Search NASA⌕ Search

Engineering topics

Newsom, Rob

Publications and source records attributed to Newsom, Rob.

At least 91 records · Page 5

dlacf.a1

This ingest reads and processes the autocovariance function raw data from the Halo Photonics StreamLine Dopplar lidar

54 ENVIRONMENTAL SCIENCES↗

Raman Lidar MERGE Value-Added Product

The U.S. Department of Energy (DOE) Atmospheric Radiation Measurement (ARM) Climate Research Facility Raman lidars (RLs) are semi-autonomous, land-based, laser remote sensing systems that provide height- and time-resolved measurements of water vapor mixing ratio, temperature, aerosol backscatter, extinction, and linear depolarization ratio from about 200 m to greater than 10 km AGL. These systems transmit at a wavelength of 355 nm with 300 mJ, ~5 ns pulses, and a pulse repetition frequency of 30 Hz. The receiver incorporates nine detection channels, including two water vapor channels at 408 nm, two nitrogen channels at 387 nm, three elastic channels, and two rotational Raman channels for temperature profiling at 354 and 353 nm. Figure 1 illustrates the layout of the ARM RL receiver system. Backscattered light from the atmosphere enters the telescope and is directed into the receiver system (i.e., aft optics). This signal is then split between a narrow-field-of-view radiometer (NFOV) path (blue) and a wide-field-of-view zenith radiometer (WFOV) path (red). The WFOV (2 mrad) path contains three channels (water vapor, nitrogen, and unpolarized elastic), and the NFOV (0.3 mrad) path contains six channels (water vapor, nitrogen, parallel and perpendicular elastic, and two rotational Raman). All nine detection channels use Electron Tubes 9954B photomultiplier tubes (PMTs). The signals from each of the nine PMTs are acquired using transient data recorders from Licel GbR (Berlin, Germany). The Licel data recorders provide simultaneous measurements of both analog photomultiplier current and photon counts at height resolution of 7.5 m and a time resolution of 10 s. The analog signal provides good linearity in the strong signal regime, but poor sensitivity at low signal levels. Conversely, the photo counting signal provides good sensitivity in the weak signal regime, but is strongly nonlinear at higher signal levels. The advantage in recording both signals is that they can be combined (or merged) into a single signal with improved dynamic range. The process of combining the analog and photon counting data has become known as “gluing” (Whiteman et al., 2006).

47 OTHER INSTRUMENTATION↗

Vertically Resolved Retrievals of Aerosol Concentrations and Effective Radii from the DOE Combined HSRL and Raman lidar Measurement Study (CHARMS) Merged High-Spectral-Resolution Lidar-Raman Lidar Data Set

The Department of Energy’s (DOE) Atmospheric Radiation Measurement (ARM) Climate Research Facility is a key component of DOE’s research strategy to address global climate change. The objective of the ARM Facility is to provide an experimental testbed for studying important atmospheric effects, particularly cloud and aerosol processes, and testing parameterizations of these processes for use in climate change models. ARM observational sites include a broad array of instruments to characterize cloud and aerosol properties, atmospheric state variables, and incoming and outgoing radiation. Advanced lidar systems provide valuable and unique information about the atmospheric column. We examine the potential for providing vertically resolved information about aerosol size and concentration with a combination of two such lidar systems, the Raman lidar and the High-Spectral-Resolution Lidar (HSRL). Currently ARM has a limited ability to remotely measure profiles of aerosol optical and microphysical properties on an operational basis. Although the Southern Great Plains (SGP), Eastern North Atlantic (ENA), and North Slope of Alaska (NSA, Oliktok Point location only) Raman lidars provide profiles of aerosol backscatter and extinction at 355 nm, additional information is required to better characterize the impacts of aerosols on radiation and clouds. Recent advances in lidar retrieval theory and algorithm development (Müller et al. 1999, 2014; Chemyakin et al. 2014) demonstrate that multi-wavelength lidar retrieval algorithms that use measurements of aerosol extinction at both 355 and 532 nm and backscatter at 355, 532, and 1064 nm have the potential to constrain both the aerosol optical (e.g., complex index of refraction, scattering, etc.) and microphysical properties (e.g., effective radius, concentration). This advancement greatly increases the utility of the remote-sensed aerosol observations. Based on this work, the HSRL group at the National Aeronautics and Space Administration (NASA)’s Langley Research Center (LaRC) developed automated algorithms for retrieving aerosol optical and microphysical properties, demonstrated these retrievals using data from the unique NASA/LaRC airborne multi-wavelength HSRL-2 system, and validated these retrievals using coincident airborne in situ data (Müller et al. 2014; Sawamura et al. 2017). We report here on the use of ARM instrumentation to gather a multi-wavelength ground-based lidar data set to test such retrievals. Continuous (24/7) operation of the co-located SGP Raman lidar and University of Wisconsin (UW) HSRL during the 10-week Combined HSRL and Raman lidar Measurement Study (CHARMS) (mid-July through September 2015) allowed the acquisition of a unique, multi-wavelength ground-based lidar data set. The ARM SGP Raman lidar (RLID) measured profiles of aerosol backscatter, extinction, and depolarization at 355 nm and profiles of water vapor mixing ratio and temperature. The UW HSRL simultaneously measured profiles of aerosol backscatter, extinction and depolarization at 532 nm and aerosol backscatter at 1064 nm. This RLID+HSRL combination provided a test data set to investigate these more advanced aerosol retrieval techniques with the potential to greatly improve aerosol characterization in the lower atmosphere.

54 ENVIRONMENTAL SCIENCES↗

Analysis of the Uncertainty in Wind Measurements from the Atmospheric Radiation Measurement Doppler Lidar during XPIA: Field Campaign Report

In March and April of 2015, the ARM Doppler lidar that was formerly operated at the Tropical Western Pacific site in Darwin, Australia (S/N 0710-08) was deployed to the Boulder Atmospheric Observatory (BAO) for the eXperimental Planetary boundary-layer Instrument Assessment (XPIA) field campaign. The goal of the XPIA field campaign was to investigate methods of using multiple Doppler lidars to obtain high-resolution three-dimensional measurements of winds and turbulence in the atmospheric boundary layer, and to characterize the uncertainties in these measurements. The ARM Doppler lidar was one of many Doppler lidar systems that participated in this study. During XPIA the 300-m tower at the BAO site was instrumented with well-calibrated sonic anemometers at six levels. These sonic anemometers provided highly accurate reference measurements against which the lidars could be compared. Thus, the deployment of the ARM Doppler lidar during XPIA offered a rare opportunity for the ARM program to characterize the uncertainties in their lidar wind measurements. Results of the lidar-tower comparison indicate that the lidar wind speed measurements are essentially unbiased (~1cm s-1), with a random error of approximately 50 cm s-1. Two methods of uncertainty estimation were tested. The first method was found to produce uncertainties that were too low. The second method produced estimates that were more accurate and better indicators of data quality. As of December 2015, the first method is being used by the ARM Doppler lidar wind value-added product (VAP). One outcome of this work will be to update this VAP to use the second method for uncertainty estimation.

Atmospheric boundary layer, lidar-derived wind spe↗

dlaux.a0

This is one of the output datastreams for Doppler Lidar ingest

54 ENVIRONMENTAL SCIENCES↗

dlusr

ARM Instrument: Doppler Lidar

54 ENVIRONMENTAL SCIENCES↗

dlrhi

ARM Instrument: Doppler Lidar

54 ENVIRONMENTAL SCIENCES↗

dl (00)

The Doppler lidar (DL) is an active remote-sensing instrument that provides range- and time-resolved measurements of the line-of-sight component of air velocity (i.e., radial velocity) and attenuated aerosol backscatter. The DL operates in the near-infrared and is sensitive to backscatter from atmospheric aerosol, which are assumed to be ideal tracers of atmospheric wind fields. The DL works by transmitting short pulses of infrared laser light into the atmosphere. Atmospheric aerosols scatter a small fraction of that light energy back to the transceiver, where it is collected and recorded as a time-resolved signal. From the delay between the outgoing pulse and the backscattered signal, the instrument infers the distance to the scattering volume. Coherent detection is used to measure the Doppler frequency shift of the backscatter signal. This is accomplished by mixing the backscatter signal with a reference laser beam (i.e., local oscillator) of known frequency. The onboard signal processor then determines the Doppler frequency shift from the spectrum of the mixed signal. The Doppler frequency shift and thus the radial air velocity is determined from the peak of the Doppler spectrum. The attenuated backscatter is determined from the energy content of the Doppler spectra. The DL provides accurate measurements of radial velocity in regions of the atmosphere where aerosol concentrations are high enough to ensure good signal-to-noise ratio. Thus, valid data are usually limited to the atmospheric boundary layer where aerosol is ubiquitous. Valid measurements can also be obtained in elevated aerosol layers or in optically thin clouds above the boundary layer. Most of the ARM DLs have full upper-hemispheric scanning capability, enabling 3D mapping of turbulent flows in the atmospheric boundary layer. With the scanner pointed vertically, the DL provides height- and time-resolved measurements of vertical velocity.

54 ENVIRONMENTAL SCIENCES↗

dlcal1

ARM Instrument: Doppler Lidar

54 ENVIRONMENTAL SCIENCES↗

dlppi

ARM Instrument: Doppler Lidar

54 ENVIRONMENTAL SCIENCES↗