Search NASA⌕ Search

Engineering topics

Moy, Matthew

Publications and source records attributed to Moy, Matthew.

Elucidating Structural Transition Dynamics in the Magnesium Cathode MgCr 2 O 4

Multivalent batteries, e.g., those based on magnesium (Mg), are promising candidates for next-generation energy storage due to their high volumetric energy densities and low cost. However, the corresponding ion migration and structural transition mechanisms are often linked and difficult to observe directly. Here, in this paper, we report the direct investigation of atomic transport pathways of cations in spinel magnesium chromate (MgCr 2 O 4 ) by using aberration-corrected scanning transmission electron microscopy (STEM). Cr atoms are directly observed to reversibly occupy the otherwise vacant octahedrally coordinated interstitial sites, passing through tetrahedral sites normally occupied by Mg. Furthermore, imaging and electron energy loss spectroscopy show that electron irradiation induces the formation of Mg and O vacancies, facilitating the migration of Cr and leading to an irreversible phase transition. These results demonstrate the ability of STEM to capture the pathway of deleterious point defects that can result in undesirable phase transitions.

25 ENERGY STORAGE↗

Cycling of block copolymer composites with lithium-conducting ceramic nanoparticles

Solid polymer and perovskite-type ceramic electrolytes have both shown promise in advancing solid-state lithium metal batteries. Despite their favorable interfacial stability against lithium metal, polymer electrolytes face issues due to their low ionic conductivity and poor mechanical strength. Highly conductive and mechanically robust ceramics, on the other hand, cannot physically remain in contact with redox-active particles that expand and contract during charge-discharge cycles unless excessive pressures are used. To overcome the disadvantages of each material, polymer-ceramic composites can be formed; however, depletion interactions will always lead to aggregation of the ceramic particles if a homopolymer above its melting temperature is used. In this study, we incorporate Li 0.33 La 0.56 TiO 3 (LLTO) nanoparticles into a block copolymer, polystyrene- b -poly (ethylene oxide) (SEO), to develop a polymer-composite electrolyte (SEO-LLTO). TEMs of the same nanoparticles in polyethylene oxide (PEO) show highly aggregated particles whereas a significant fraction of the nanoparticles are dispersed within the PEO-rich lamellae of the SEO-LLTO electrolyte. We use synchrotron hard x-ray microtomography to study the cell failure and interfacial stability of SEO-LLTO in cycled lithium-lithium symmetric cells. Three-dimensional tomograms reveal the formation of large globular lithium structures in the vicinity of the LLTO aggregates. Encasing the SEO-LLTO between layers of SEO to form a “sandwich” electrolyte, we prevent direct contact of LLTO with lithium metal, which allows for the passage of seven-fold higher current densities without signatures of lithium deposition around LLTO. We posit that eliminating particle clustering and direct contact of LLTO and lithium metal through dry processing techniques is crucial to enabling composite electrolytes.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗