Engineering topics

Myers, Andrew T.

Publications and source records attributed to Myers, Andrew T..

3 records

DOE OSTI2024

Toward Polydisperse Flows With MFIX-EXA

In the presence of large size disparities, single-grid neighbor search algorithms lead to inflated neighbor lists that significantly degrade the performance of Lagrangian particle solvers. If Eulerian–Lagrangian (EL) frameworks are to remain performant when simulating realistic systems, improved neighbor detection approaches must be adopted. To this end, we consider the application of a multigrid neighbor search (MGNS) algorithm in the mfix-exa software package, an exascale EL solver built upon the AMReX library. Here, details regarding the implementation and verification of MGNS are provided along with speedup curves for a bidisperse mixing layer. MGNS is shown to yield up to 15$\times$ speedup on CPU and 6$\times$ speedup on GPU for the problems considered here. The mfix-exa software is then validated for a variety of polydisperse flows. Finally, a brief discussion is given for how dynamic MGNS may be completed, with application to spatially varying particle size distributions.

42 ENGINEERING↗

DOE OSTI2024

OpenFAST Modeling of the T-Omega Wind Floating Offshore Wind Turbine System

To reduce the cost of offshore wind energy through a more efficient design of the floating support structure, T-Omega Wind developed a novel lightweight and shallow-draft platform concept that aims to achieve a wave-following behavior without resonance amplification. The rotor and generator are carried by four tower legs with each leg supported by a shallow-draft float at the base. In preparation for a more detailed analysis, a coupled aero-hydro-elastic model of the proposed concept is developed in OpenFAST. The detailed modeling approach is presented, including a novel application of the SubDyn substructure dynamics module of OpenFAST to approximate the loads on the axle tube at the tower top from the rotor hub bearings. Preliminary results obtained with the OpenFAST model by rigidifying the substructure and blades indicate that the original sizing of the design can lead to large hub acceleration in the axial/surge and pitch directions due to platform-pitch motion. The high axial acceleration also potentially leads to large bending moments in the four tower legs. To address these issues, an updated design is developed with, among other changes, increased float spacing at the tower base and improved shear-transmitting geometry of the tower legs. The new design suggests significantly reduced extreme hub accelerations under the same conditions even with structural flexibility and will be further analyzed in the future through full aero-hydro-servo-elastic simulations.

FOWT↗

DOE OSTI2024

OpenFAST Modeling of the T-Omega Wind Floating Offshore Wind Turbine System: Preprint

To reduce the cost of offshore wind energy through a more efficient design of the floating support structure, T-Omega Wind developed a novel lightweight and shallow-draft platform concept that aims to achieve a wave-following behavior without resonance amplification. The rotor and generator are carried by four tower legs with each leg supported by a shallow-draft float at the base. In preparation for a more detailed analysis, a coupled aero-hydro-elastic model of the proposed concept is developed in OpenFAST. The detailed modeling approach is presented, including a novel application of the SubDyn substructure dynamics module of OpenFAST to approximate the loads on the axle tube at the tower top from the rotor hub bearings. Preliminary results obtained with the OpenFAST model by rigidifying the substructure and blades indicate that the original sizing of the design can lead to large hub acceleration in the axial/surge direction and in the pitch direction due to platform-pitch motion. The high hub acceleration also potentially leads to large bending moments in the four tower legs. To address the issue identified, an updated design is developed with, among other changes, increased float spacing at the tower base and improved geometry of the tower legs. The new design suggests significantly reduced extreme platform pitch angles under the same conditions and will be further analyzed in the future through full aero-hydro-servo-elastic simulations.

FOWT↗