Search NASA⌕ Search

Engineering topics

Miyamoto, M.

Publications and source records attributed to Miyamoto, M..

35 records · Page 2

Diffusive modification of primary zoning in olivine cores in Angrite LEW 87051

Angrite LEW 87051 consists of large olivine crystals set in a fine-grained groundmass that clearly represents a crystallized melt. A few olivines contain Ca-poor, Cr-rich cores that crystallized from a very different melt than the outer part of the crystals constituting the majority of olivine in LEW 87051. We evaluate a model in which the cores formed through fractional crystallization of one melt, then were incorporated into a different melt as xenocrysts, whereupon the original zoning patterns were modified by diffusion. Using a similar approach, we calculate zoning patterns for the cores that would result from perfect fractional crystallization, compare them with the observed zoning, and determine whether the differences could result from diffusive modification consistent with known diffusion rates for Ca, Mn, and Cr. Using distribution coefficients from the 1400 C, IW + 1 experiments, we computed CaO, Cr2O3, and MnO abundances in the hypothetical parent melt by inverting the olivine at the centers of the cores. We further assumed that the primary zoning profile for CaO is essentially unmodified, because the diffusion rate of Ca in olivine is slow. We carried out the fractional crystallization calculation until the calculated Ca content was that observed at break in zoning profiles at the outer edge of the core. We then normalized the distance of this calculated profile to the length of the observed profile in the olivine core and calculated profiles for MnO and Cr2O3. The CaO zoning profile agrees well with the observed profile. The observed MnO profile is slightly higher than the calculated profile near the edge. Diffusion calculations indicate that reversal of the general trend of primary zoning through diffusion would require that diffusion of Cr is 5-10x faster than that of Mn.

Mikouchi, T.↗

Inhomogeneous distribution of materials in lodranites-acapulcoites and IAB irons and their common formation processes

The two-dimensional chemical mapping analysis (CMA) techniques of EPMA and XRF were applied to a new polished thin section (PTS) of EET84302,28, Acapulco and a 5x3 cm slice of Caddo County to find heterogeneous regional distribution of low temperature fractions in the lodranite-acapulcoite groups and silicate inclusions in the IAB irons. A region richer in metal-plagioclase was found in EET84302,28 and Caddo County. The mineralogy of EET84302,28 is not much different from coarse-grained, metal-rich acapulcoite-like mineral assemblage in EET84302,19, which has chromite-orthopyroxene segregation. Nearly uniform Mg/Fe ratios of silicates modified by reduction at regional oxygen fugacity and large difference in modal abundances of minerals in this meteorite group can be explained by regional concentration of materials when the source materials were partly melted.

Takeda, Hiroshi↗

Partition coefficients for Al, Ca, Ti, Cr, and Ni in olivine obtained by melting experiment on an LL6 chondrite

We report the partition coefficients for Ca, Al, Ti, Cr, and Ni in olivine obtained through a series of melting experiments on an LL6 chondrite under varying conditions of temperature and oxygen fugacity. It is necessary to examine the variation of partition coefficients up to extremely reducing conditions in order to study meteoritic olivines. For Ca, Al, and Cr, the partition coefficients tend to decrease as temperature increases, but do not change even under extremely reducing conditions.

Miyamoto, M.↗

The Mn-Fe negative correlation in olivines in ALHA 77257 ureilite

An electron probe microanalyzer is used to measure the Mn, Fe, and oxygen zoning profiles of olivines in the ALHA 77257 ureilite. This is done to study the effects of reduction on the Mn-Fe value, as ureilite olivines exhibit thin reduced rims. Since the Mn content gradually increases toward the rim of ureilite olivines, while the Fa (= 100 x Fe/(Mg + Fe), mol percent) component decreases, the Mn-Fe content of olivine is likely related to redox conditions. The results of melting experiments suggest that the Mn-Fe positive correlation is related to temperature and that the negative correlation of Mn-Fe in olivine and low-Ca pyroxene is related to reduction.

Miyamoto, M.↗

More on the cooling history of angrite LEW 86010

Antarctic angrite LEW 86010 has many chemical and mineralogical characteristics which suggest it is closely related to Angra dos Reis (ADOR). However, these meteorites have had very different thermal histories. Olivines and pyroxenes in ADOR are nearly homogeneous, suggesting very slow cooling or extensive subsolidus equilibration. In contrast, LEW 86010 pyroxenes are extensively zoned in both major and trace elements, while olivines are nearly homogeneous, suggesting that cooling of this sample was slow enough to homogenize olivines, but too fast to homogenize pyroxenes. In an earlier study, we used Ca diffusion gradients associated with exsolution lamellae of kirsh-steinite in LEW 86010 olivines to estimate the cooling rate of this sample. We obtained cooling rates of a few x.01 deg C/yr, corresponding to a burial depth of approximately 10(exp 2) m under solid rock (thermal diffusivity = 0.004 sq cm/s), or approximately m under regolith material (10(exp -5) sq cm/s). Unfortunately, this calculation was very sensitive to the assumed temperature of initial exsolution, which we approximated from the estimated initial olivine bulk Ca content, and also to the extrapolated values for the Ca diffusion coefficient (D sub Ca). This abstract reports new cooling rate estimates obtained using a refined approach that includes the initial temperature of exsolution as one of the fitted parameters. The purpose of our new calculations is (1) to reduce uncertainties in cooling rate due to uncertainties in bulk olivine Ca content and initial exsolution temperature, (2) to investigate the effects of using different values for D sub Ca, and (3) to determine how well constrained the cooling rate is for any particular Ca diffusion coefficient.

Mckay, G.↗

The thickness of eucritic crust in the HED parent body

Because cumulate eucrites are generally thought to be located at the lower part in eucritic crust on a diogenitic mantle in the HED parent body, the burial depth of cumulate eucrites gives information on the thickness of the eucritic crust. We estimated the burial depth and cooling rate of cumulate eucrites, Serra de Mage and Moore County on the basis of the width of augite lamellae and compositional gradients of Ca in pyroxenes by numerically solving the diffusion equation. We obtained the burial depth of the eucrites of 7-8 km and cooling rate of 0.00016-0.0002 degrees C/yr.

Miyamoto, M.↗

Mineralogical comparison of the Y86032-type lunar meteorites to feldspathic fragmental breccia 67016

Mineralogical characteristics of lunar meteorites Y82193 and Y86032 were compared to those of Apollo-16 fieldspathic fragmental breccia 67016, using results from electron microprobe analysis and TEM. It was found that the pyroxene mineralogy and chemistry of granulitic clasts in 67016 breccia and the Y86032-type lunar meteorites were much alike, suggesting that the formation processes of the fieldspathic fragmental breccias are also important in the genesis of lunar meteorites. There were differences in matrix microtextures, however, implying that 67016 and Y86032-type breccia formation temperatures were different.

Takeda, H.↗

Mineralogy of a basaltic clast in lunar highland regolith breccia 60019

Mineralogy of a basaltic clast, Ba-2, found on the cut surface of a new slab of lunar highland regolith breccia 60019 was studied and compared with that of lunar meteorites ALHA81005 and Y791197. The coarse-grained Ba-2 clast consists of Na-bearing plagioclase, high-Ca clinopyroxene, ilmenite, silica, and mesostasis. The mineralogy and chemical zoning trends in the Ba-2 clast suggest that this basalt is similar to the 60639,1 basalt in the Apollo 16 rake samples, and to Luna 16 high-alumina moderate-TiO2 mare basalts; however, olivine is not present in Ba-2. On the basis of these and other findings, and assuming the early formation of the Apollo 16 regolith breccia (as proposed by McKay et al., 1986), it is suggested that B-2 could represent a post-Nectaris lava flow older than the formation of 60019.

Takeda, Hiroshi↗

Outgassing measurement of the aluminum alloy UHV chamber

A large vacuum chamber (580 mm diameter) was fabricated from an aluminum alloy surface treated by a special process normally used on small chambers. The chamber was tested unbaked and baked at various temperatures, pressures, and holding periods. The chamber was filled with N2 gas, and the outgassing rate was measured after one hour. Then the ultimate pressure was measured. Outgassing rates for baked and unbaked groups were compared. It is concluded that the same surface treatment technique can be used on both large and small chambers produced by the same special extrusion process.

Miyamoto, M.↗

Chemical zoning and homogenization of Pasamonte-type pyroxene and their bearing on thermal metamorphism of a howardite parent body

The Mg-Fe zoning of pyroxenes in Pasamonte and Juvinas eucrites is examined in order to gain a better understanding of the metamorphism in the surface layer of a eucrite/howardite parent body. Three distinct types of Ca-Mg-Fe zoning of Pasamonte pyroxenes are identified. The wide compositional range of the zoned pyroxenes suggests that Pasamonte is less metamorphosed than previously believed. It is also found that a Pasamonte-type pyroxene may yield a Juvinas-type pyroxene by thermal metamorphism. Calculations imply that the homogenization of Juvinas pyroxenes may have occurred during later reheating events rather than during initial cooling.

Miyamoto, M.↗

Mineralogical studies of lunar meteorites and their lunar analogs

The minerology and textural properties of three lunar meteorites (Yamato 791197, ALH81005, and Yamato 82192) were analyzed and compared with lunar surface rock samples. The chemical composition and textures of pyroxene and the occurrance of glass matrices were specifically addressed. The study of glass in the lunar meteorites suggests that the glass was not produced by a meteorite impact which excavated the mass into orbit towards the Earth. The glass had been devitrified on the lunar surface before the excavation, and new glass was not produced by the last impact.

Takeda, H.↗

Mineralogical comparison and cooling history of lunar and chondritic vesicular melt breccias

Lunar sample 77135, an impact melt breccia full of vesicles, has been reinvestigated by electron microprobe and X-ray diffraction techniques and compared with a vesicular melt LL chondrite, Yamato 790964, in an attempt to understand their impact heating processes and subsequent cooling history. Notable similarities between the lunar and chondritic melt breccias include: abundant vesicles, similar pyroxene chemical zoning trends, the presence of variable amounts of clastic material, and similar chemical compositions except for K and Na contents of glass and mesostasis. Some constraints on the cooling history are estimated from Mg-Fe diffusion profiles in olivine and pyroxene. The burial depth of lunar sample 77135 during cooling was 0.2-100 m; the depth for the chondrite was probably smaller. Impact melts were probably produced and a layer of regolith retained on the parent body sufficiently thick to allow the olivines to homogenize during slow cooling.

Miyamoto, M.↗

The Yamato-74659 ureilite and some new findings on the Yamato achondritic pyroxenes

A cube-like fragment with an approximately 4 mm edge was taken from the Yamato-74659 meteorite for the mineralogical and crystallographic examination discussed in the present paper. An analysis of powdered fragments by a standard wet chemical method showed that it matched to weathered ureilite. The chemical composition was found to differ from other ureilites in that the FeO content (8.83 wt%) is the lowest among known ureilites and it is richer in SiO2 contents (42.91 wt%).

Takeda, H.↗

Crystallization of pyroxenes in lunar KREEP basalt 15386 and meteoritic basalts

Single crystal X-ray diffraction studies and electron microprobe analyses of pyroxenes from the meteorites Pasamonte, Yamato 74450 and Yamato 74159 and in lunar KREEP basalt 15386 show similarities of pyroxene crystallization history. They each began crystallization with magnesian pyroxene (pigeonite in the meteorites, orthopyroxene in 15386) followed by strong zonation toward iron-rich and calcium-rich compositions. These data appear to be understandable in terms of dynamic crystallization experiments on liquids of similar composition to the meteorites. In contrast, pyroxene compositions in the meteorites Juvinas, Sioux County and Nuevo Laredo lie along an apparent tie line between calcium-poor and calcium-rich end members with no iron-enrichment trend. In Sioux County and Juvinas, the primary pyroxene is calcium-poor, with exsolved augite. In Nuevo Laredo, pigeonite and augite occur as separate grains with exsolution of augite in the pigeonite. The development of prominent exsolution lamellae is consistent with a long thermal annealing after the primary crystallization event, which may also explain the absence of iron/magnesium zonation in the pigeonites.

Takeda, H.↗

Characterization of crust formation on a parent body of achondrites and the moon by pyroxene crystallography and chemistry

Single crystal X-ray diffraction and electron microprobe techniques were used to study lunar crustal pyroxenes in a cataclastic norite, a pyroxene-rich clast, and anorthosite lunar samples, and also in meteorites including diogenites, eucrites, and the Yamoto (1) howardite. The crystallographic and chemical characteristics of pyroxenes in these materials are compared and are discussed in terms of the lower stability limit of pigeonite. A mechanical mixing model of howardite is proposed.

Takeda, H.↗

Relative cooling rates of mare basalts at the Apollo 12 and 15 sites as estimated from pyroxene exsolution data

X-ray single-crystal diffraction studies, supplemented by electron microprobe analyses of core pigeonites and rim augites from rocks 12031, 15085, 15475, and 15495, have been used to suggest cooling rates for these and other Apollo 12 and 15 rocks studied by similar methods. The extent of subsolidus phase separation of pyroxenes is used as a measure of the cooling rate. The results were interpreted in terms of model cooling histories of a lava flow whose thickness was estimated from the absolute cooling rates obtained by cooling rate experiments and by temperature-time variation through an extrusive flow computed by employing simplified theory of Jaeger. All available data on the exsolution and cation distributions of pyroxenes from Apollo 12 and 15 samples at present are consistent with the hypothesis that these rocks were derived from the top and interior of lava flows with thicknesses of 4-10 m. A process for exsolution of augite from a host pigeonite on (100) has been related to its low-calcium content.

Takeda, H.↗