Engineering topics
Publications and source records attributed to Murphy, R. M..
The performance and safety characteristics of the lithium BCX and lithium CSC battery system are discussed. A comparison is made between the two systems with respect to open circuit voltage, energy density, and operating temperature.
Smoke density studies on twelve cellulosic and five synthetic materials using the Arapahoe and NBS smoke chambers show an empirical relationship between smoke weight as per cent of initial weight in the Arapahoe test and maximum specific optical density under piloted conditions in the NBS test. The NBS optical density data under piloted conditions exhibited sensitivity to test artifacts such as type of pilot burner.
The toxicity of the pyrolysis gases from some samples of polyurethane flexible foams appears to have decreased with age, while other samples seem to exhibit no significant change with age in this respect. The changes observed were greater than could be accounted for by variations in the material, or test variations or artifacts.
A simple laboratory method for determining ignitability of materials is described. The apparatus consists of a Mellen high-flux heater capable of producing up to 13 W/sq cm heat flux, a Medtherm water-cooled radiometer for measuring heat flux, a mounting frame to hold all components in proper position, and specimen holders of the type used for the NBS smoke test. Time to ignition at different heat flux levels is recorded. Test results are presented for a variety of materials.
A variety of insulation and building materials were evaluated for ignitability, using a screening test method developed at the University of San Francisco. Ignitability tended to be greater with the more efficient insulation materials because the insulating qualities resulted in a more rapid rise in temperature at the exposed surface. The use of a noncombustible facing material is recommended to provide protection from surface ignition.
Twelve samples of rigid foam insulation were evaluated for flash-fire propensity, using the USF flash-fire screening test method. These materials exhibited little or no flash-fire propensity under these particular test conditions.