Engineering topics

Moeller, C. P.

Publications and source records attributed to Moeller, C. P..

7 records

DOE OSTI2024

First high-power helicon results from DIII-D

Abstract More than 0.6 MW of rf power at 476 MHz has been coupled to DIII-D plasmas by launching helicon (whistler) waves with a traveling-wave antenna (comb-line) in the fast-wave polarization (Van Compernolle et al 2021 Nucl. Fusion 61 116034) which resulted in the observation of electron heating of the core plasma with single-pass absorption based on ray-tracing in L-mode discharges. The coupling performance of the 1.5 m wide 30-element comb-line traveling-wave antenna has been consistent with expectations based on the 2015–2016 experiments on DIII-D with a low-power 12-element prototype (Pinsker et al 2018 Nucl. Fusion 58 106007). The conditioning process that was necessary to carry out high-power experiments is discussed; rf-specific impurities have not been observed. Parametric decay instabilities have been observed and are being investigated as a potential edge absorption mechanism (Porkolab et al 2023 AIP Conf. Proc. 2984 070004).

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

A Pockels cell enabled heterodyne phase contrast imaging diagnostic for detection of ion cyclotron emission

This work describes a novel optical heterodyne detection scheme that significantly extends the frequency response of the phase contrast imaging method to detect electron density fluctuations in tens of megahertz frequency range. The system employs a variable frequency electro-optic modulator to allow operation at any frequency in the range 10–40 MHz without the need to realign the system. The frequency coverage of the system makes it suitable to measure the radial structure of the electron density component of ion cyclotron emission on devices having confining magnetic field of a few tesla, thus extending the purely temporal measurements provided so far by magnetic probes.

47 OTHER INSTRUMENTATION↗

DOE OSTI2022

Magnetron R&D Progress for High Efficiency CW RF Sources of Industrial Accelerators

After the demonstration of using high efficiency magnetron power to combine and aim to drive a radio frequency accelerator at 2450MHz in CW mode [1], we have used trim coils adding to a water-cooled magnetron and three amplitude modulation methods in an open-loop control to further suppress the 120Hz side-band noise to -46.7dBc level. We have also successfully demonstrated the phase-locking to an industrial grade cooking magnetron transmitter at 915MHz with a 75kW CW power delivered to a water load by using a -26.6dBc injection signal. The sideband noise at 360Hz from the 3-Phase SCRs DC power supply can be reduced to -16.2dBc level. Their power combing scheme and higher power application to industrial accelerators are foreseeing.

Wang, H.↗

DOE OSTI2022

Design of a finline antenna for current drive in TST-2

A novel “finline” antenna was designed to excite lower-hybrid waves (LHWs) for plasma current drive at 2.45 GHz in the TST-2 spherical tokamak. A periodic fin array acts as a transmission line for electromagnetic surface waves. Cold tests confirmed propagation of the electromagnetic surface wave on the fin array which was dominantly Transverse Magnetic (TM). Unlike the conventional waveguide array “grill” antenna, the finline antenna requires only two ports to feed all the elements, and calculations show that there is little reflection regardless of the plasma conditions in front of the antenna. Characteristics of the microwave transmission on the fin array were investigated using a three-dimensional full-wave simulation and the fin geometry was tuned to achieve the desired refractive index. Coupling to LHWs under typical TST-2 scrape-off layer conditions was confirmed by the simulation. Finally, to demonstrate LHW excitation, the finline antenna was energized in the presence of a plasma generated by another 200 MHz LH antenna. The x-ray radiation showed strong enhancement during the finline antenna pulse which indicated successful generation of fast electrons by LHWs.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2021

Modification of the magneto-hydrodynamic equilibrium by the lower-hybrid wave driven fast electrons on the TST-2 spherical tokamak

Presence of a large population of fast particles may qualitatively modify the tokamak equilibrium from the one that can be described by standard magneto-hydrodynamics (MHD). The kinetic modification of the MHD equilibrium was studied for a lower-hybrid (LH) wave driven plasma on the TST-2 spherical tokamak. The analysis was performed using an equilibrium reconstruction method based on an extended MHD model that considers a two-component plasma of bulk MHD fluid and kinetic fast electrons. Scrape-off-layer current appeared naturally in the extended MHD analysis because of the finite electron orbit excursion from the flux surfaces. This reduced the bulk pressure contribution to the toroidal current substantially. Furthermore, the resulting poloidal flux profile was more consistent with that inferred from the Thomson scattering measurement.

extended magneto-hydrodynamics↗

DOE OSTI2021

The high-power helicon program at DIII-D: gearing up for first experiments

Helicon current drive, also called fast wave current drive in the lower hybrid range of frequencies, has long been regarded as a promising current drive tool for reactor grade plasmas. A newly installed MW-level system at DIII-D will be the first test of this technology in reactor-relevant plasmas, in the sense that full single-pass absorption is expected. A 30-module traveling wave antenna has been installed and optimized in-vessel in early 2020. The linear electromagnetic characteristics of the unloaded module array have been extensively tested both on the bench and in the vessel at instrumentation power levels. Excellent performance has been achieved, ~2% reflected power and ~1.5% dissipated power per module in air, in a 10 MHz band around 476 MHz. Stripline feeds on both ends of the antenna allow either co or counter current drive. The installation of a 1.2 MW klystron and associated high-power electronics was completed in Fall 2020. Commissioning of the antenna is ongoing. An important goal of this experiment is to validate the helicon current drive physics basis using an extensive set of new and upgraded diagnostics.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2021

Magnetron R&D for high efficiency CW RF sources for industrial accelerators

The scheme of using high-efficiency magnetrons to drive radiofrequency accelerators has been demonstrated at 2450 MHz in CW mode *. Magnetron test stands at JLab and GA have been set up to further test the noise figure and the locking speed of the injection phase-lock method. For higher power applications, power combining experiments using a TM010 cavity-type combiner and a magic tee for the binary combiner while using a single clean injection signal has been carried out at 2450 MHz. The frequency pulling effect between the magnetron and a low-Q cavity has been shown to enhance the frequency locking bandwidth compared to the injection phase-lock alone. The principle has been studied by the equivalent circuit simulation, analytical model, and finally confirmed experimentally on the magnetrons. Due to the pandemic delay in 2020, the equivalent high power tests using a 75kW, 915MHz industrial magnetron will be done in 2021 and will be reported in a future paper.

Wang, H.↗