Engineering topics

Moore, B. C.

Publications and source records attributed to Moore, B. C..

4 records

NASA NTRS1982

Cryopump for large pulses of hydrogen

A test involving a flow of hot hydrazine decomposition products at a rate of 13.6 g/s (0.03 lb/s) established the requirement to maintain pressure in an 11.9-m-(39 ft) diameter space chamber below 200 microns. The flow, 2/3 hydrogen and 1/3 nitrogen by volume, continued for several periods ranging from 3 to 15 min. The pressure requirement was necessary to minimize thermal effects of the gas on the test vehicle but was well beyond the capability of the existing facility pumps. Various methods of obtaining additional temporary jump capacity were considered. From these, the slugged-charcoal approach was selected as the quickest and least expensive method to implement.

Moore, B. C.↗

NASA NTRS1980

Proposed method for degassing metals for extreme low pressures

Metal outgassing currently limits the pressures attained in vacuum chambers. The dominant residual gas in a carefully degassed metal system is usually hydrogen. The atomic hydrogen within bulk metals could be removed by diffusion processes if surface effects did not interfere. It is proposed that removing the surface hydrogen during vacuum bakeout by continuous electron bombardment (or similar irradiation) would allow the diffusion to proceed and lead to lower outgassing rates and operating pressures.

Moore, B. C.↗

NASA NTRS1979

Degassing procedure for ultrahigh vacuum

Calculations based on diffusion coefficients and degassing rates for stainless-steel vacuum chambers indicate that baking at lower temperatures for longer periods give lower ultimate pressures than rapid baking at high temperatures. Process could reduce pressures in chambers for particle accelerators, fusion reactors, material research, and other applications.

Moore, B. C.↗

NASA NTRS1972

Helium Leak Measurements Using CO2 as a Carrier

Detection delay defects are omitted by using helium mass spectrometer leak detector combined with several known procedures. Technique combines carbon dioxide purging, cryogenic separating helium accumulation, and use of carbon dioxide as carrier gas.

Moore, B. C.↗