Mueggenburg, H. H. | Search NASA

NASA NTRS1990

Formed platelet liner concept for regeneratively cooled chambers

A process for the fabrication of a formed platelet regeneratively cooled combustion chamber liner is described, and the benefits offered by the combustor liner are discussed. The advantages of using formed platelet combustor liners include a substantially increased cycle life and decreased coolant pressure drop in conjunction with low manufacturing costs. In the initial experiments, zirconium copper combustor liner sections with a hot gas wall thickness as small as 0.008 inch and channel aspect ratios of 15 have been achieved. It is also shown that HIP provides an excellent bonding technique for joining chamber liner panels.

Burkhardt, W. M.↗

NASA NTRS1990

A highly durable injector faceplate design concept for O2/H2 propellants

Two different O2/H2 injector faceplate designs were used in a test bed rocket engine at the NASA Lewis Research Center facility. This test bed was operated in a pulsing mode to evaluate thrust chamber wall materials and coatings. Degradation of the sintered mesh injector face plates resulted in the substitution of a photoetched diffusion-bonded platelet faceplate. This faceplate accumulated over 4200 thermal cycles without damage or degradation. Prior testing for a total of 17,446 cycles required 19 sintered mesh faceplates. This average of 918 cycles per unit showed the diffusion bonded faceplate to have a thermal cycle capability ranging from 150 to 500 percent of that of the sintered wire unit. The test data also showed that the diffusion-bonded faceplate provided a more uniform flow of gaseous H2 through its discrete and uniformly spaced propellant orifices resulting in enhanced face cooling (no local hot spots) and increased performance. The injector faceplate designs are described and the results of the injector comparison test data are presented.

Mueggenburg, H. H.↗