Search NASA⌕ Search

Engineering topics

Moerder, D. D.

Publications and source records attributed to Moerder, D. D..

18 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2008

Control Laws for a Dual-Spin Stabilized Platform

This paper describes two attitude control laws suitable for atmospheric flight vehicles with a steady angular momentum bias in the vehicle yaw axis. This bias is assumed to be provided by an internal flywheel, and is introduced to enhance roll and pitch stiffness. The first control law is based on Lyapunov stability theory, and stability proofs are given. The second control law, which assumes that the angular momentum bias is large, is based on a classical PID control. It is shown that the large yaw-axis bias requires that the PI feedback component on the roll and pitch angle errors be cross-fed. Both control laws are applied to a vehicle simulation in the presence of disturbances for several values of yaw-axis angular momentum bias. It is seen that both control laws provide a significant improvement in attitude performance when the bias is sufficiently large, but the nonlinear control law is also able to provide improved performance for a small value of bias. This is important because the smaller bias corresponds to a smaller requirement for mass to be dedicated to the flywheel.

Lim, K. B.↗
NASA NTRS2007

CMG-Augmented Control of a Hovering VTOL Platform

This paper describes how Control Moment Gyroscopes (CMGs) can be used for stability augmentation to a thrust vectoring system for a generic Vertical Take-Off and Landing platform. The response characteristics of the platform which uses only thrust vectoring and a second configuration which includes a single-gimbal CMG array are simulated and compared for hovering flight while subject to severe air turbulence. Simulation results demonstrate the effectiveness of a CMG array in its ability to significantly reduce the agility requirement on the thrust vectoring system. Albeit simplifying physical assumptions on a generic CMG configuration, the numerical results also suggest that reasonably sized CMGs will likely be sufficient for a small hovering vehicle.

Lim, K. B.↗
NASA NTRS2005

Bias Momentum Sizing for Hovering Dual-Spin Platforms

An atmospheric flight vehicle in hover is typically controlled by varying its thrust vector. Achieving both levitation and control with the propulsion system places considerable demands on it for agility and precision, particularly if the vehicle is statically unstable, or nearly so. These demands can be relaxed by introducing an appropriately sized angular momentum bias about the vehicle's yaw axis, thus providing an additional margin of attitude stability about the roll and pitch axes. This paper describes an approach for specifying the appropriate size of such angular momentum bias, based on the vehicle s physical parameters and its disturbance environment. It also describes several simplifications that provide a more physical and intuitive understanding of the dynamics. This will enhance the possibility of practically applying this technology to a flying vehicle.

Lim, K. B.↗
NASA NTRS2005

Attitude Control for an Aero-Vehicle Using Vector Thrusting and Variable Speed Control Moment Gyros

Stabilization of passively unstable thrust-levitated vehicles can require significant control inputs. Although thrust vectoring is a straightforward choice for realizing these inputs, this may lead to difficulties discussed in the paper. This paper examines supplementing thrust vectoring with Variable-Speed Control Moment Gyroscopes (VSCMGs). The paper describes how to allocate VSCMGs and the vectored thrust mechanism for attitude stabilization in frequency domain and also shows trade-off between vectored thrust and VSCMGs. Using an H2 control synthesis methodology in LMI optimization, a feedback control law is designed for a thrust-levitated research vehicle and is simulated with the full nonlinear model. It is demonstrated that VSCMGs can reduce the use of vectored thrust variation for stabilizing the hovering platform in the presence of strong wind gusts.

Shin, Jong-Yeob↗
NASA NTRS2004

A New Approach to Attitude Stability and Control for Low Airspeed Vehicles

This paper describes an approach for controlling the attitude of statically unstable thrust-levitated vehicles in hover or slow translation. The large thrust vector that characterizes such vehicles can be modulated to provide control forces and moments to the airframe, but such modulation is accompanied by significant unsteady flow effects. These effects are difficult to model, and can compromise the practical value of thrust vectoring in closed-loop attitude stability, even if the thrust vectoring machinery has sufficient bandwidth for stabilization. The stabilization approach described in this paper is based on using internal angular momentum transfer devices for stability, augmented by thrust vectoring for trim and other "outer loop" control functions. The three main components of this approach are: (1) a z-body axis angular momentum bias enhances static attitude stability, reducing the amount of control activity needed for stabilization, (2) optionally, gimbaled reaction wheels provide high-bandwidth control torques for additional stabilization, or agility, and (3) the resulting strongly coupled system dynamics are controlled by a multivariable controller. A flight test vehicle is described, and nonlinear simulation results are provided that demonstrate the efficiency of the approach.

Lim, K. B.↗
NASA NTRS2003

An Overview of the NASA Test Platform Research

A methodology for improving attitude stability and control for low-speed and hovering air vehicle is under development. In addition to aerodynamically induced control forces such as vector thrusting, the new approach exploits the use of bias momenta and torque actuators, similar to a class of spacecraft system, for its guidance and control needs. This approach will be validated on a free-flying research platform under development at NASA Langley Research Center. More broadly, this platform also serves as an in-house testbed for research in new technologies aimed at improving guidance and control of a Vertical Take-Off and Landing (VTOL) vehicle.

Lim, K. B.↗
NASA NTRS1986

Two time scale output feedback regulation for ill-conditioned systems

Issues pertaining to the well-posedness of a two time scale approach to the output feedback regulator design problem are examined. An approximate quadratic performance index which reflects a two time scale decomposition of the system dynamics is developed. It is shown that, under mild assumptions, minimization of this cost leads to feedback gains providing a second-order approximation of optimal full system performance. A simplified approach to two time scale feedback design is also developed, in which gains are separately calculated to stabilize the slow and fast subsystem models. By exploiting the notion of combined control and observation spillover suppression, conditions are derived assuring that these gains will stabilize the full-order system. A sequential numerical algorithm is described which obtains output feedback gains minimizing a broad class of performance indices, including the standard LQ case. It is shown that the algorithm converges to a local minimum under nonrestrictive assumptions. This procedure is adapted to and demonstrated for the two time scale design formulations.

Calise, A. J.↗
NASA NTRS1985

Piloted simulation of an algorithm for onboard control of time-optimal intercept

A piloted simulation of algorithms for onboard computation of trajectories for time-optimal intercept of a moving target by an F-8 aircraft is described. The algorithms, use singular perturbation techniques, generate commands in the cockpit. By centering the horizontal and vertical needles, the pilot flies an approximation to a time-optimal intercept trajectory. Example simulations are shown and statistical data on the pilot's performance when presented with different display and computation modes are described.

Price, D. B.↗
NASA NTRS1985

Optimal output feedback design of systems with ill-conditioned dynamics

Singular perturbation concepts are exploited to develop a procedure for designing a constant gain, output feedback control system. It is assumed that the original system is ill-conditioned in the sense that the plant contains widely separated dynamics, and that an accurate description for the high frequency behavior may not be available. The design procedure attempts to stabilize the system by minimizing a quadratic cost function made up of the control and states associated with a reduced order (low frequency) model for the plant, and a measure of stability for the neglected fast dynamics. The resulting design procedure does not require knowledge of the fast dynamics.

Calise, A. J.↗
NASA NTRS1985

Optimal generalized multistep integration formulae for real-time digital simulation

The problem of discretizing a dynamical system for real-time digital simulation is considered. Treating the system and its simulation as stochastic processes leads to a statistical characterization of simulator fidelity. A plant discretization procedure based on an efficient matrix generalization of explicit linear multistep discrete integration formulae is introduced, which minimizes a weighted sum of the mean squared steady-state and transient error between the system and simulator outputs.

Moerder, D. D.↗
NASA NTRS1985

Optimal digital real-time simulation

Issues affecting the fidelity of real-time digital simulation are discussed and a scalar measure of fidelity is derived which reflects the end-to-end dynamics of a given simulator. A class of explicit linear multistep discrete integration formulae are developed which are optimal with respect to the fidelity measure for a given simulation configuration. A computational algorithm is given for calculating the parameters associated with the optimal formulae.

Moerder, D. D.↗
NASA NTRS1984

Research on output feedback control of systems with ill-conditioned dynamics

The accuracy of a two time scale approach to the output feedback regulator design problem is examined. An approximate quadratic performance index which reflects a two time scale decomposition of the system dynamics is developed. A sequential numerical algorithm is defined which obtains output feedback gains minimizing a broad class of performance indices, including the standard LQ case. A procedure for optimally zeroing selected gain elements in an output feedback gain matrix is developed and demonstrated. A summary of conference and journal publications from this research is also provided.

Calise, A. J.↗
NASA NTRS1984

Two time scale stabilization of systems with output feedback

The problem of constant gain output feedback regulator design for linear systems with ill-conditioned dynamics is considered in the context of singular perturbation theory. A design approach is developed in which gains can be separately calculated to stabilize reduced-order slow and fast subsystem models. By employing the notion of combined control and observation spillover suppression, conditions are derived assuring that these gains will stabilize the full-order system, assuming sufficient frequency separation between the slow and fast subsystems. An LQ design procedure is described in which the spillover suppression conditions are satisfied by adjoining penalty functions to the subsystem performance indices. The theory is demonstrated in a controller design for a flexible space structure.

Moerder, D. D.↗
NASA NTRS1984

Two time scale design of output feedback systems

Singular perturbation techniques are used in this paper to develop a two time scale procedure for designing static gain output feedback controllers. It is shown that, if certain control spillover conditions are satisfied, control designs based on reduced-order models will stabilize the corrgsponding full system. Optimal output feedback control theory is used to derive the necessary conditions for the stabilizing gain matrix. The problem of stabilizing a model for a large space structure is used to illustrate the practicality of the approach.

Calise, A. J.↗
NASA NTRS1982

Singular perturbation techniques for real time aircraft trajectory optimization and control

The usefulness of singular perturbation methods for developing real time computer algorithms to control and optimize aircraft flight trajectories is examined. A minimum time intercept problem using F-8 aerodynamic and propulsion data is used as a baseline. This provides a framework within which issues relating to problem formulation, solution methodology and real time implementation are examined. Theoretical questions relating to separability of dynamics are addressed. With respect to implementation, situations leading to numerical singularities are identified, and procedures for dealing with them are outlined. Also, particular attention is given to identifying quantities that can be precomputed and stored, thus greatly reducing the on-board computational load. Numerical results are given to illustrate the minimum time algorithm, and the resulting flight paths. An estimate is given for execution time and storage requirements.

Calise, A. J.↗
NASA NTRS1981

Piloted simulation of an on-board trajectory optimization algorithm

This paper will describe a real time piloted simulation of algorithms designed for on-board computation of time-optimal intercept trajectories for an F-8 aircraft. The algorithms, which were derived using singular perturbation theory, generate commands that are displayed to the pilot on flight director needles on the 8-ball. By flying the airplane so as to zero the horizontal and vertical needles, the pilot flies an approximation to a time-optimal intercept trajectory. The various display and computation modes that are available will be described and results will be presented illustrating the performance of the algorithms with a pilot in the loop.

Price, D. B.↗