Search NASA⌕ Search

Engineering topics

Nelson, H. D.

Publications and source records attributed to Nelson, H. D..

9 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

An active optimal control strategy of rotor vibrations using external forces

An active control strategy for lateral rotor vibrations using external forces is proposed. An extended state observer is used to reconstruct the full states and the unbalance distribution. An optimal controller which accommodates persistent unbalance excitation is derived with feedback of estimated states and unbalances. Numerical simulations were conducted for two separate four degree of freedom rotor systems. These simulations indicated that the proposed strategy can achieve almost complete vibration cancellation. This was shown to be true even when the number of external control forces was less than the system order so long as coordinate coupling was present. Both steady state and transient response at a constant speed are presented.

Zhu, W.↗
NASA NTRS1988

Periodic response of nonlinear systems

A procedure is developed to determine approximate periodic solutions of autonomous and non-autonomous systems. The trignometric collocation method (TCM) is formalized to allow for the analysis of relatively small order systems directly in physical coordinates. The TCM is extended to large order systems by utilizing modal analysis in a component mode synthesis strategy. The procedure was coded and verified by several check cases. Numerical results for two small order mechanical systems and one large order rotor dynamic system are presented. The method allows for the possibility of approximating periodic responses for large order forced and self-excited nonlinear systems.

Nataraj, C.↗
NASA NTRS1987

Optimal placement of critical speeds in rotor-bearing systems

The design of a rotor-bearing system is an iterative process in which the parameters that influence the design are modified until the desired design objectives are achieved. Primary among the design objectives is the minimization of the response amplitude within the operating range of the rotor system. An automated design procedure for the optimal placement of the critical speeds of a rotor is presented. The desired design objective is cast as a nonlinear programming problem that minimizes an objective function subject to constraints. The optimization program interacts with an analysis program to search for the feasible optimal design.

Rajan, M.↗
NASA NTRS1986

Parameter sensitivity in the dynamics of rotor-bearing systems

When designing a rotor system it is frequently desirable to have at hand a set of design sensitivity coefficients which quantitatively predict a change in specific system characteristics to changes in design parameters. This paper presents eigenvalue sensitivity coefficients for the damped natural frequencies of whirl of general linear rotor system modelled by finite element discretization. In addition, a simple and direct method for calculation of the damped critical speeds is presented, which utilizes the eigenvalue sensitivity with respect to the spin speed. It is shown that the combination of design parameter and spin speed whirl frequency sensitivity coefficients may be used to also evaluate the damped critical speed sensitivity coefficients.

Rajan, M.↗
NASA NTRS1985

Effect of coulomb spline on rotor dynamic response

A rigid rotor system coupled by a coulomb spline is modelled and analyzed by approximate analytical and numerical analytical methods. Expressions are derived for the variables of the resulting limit cycle and are shown to be quite accurate for a small departure from isotropy.

Nataraj, C.↗
NASA NTRS1985

Analyses of Multishaft Rotor-Bearing Response

Method works for linear and nonlinear systems. Finite-element-based computer program developed to analyze free and forced response of multishaft rotor-bearing systems. Acronym, ARDS, denotes Analysis of Rotor Dynamic Systems. Systems with nonlinear interconnection or support bearings or both analyzed by numerically integrating reduced set of coupledsystem equations. Linear systems analyzed in closed form for steady excitations and treated as equivalent to nonlinear systems for transient excitation. ARDS is FORTRAN program developed on an Amdahl 470 (similar to IBM 370).

Nelson, H. D.↗
NASA NTRS1984

A blade loss response spectrum for flexible rotor systems

A shock spectrum procedure is developed to estimate the peak displacement response of linear flexible rotor-bearing systems sugjected to a step change in unbalance (i.e., a blade loss). A progressive and a retrograde response spectrum are established. These blade loss response spectra are expressed in a unique non-dimensional form and are functions of the modal damping ratio and the ratio of rotor spin speed to modal damped whirl speed. Modal decomposition using complex modes is utilized to make use of the unique feature of the spectra for the calculation of the peak blade loss displacement response of the rotor system. The procedure is applied to three example systems using several modal superposition strategies. The results of each are compared to true peak displacement obtained by a separate transient response program.

Nelson, H. D.↗
NASA NTRS1982

Nonlinear analysis of rotor-bearing systems using component mode synthesis

The method of component mode synthesis is developed to determine the forced response of nonlinear, multishaft, rotor-bearing systems. The formulation allows for simulation of system response due to blade loss, distributed unbalance, base shock, maneuver loads, and specified fixed frame forces. The motion of each rotating component of the system is described by superposing constraint modes associated with boundary coordinates and constrained precessional modes associated with internal coordinates. The precessional modes are truncated for each component and the reduced component equations are assembled with the nonlinear supports and interconnections to form a set of nonlinear system equations of reduced order. These equations are then numerically integrated to obtain the system response. A computer program, which is presently restricted to single shaft systems, has been written and results are presented for transient system response associated with blade loss dynamics with squeeze film dampers, and with interference rubs.

Nelson, H. D.↗