Engineering topics

Morris, N.

Publications and source records attributed to Morris, N..

4 records

NASA NTRS1988

Shock tunnel studies of scramjet phenomena

Commissioning of the new T4 shock tunnel at the University of Queensland implied that it was no longer necessary to focus the work of the research group about an annual test series conducted in the T3 shock tunnel in Canberra. Therefore, it has been possible to organize a group for work to proceed along lines such that particular personnel are associated with particular project areas. The format of this report consists of a series of reports on specific project areas, with a brief general introduction commenting on each report. The introduction is structured by project areas, with the title of the relevant report stated under the project area heading. The reports themselves follow in the order of the project area headings.

Morgan, R. G.↗

NASA NTRS1987

Hydrogen scramjet with sidewall injection - Shock tunnel simulations

A free-piston shock tunnel has been used to obtain test data on a scramjet combustion chamber with sidewall injection. The results obtained indicate that combustion was strongly influenced by a region of fuel whose temperature was held below its ignition temperature by wall-cooling effects; this increased the fraction of unburned fuel and resulted in a significant loss of specific impulse. Aerodynamic heating would keep the walls above hydrogen ignition temperature in an actual scramjet powerplant, however. Maximum specific impulse was obtained with a combination of parallel and transverse injection in a long combustion chamber, followed by a dual stage expansion.

Morgan, R. G.↗

NASA NTRS1986

Hydrogen scramjet with side wall injection

Preliminary results are presented from an experimental evaluation of a hydrogen-burning wall-injection scramjet engine, performed in the free-piston shock tunnel at the Australian National University. The advantages of scramjet propulsion for high-Mach-number high-altitude flight are reviewed, and the need for an alternative to injection struts is indicated. Pressure profiles and heat-transfer measurements for constant-area and diverging ducts are presented graphically and characterized in detail. The ability of the injected flow to shield the chamber wall from the heat of the freestream flow is demonstrated. The extrapolation of the shock-tunnel results to flight conditions, however, is made difficult by the fact that a significant amount of fuel passes through a quenched zone without burning, seriously degrading overall performance.

Morgan, R. G.↗

NASA NTRS1985

Scramjet sidewall burning: Preliminary shock tunnel results

Experiments performed with a two dimensional model scramjet with particular emphasis on the effect of fuel injection from a wall are reported. Air low with a nominal Mach number of 3.5 and varied enthalpies was produced. It was found that neither hydrogen injection angle nor combustor divergence angle had any appreciable effect on thrust values while increased combustor length appeared to increase thrust levels. Specific impulse was observed to peak when hydrogen was injected at an equivalence ratio of about 2. Lowering the Mach number of the injected hydrogen at low equivalence ratios, less than 4, appeared to benefit specific impulse while hydrogen Mach number had little effect at higher equivalence ratios. When a 1:1 mixture by volume of nitrogen and oxygen is used instead of air as a test gas, it is found that hydrogen combustion is enhanced but only at high enthalpies.

Morgan, R. G.↗