation in a process never before seen within planetary atmospheres.

Chowdhury, M. N.↗
DOE OSTI2020

Theory of ignition and burn propagation in inertial fusion implosions

A detailed analytic model is presented here to investigate the physics of burn propagation in inertially confined plasmas. The onset of ignition and burn propagation occurs when alpha heating of the hot spot causes rapid ablation of shell mass into the hot spot. This allows large energy gains to be achieved since most of the fuel mass is located in the shell. Here, we first present a comprehensive review of previous analytic models that have been used to describe the physics of hot-spot evolution and ignition; we then show that a proper description of a propagating burn wave requires a comprehensive model of hot spot and shell evolution that includes proper mass conservation in the shell, fusion reactivity, and fuel depletion. The analytic theory is in good agreement with detailed radiation-hydrodynamic simulations that predict the onset of burn propagation as occurring when the yield enhancement caused by alpha heating is between 15- and 25-fold, $f_α$ ~ 1.4, where $f_α$ = alpha energy deposited/hot-spot energy at bang time, and the hot-spot burnup fraction is approximately 2%. We show that the definition of ignition is not sensitive to the alpha-particle stopping power nor asymmetries provided that the absorbed fraction of alpha particles $θ_α$ is correctly accounted for. Finally, we use the results of 2-D simulations to show that even when $θ_α$ is small and unknown (as is true in hot spots with mid modes that have significant leakage of alpha particles into the surrounding cold bubbles), one can still relate the experimentally measureable parameter $\chi^{53}_α$ to the yield amplification and the burning-plasma parameter $Q^{\text{hs}}_α$ = alpha energy deposited/total input work delivered to the hot spot

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2020

First candidates for $γ$ vibrational bands built on the [ 505 ] 11 / 2 - neutron orbital in odd- A Dy isotopes

In this work, rotational structures have been measured using the Jurogam II and GAMMASPHERE arrays at low spin following the Gd 155 ( α , 2 n ) Dy 157 and Nd 148 ( C 12 , 5 n ) Dy 155 reactions at 25 and 65 MeV, respectively. We report high- K bands, which are conjectured to be the first candidates of a K π = 2 + γ vibrational band, built on the [ 505 ] 11 / 2 - neutron orbital, in both odd- A Dy 155 , 157 isotopes. The coupling of the first excited K = 0 + states or the so-called β vibrational bands at 661 and 676 keV in Dy 154 and Dy 156 to the [ 505 ] 11 / 2 - orbital, to produce a K π = 11 / 2 - band, was not observed in both Dy 155 and Dy 157 , respectively. The implication of these findings on the interpretation of the first excited 0 + states in the core nuclei Dy 154 and Dy 156 are also discussed.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
DOE OSTI2019

Advances of the FRIB project

The Facility for Rare Isotope Beams (FRIB) Project has entered the phase of beam commissioning starting from the room-temperature front end and the superconducting linac segment of first 15 cryomodules. With the newly commissioned helium refrigeration system supplying 4.5K liquid helium to the quarter-wave resonators and solenoids, the FRIB accelerator team achieved the sectional key performance parameters as designed ahead of schedule accelerating heavy ion beams above 20MeV/u energy. Thus, FRIB accelerator becomes world’s highest-energy heavy ion linear accelerator. We also validated machine protection and personnel protection systems that will be crucial to the next phase of commissioning. FRIB is on track towards a national user facility at the power frontier with a beam power two orders of magnitude higher than operating heavy ion facilities. Here, this paper summarizes the status of accelerator design, technology development, construction, commissioning as well as path to operations and upgrades.

43 PARTICLE ACCELERATORS↗
DOE OSTI2019

Tripled yield in direct-drive laser fusion through statistical modelling

Accurate predictive models are essential to the design of high-performance, laser-fusion experiments. Here, we report the development of a promising statistical approach that has been used to quantitatively predict and design several cryogenic deuterium-tritium (DT) implosions on the OMEGA Laser System, leading to the tripling of the fusion yield to its highest value for direct-drive laser fusion of DT-layered targets. When scaled to National Ignition Facility laser energies of 1.9 MJ, these targets are predicted to produce a fusion energy output of ~500 kJ—several times larger than current fusion yields achieved at that facility. Future applications of this approach will guide the exploration of the vast parameter space for the conditions required for thermonuclear ignition and expose gaps in our understanding of laser-fusion physics.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2019

Tripled yield in direct-drive laser fusion through statistical modelling [Tripling the yield in direct-drive laser fusion via predictive statistical modeling]

Focusing laser light onto a very small target can produce the conditions for laboratory-scale nuclear fusion of hydrogen isotopes. The lack of accurate predictive models, which are essential for the design of high-performance laser-fusion experiments, is a major obstacle to achieving thermonuclear ignition. Here we report a statistical approach that was used to design and quantitatively predict the results of implosions of solid deuterium–tritium targets carried out with the 30-kilojoule OMEGA laser system, leading to tripling of the fusion yield to its highest value so far for direct-drive laser fusion. When scaled to the laser energies of the National Ignition Facility (1.9 megajoules), these targets are predicted to produce a fusion energy output of about 500 kilojoules—several times larger than the fusion yields currently achieved at that facility. As a result, this approach could guide the exploration of the vast parameter space of thermonuclear ignition conditions and enhance our understanding of laser-fusion physics.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2018

Computation of the Seismic Stability of Earth Retaining Structures Final Report CRADA No. TSB-954-94

The purpose of this CRADA project was to evaluate the seismic stability of block retaining wall systems. Retaining wall systems are used extensively in private and commercial developments. This study was designed to develop and demonstrate a computer modeling technology to be used to predict the seismic stability of any block wall system design. The nonlinear finite element computer programs developed at LLNL and employed in the Computational Earthquake Initiative were utilized in this small business CRADA to analyze the seismic stability of the block retaining walls. The unique capability of the LLNL programs to rigorously model frictional contact in a dynamic analysis problem were used in a computer simulation of the dynamic interaction the block waiVsoil systems under seismic excitation.

58 GEOSCIENCES↗
DOE OSTI2017

THE MAYAK WORKER DOSIMETRY SYSTEM (MWDS-2013) FOR INTERNALLY DEPOSITED PLUTONIUM: AN OVERVIEW

The Mayak Worker Dosimetry System (MWDS-2013) is a system for interpreting measurement data from Mayak workers from both internal and external sources. This paper is concerned with the calculation of annual organ doses for Mayak workers exposed to plutonium aerosols, where the measurement data consists mainly of activity of plutonium in urine samples. The system utilises the latest biokinetic and dosimetric models, and unlike its predecessors, takes explicit account of uncertainties in both the measurement data and model parameters. The aim of this paper is to describe the complete MWDS-2013 system (including model parameter values and their uncertainties) and the methodology used (including all the relevant equations) and the assumptions made. Where necessary, supplementary papers which justify specific assumptions are cited.

Bayesian analysis' retrospective dosimetry↗
DOE OSTI2017

Investigation of negative-parity states in Dy 156 : Search for evidence of tetrahedral symmetry

An experiment populating low/medium-spin states in 156 Dy was performed to investigate the possibility of tetrahedral symmetry in this nucleus. In particular, focus was placed on the low-spin, negative-parity states since recent theoretical studies suggest that these may be good candidates for this high-rank symmetry. The states were produced in the 148 Nd ( 12 C , 4 n ) reaction and the Gammasphere array was utilized to detect the emitted γ rays. B ( E 2 ) / B ( E 1 ) ratios of transition probabilities from the low-spin, negative-parity bands were determined and used to interpret whether these structures are best associated with tetrahedral symmetry or, as previously assigned, to octupole vibrations. In addition, several other negative-parity structures were observed to higher spin and two new sequences were established.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗