Engineering topics

Morris, N. A.

Publications and source records attributed to Morris, N. A..

3 records

NASA NTRS1987

Silane as an ignition aid in scramjets

This paper presents the results of experiments on silane/hydrogen combustion in a scramjet model configured as a constant area duct with a central injector. Intake flow conditions were created by free piston shock tunnels with simulated flight speeds ranging between 1.4 and 4.2 km/s. Intake conditions were restricted to three nominal Mach numbers. Boundary layer heating appeared to be responsible for ignition at low temperature, high Mach number conditions. Concentration of silane in hydrogen was varied, as well as intake temperature and pressure. Results indicated that silane in concentrations as low as 2.5 percent in hydrogen, was effective as a fuel additive for scramjets at conditions where hydrogen alone could not support combustion. An unsteady effect was observed as the intake temperature approached the lower limit for combustion. The combustion temperature limit rose significantly as the intake pressure was reduced to low levels. Computer simulations using a one dimensional premixed analysis suggested that although silane enhanced the combustion process, it was strongly dependent on the initial concentration of free radical oxygen. Results from the simulations were comparable to experimental results for some conditions.

Morris, N. A.↗

NASA NTRS1987

High Reynolds number heat transfer to the cold walls of a model scramjet

The results of simultaneous heat transfer and pressure measurements at the walls of three different configurations of a model scramjet are presented. The heat transfer results are compared with results empirically predicted from the pressure measurements. It is shown that the measured heat transfer rate is comparable with, or lower than, that predicted for a laminar boundary layer. A mathematical model is proposed for the film-cooling effect observed when a hydrogen fuel is injected along a wall of the scramjet. In this mathematical model, the heat transfer rate is shown to be insensitive to the velocity profile in the insulating layer of fuel. The model suggests that the cooling layer is turbulent and that 90 percent of the fuel is mixed with the air.

Paull, A.↗

NASA NTRS1986

Further shock tunnel studies of scramjet phenomena

Scramjet phenomena were studied using the shock tunnel T3 at the Australian National University. Simple two dimensional models were used with a combination of wall and central injectors. Silane as an additive to hydrogen fuel was studied over a range of temperatures and pressures to evaluate its effect as an ignition aid. The film cooling effect of surface injected hydrogen was measured over a wide range of equivalence. Heat transfer measurements without injection were repeated to confirm previous indications of heating rates lower than simple flat plate predictions for laminar boundary layers in equilibrium flow. The previous results were reproduced and the discrepancies are discussed in terms of the model geometry and departures of the flow from equilibrium. In the thrust producing mode, attempts were made to increase specific impulse with wall injection. Some preliminary tests were also performed on shock induced ignition, to investigate the possibility in flight of injecting fuel upstream of the combustion chamber, where it could mix but not burn.

Morgan, R. G.↗