Engineering topics

Munaretto, S. (ORCID:0000000314650971)

Publications and source records attributed to Munaretto, S. (ORCID:0000000314650971).

6 records

DOE OSTI2024

First observation of RMP ELM mitigation on MAST Upgrade

Abstract The first experimental attempts at controlling edge localised modes (ELMs) via the application of resonant magnetic perturbations on the MAST Upgrade tokamak are reported. Using the linear MHD model MARS-F, the phase shift between the upper and lower coil rows ΔΦ was optimised for toroidal mode number n = 1 and n = 2 fields, to provide forward guidance to experiments. In low β N discharges, the application of n = 1 3D fields caused the ELM frequency f E L M to increase by over a factor 20 relative to the reference, and also induced a locked mode, which did not cause a plasma termination nor an H-L back transition. However when β N was raised, this induced locked mode caused plasma termination which precluded mitigation access. Initially, applying a numerically optimised n = 2 field had no effect. However applying a rigid toroidal shift to this field caused a locked mode disruption, demonstrating the presence of a substantial n = 2 error field. Coil current ramps were conducted with ΔΦ set at 6 different values, resulting in either locked mode disruptions or no effect, but mitigation with n = 2 fields was not established.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2024

NSTX-U research advancing the physics of spherical tokamaks

Abstract The objectives of NSTX-U research are to reinforce the advantages of STs while addressing the challenges. To extend confinement physics of low- A , high beta plasmas to lower collisionality levels, understanding of the transport mechanisms that set confinement performance and pedestal profiles is being advanced through gyrokinetic simulations, reduced model development, and comparison to NSTX experiment, as well as improved simulation of RF heating. To develop stable non-inductive scenarios needed for steady-state operation, various performance-limiting modes of instability were studied, including MHD, tearing modes, and energetic particle instabilities. Predictive tools were developed, covering disruptions, runaway electrons, equilibrium reconstruction, and control tools. To develop power and particle handling techniques to optimize plasma exhaust in high performance scenarios, innovative lithium-based solutions are being developed to handle the very high heat flux levels that the increased heating power and compact geometry of NSTX-U will produce, and will be seen in future STs. Predictive capabilities accounting for plasma phenomena, like edge harmonic oscillations, ELMs, and blobs, are being tested and improved. In these ways, NSTX-U researchers are advancing the physics understanding of ST plasmas to maximize the benefit that will be gained from further NSTX-U experiments and to increase confidence in projections to future devices.

74 ATOMIC AND MOLECULAR PHYSICS↗

DOE OSTI2024

Chasing the multi-modal plasma response in MAST-U

Abstract Achieving edge localized modes (ELMs) suppression in spherical tokamaks by applying resonant magnetic perturbations (RMPs) has proven challenging. The poloidal spectrum of the applied RMP is a key parameter that has an impact on the capability to mitigate and eventually suppress ELMs. In this work the resistive magnetohydrodynamic code MARS-F (Liu et al 2000 Phys. Plasmas 7 3681) is used to evaluate the possibility of directly measuring the plasma response in MAST-U, and particularly its variation as function of the applied poloidal spectrum, in order to guide the experimental validation of the predicted best RMP configuration for ELM suppression. Toroidal mode number n = 2 RMP is considered to minimize the presence of sidebands, and to avoid the deleterious core coupling of n = 1. Singular Value Decomposition is used to highlight linearly independent structures in the simulated magnetic 3D fields and how those structures can be measured at the wall where the magnetic sensors are located. Alternative ways to measure the multimodal plasma response and how they can be used to infer the best RMP configuration to achieve ELM suppression are also presented, including the plasma displacement and the 3D footprints at the divertor plates.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2024

Global micro-tearing modes in the wide pedestal of an NSTX plasma

Global linear electromagnetic gyrokinetic simulations of micro-tearing modes (MTMs) growing in the wide pedestal of the ELM-free NSTX discharge #132 588 are reported. Two micro-tearing branches growing near the surfaces of safety factor q = 4 (pedestal top) and q=5–6 (pedestal) are simulated. The frequencies of these MTMs with low toroidal mode number (n ranging from 3 to 6) are in agreement with the ones of quasi-coherent fluctuations present on the magnetic spectrogram. No kinetic ballooning mode (KBM) is observed at experimental values of β; instead, the experimental plasma lies 20% below the critical global KBM threshold. This confirms local simulation results stating that experimental NSTX profiles lie in the KBM stability region. Carbon impurities, which are abundant in this plasma, were found to play a significant role. Neglecting them leads to a ∼50% error in the growth rates.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2024

MHD stability of spherical tokamak equilibria with non-monotonic q-profiles

We use the 3D magnetohydrodynamic (MHD) code M3D-C1 [Jardin et al., Comput. Sci. Discovery 5, 014002 (2012)] to examine the MHD stability and subsequent evolution of NSTX shot 129169. This discharge had a period with a non-monotonic safety factor profile, q (reversed shear), which was terminated by a MHD event that abruptly lowered the central safety factor, q0, and greatly reduced the peakedness of the pressure profile. We show that the equilibrium just before the MHD event occurred was linearly unstable to many pressure-driven infernal modes. Modes with toroidal mode number n≥3 all had rational surfaces very close to the minimum value of q. However, a non-resonant pressure-driven (1, 1) mode was also present, and this dominated the nonlinear evolution. The final state in the simulation, after the MHD activity subsided, had a reduced and flattened pressure profile and a nearly monotonic q-profile, in qualitative agreement with experimental results. The initial state was also unstable to the resistive interchange criteria in the reversed-shear region, but the final state was stable everywhere. The “double tearing mode” (DTM) does not appear to play a role in the MHD activity of this discharge. In Appendix A, we show that in a torus, the DTM is strongly stabilized by pressure, but it is destabilized in cylindrical geometry (which has been the most extensively analyzed in the literature).

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2023

Real time detection of multiple stable MHD eigenmode growth rates towards kink/tearing modes avoidance in DIII-D tokamak plasmas

Abstract Real time detection of time evolving growth rates of multiple stable magnetohydrodynamic (MHD) eigenmodes has been achieved in DIII-D tokamak experiments via multi-mode three-dimensional (3D) active MHD spectroscopy. The measured evolution of the multi-modes’ growth rates is in good accordance with the variation of the plasma β N . Using experimental equilibria, resistive MARS-F simulations found the two least stable modes to have comparable growth rates to those experimentally measured. Real time and offline calculations of the modes’ growth rates show comparable results and indicate that cleaner system input and output signals will improve the accuracy of the real time stability detection. Moreover, the shortest real time updating time window of multi-mode eigenvalues can be about 2 ms in DIII-D experiments. This real time monitoring of stable, macroscopic kink and tearing modes thus provides an effective tool for avoidance of the most common causes of tokamak disruption.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗