Search NASA⌕ Search

Engineering topics

Nakamura, K.

Publications and source records attributed to Nakamura, K..

25 records · Page 2

Non-invasive assessment of otolith formation during development of the Japanese red-bellied newt, Cynops pyrrhogaster

Pre-mated adult female newts and embryos have been flown on the International Microgravity Laboratory-2 (IML-2) Space Shuttle flight in 1994 (Wiederhold et al., 1992b). With the specimens available from this flight, the calcification of otoliths, ulna, radius and backbone of the flown larvae and adult newts were analyzed. The experiments presented here studied the development of the otoliths on the ground. Otoliths of living newts, from embryo to adult, were observed in situ with the application of a new X-ray and bio-imaging analyzer system. For the establishment of this method, newts at different developmental stages were used. An imaging plate temporarily stores the X-ray energy pattern at the bio-imaging analyzer. A latent image on the imaging plate was transformed into a digital time series signal with an image reader. Acquired digital information was computed with the image processor. The processed information was recorded on film with an image recorder, in order to visualize it on an enlargement computed radiograph. To analyze development of the otoliths, photo-stimulated luminescence level was detected by an image analyzer, using transmitted X-ray photons. A single clump of otoconia could first be seen at stage 33. Stage-36 embryos first have distinguishable otoliths, with the utricle in front and saccule behind. Our results show that this X-ray method detects the otoliths equally as well as sectioning. In the newt, the mandibular/maxillary bone formed before the spine. It is suspected that for the newt embryo, living in water, feeding becomes necessary prior to support of the body.

NASA Discipline Neuroscience↗

Retrieval of precipitation profiles from airborne radar and passive radiometer measurements - Comparison with dual-frequency radar measurements

Precipitation-rate profiles derived from a single-frequency radar and a radiometer are compared with profiles derived from a dual-frequency radar, using data obtained during the 1985-1986 Communication Research Laboratory/NASA rain measuring experiment over the Atlantic Ocean from a dual-frequency X- and Ka-band radars and an X-band passive radiometer. Profiles were retrieved using a modification of the Hitschfeld-Bordan (1954) algorithm constrained by a measurement of the path integrated extinction derived from passive radiometry. It was found that the two techniques under comparison yielded average rainfall rates that agreed within about 25 percent. It is suggested that, while a single-frequency radar operating in conjunction with multifrequency passive radiometers might provide cost-effective spaceborne measurements of tropical rainfall distributions, a dual-frequency radar might be able to remove some ambiguities that were encountered in this study.

Weinman, J. A.↗

Experimental tests of methods for the measurement of rainfall rate using an airborne dual-wavelength radar

Several attenuation-based methods for estimating the rainfall rate were applied to measurements made by an airborne dual-wavelength radar operating at 0.87 cm, the K(a)-band, and at 3 cm, the X-band. These methods included the traditional Z-R methods, designated Z(X)-R and Z(K)-R for the X- and K(a) band wavelengths, respectively; single- and dual-wavelength surface reference techniques (SRT and DSRT, respectively); and standard dual-wavelength methods with and without range-averaging. As the primary sources of error for these methods are nearly independent, agreement among the rain rates obtained with these methods would lend confidence in the results. Correlation coefficients obtained between the rainfall rates with the Z(X)-R and DSRT methods were generally between 0.7 and 0.9. Good agreement among the methods occurred most often in stratiform rain for rain rates betwen a few mm/hr to about 15 mm/hr, i.e., where attenuation at the shorter wavelength is significant but not so severe as to result in a loss of signal.

Meneghini, R.↗

Experimental tests of range-profiling algorithms

The natural tendency in the design of a spaceborne weather radar is to select frequencies at 10 GHz or higher. A major disadvantage of this approach is that increased attenuation limits the maximum rain rate that can be accurately estimated. Here, a way to lessen this problem is suggested which uses estimates of path attenuation to reconstruct a profile of the rain rate.

Meneghini, R.↗

Comparison of rainfall profiles retrieved from dual-frequency radar and from combined radar and passive microwave radiometric measurements

Precipitation profiles retrieved from a dual frequency X- and Ka-band radar and from an X-band radiometer are analyzed. Profiles from combined radar and microwave radiometer measurements are compared to those from dual frequency radar measurements to study the performance of the combined radar-radiometer retrievals. A method for the retrieval of rainfall rate profiles from attenuated radar returns and passive radiometric data is presented. The results suggest that the operation of a single frequency radar with multifrequency passive radiometers may provide cost-effective spaceborne measurements of global tropical rainfall distributions. The possible use of this methodology for the Tropical Rainfall Measuring Mission is considered.

Weinman, J. A.↗

Interaction of metal layers with polycrystalline Si

Solid-phase reactions of metal films deposited on 0.5-micron-thick polycrystalline layers of Si grown by chemical vapor deposition at 640 C were investigated by MeV He-4 backscattering spectrometry, glancing angle X-ray diffraction, and SEM observations. For the metals Al, Ag, and Au, which form simple eutectics, heat treatment at temperatures below the eutectic results in erosion of the poly-Si layer and growth of Si crystallites in the metal film. Crystallite formation is observed at temperatures exceeding 550 C for Ag, at those exceeding 400 C for Al, and at those exceeding 200 C for Au films. For Pd, Ni, and Cr, heat treatment results in silicide formation. The same initial silicides (Pd2Si, Ni2Si, and CrSi2), are formed at similar temperatures on single-crystal substrates.

Nakamura, K.↗