Search NASA⌕ Search

Engineering topics

Morris, S. J.

Publications and source records attributed to Morris, S. J..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1985

Orbit on demand - Will cost determine best design?

Eleven design concepts for vertical (V) and horizontal (H) take-off launch-on-demand manned orbital vehicles are discussed. Attention is given to up to three stages, Mach numbers (sub-, 2, or 3), expendable boosters, drop tanks (DT), and storable (S) or cryogenic fuels. All the concepts feature lifting bodies with circular cross-section and most have a 7 ft diam, 15 ft long payload bay as well as a crew compartment. Expendable elements impose higher costs and in some cases reduce all-azimuth launch capabilities. Single-stage vehicles simplify the logistics whether in H or V configuration. A two-stage H vehicle offers launch offset for the desired orbital plane before firing the rocket engines after take-off and subsonic acceleration. A two-stage fully reusable V form has the second lowest weight of the vehicles studied and an all-azimuth launch capability. Better definition of the prospective mission requirements is needed before choosing among the alternatives.

Macconochie, J. O.↗
NASA NTRS1981

Advanced turboprop cargo aircraft systems study

Parametric studies were conducted to define the effects of advanced propeller (propfan) characteristics on aircraft direct operating costs, fuel consumption, and noiseprints. Selected propfan aircraft realized 21-percent fuel savings and 15-percent lower DOCs relative to advanced turbofan aircraft. While both the propfan and turbofan aircraft satisfied current federal noise regulations, the propfan aircraft had smaller noiseprints at 90-EPNdB noise levels but larger noiseprints at lower noise levels. Several techniques for reducing the propfan aircraft noiseprints were explored; some of these contribute substantial reductions in noiseprint areas. Also, a propfan aircraft for the C-X role was studied.

Muehlbauer, J. C.↗
NASA NTRS1978

Computer Program for the Design and Off-Design Performance of Turbojet and Turbofan Engine Cycles

The rapid computer program is designed to be run in a stand-alone mode or operated within a larger program. The computation is based on a simplified one-dimensional gas turbine cycle. Each component in the engine is modeled thermo-dynamically. The component efficiencies used in the thermodynamic modeling are scaled for the off-design conditions from input design point values using empirical trends which are included in the computer code. The engine cycle program is capable of producing reasonable engine performance prediction with a minimum of computer execute time. The current computer execute time on the IBM 360/67 for one Mach number, one altitude, and one power setting is about 0.1 seconds. about 0.1 seconds. The principal assumption used in the calculation is that the compressor is operated along a line of maximum adiabatic efficiency on the compressor map. The fluid properties are computed for the combustion mixture, but dissociation is not included. The procedure included in the program is only for the combustion of JP-4, methane, or hydrogen.

Morris, S. J.↗
NASA NTRS1978

System optimization of gasdynamic lasers, computer program user's manual

The user's manual for a computer program that performs system optimization of gasdynamic lasers is provided. Detailed input/output formats are CDC 7600/6600 computers using a dialect of FORTRAN. Sample input/output data are provided to verify correct program operation along with a program listing.

Otten, L. J., III↗
NASA NTRS1976

Assessment of Variable-cycle Engines for Mach 2.7 Supersonic Transports

Three proposed SCAR propulsion systems in terms of aircraft range for a fixed payload and take-off gross weight with a design cruise Mach number 2.7 are evaluated. The effects of various noise and operational restraints are determined and sensitivities to some of the more important performance variables are presented for the most probable design noise and operational restraint case. Critical areas requiring new or improved technology for each cycle are delineated.

Morris, S. J.↗