Search NASA⌕ Search

Engineering topics

Na-Nakornpanom, Arthur

Publications and source records attributed to Na-Nakornpanom, Arthur.

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2017

Status of NASA’s Deep Space Optical Communication Technology Demonstration

With NASA funding, the Deep Space Optical Communication (DSOC) Project at JPL is planning a system level technology demonstration of optical communications from deep space. A 22 cm diameter flight laser transceiver (FLT) is being developed for space flight. The FLT will be designed to transmit an average laser power of 4W at 1550 nm and receive a weak 1064 nm laser signal (> 100 femtowatts). Use of the Hale telescope at Palomar Mountain, CA, retrofitted with a photoncounting receiver to detect the downlink from space, is planned. The Optical Communication Telescope Laboratory (OCTL) at Table Mountain, CA will transmit a 1064 nm laser beacon to serve as a pointing reference for the FLT and support low-rate uplink data-rates. The DSOC FLT is part of the baseline payload for the Psyche mission spacecraft recently selected for flight by NASA, providing link demonstration opportunities during the mission cruise phase. Link demonstration opportunities at distances of approximately 0.1 to 2 astronomical units (AU) are expected. The DSOC system is being designed to support downlink data-rates of 0.2 to > 200 Mb/s and uplink data rates of approximately 1.6 kb/s. A status update of DSOC Project activities on flight and ground development will be summarized in this paper.

Biswas, Abhijit↗
NASA NTRS2017

In-Flight Thermal Performance of the OCO-2 Instrument

The Orbiting Carbon Observatory-2 (OCO-2), launched on July 2, 2014, continues to operate nominally after successfully completing its primary mission of two years in space. It is hoped that, following a Senior Review and proposal phase, NASA will fund a two year extended mission, which would start in June 2017. The thermal design provides three temperature zones required by the instrument, specifically at 120 K, 267 K and 297 K. A single-stage pulse tube cryocooler provides refrigeration to three focal plane arrays to 120 K, via a high conductance flexible thermal strap. A variable conductance heat pipe (VCHP) based heat rejection system transports waste heat from the instrument, located inside the spacecraft, to the space-viewing radiators, providing tight temperature control of the spectrometer optics to 267 K, and maintains the electronics and cryocooler at 297 K. Soon after entering the A-Train on August 3, 2014, the optics and focal planes were cooled to their operating temperatures. Ice contamination of the cryogenic surfaces led to increased cryocooler loads and drove the need for two focal plane decontamination cycles between September 2014 and October 2014. A decrease in the radiometric gain of the O2 A-Band channel led to five additional focal plane decontamination cycles, between January 2015 and February 2017, and is now the primary driver of decontamination cycles. This paper provides a general overview of the thermal and cryogenic system design and reviews the inflight thermal performance for the mission.

Na-Nakornpanom, Arthur↗
NASA NTRS2012

In-Flight Performance of the TES Loop Heat Pipe Rejection System: Seven Years in Space

The Tropospheric Emission Spectrometer (TES) is an infrared, high spectral resolution Fourier transform spectrometer with a 3.3 to 15.4 micron wavelength coverage. TES is a scanning instrument intended for determining the chemical state of the Earth's lower atmosphere (troposphere) from the surface to 30+ km. TES produces vertical profiles of important pollutant and greenhouse gases such as carbon monoxide, ozone, methane, and water vapor on a global scale every other day. TES was launched into orbit onboard NASA's earth Observing System Aura spacecraft on July 15, 2004 from Vandenberg Air Force Base, California.

tropospheric emission spectrometer↗
NASA NTRS2012

In-Flight Performance of the TES Loop Heat Pipe Rejection System: Seven Years in Space

The Tropospheric Emission Spectrometer (TES) instrument heat rejection system has been operating in space for nearly 8 years since launched on NASA's EOS Aura Spacecraft. The instrument is an infrared imaging fourier transform spectrometer with spectral coverage of 3.2 to 15.4 microns. The loop heat pipe (LHP) based heat rejection system manages all of the instrument components waste heat including the two mechanical cryocoolers and their drive electronics. Five propylene LHPs collect and transport the instrument waste heat to the near room temperature nadir viewing radiators. During the early months of the mission, ice contamination of the cryogenic surfaces including the focal planes led to increased cryocooler loads and the need for periodic decontamination cycles. Focal plane decontamination cycles require power cycling both cryocoolers which also requires the two cryocooler LHPs to turn off and on during each cycle. To date, the cryocooler LHPs have undergone 24 start-ups in orbit successfully. This paper reports on the TES cryocooler loop heat pipe based heat rejection system performance. After a brief overview of the instrument thermal design, the paper presents detailed data on the highly successful space operation of the loop heat pipes since instrument turn-on in 2004. The data shows that the steady-state and transient operation of the LHPs has not changed since 2004 and shows consistent and predictable performance. The LHP based heat rejection system has provided a nearly constant heat rejection heat sink for all of its equipment which has led to exceptional overall instrument performance with world class science.

allowable flight temperature↗