Search NASA⌕ Search

Engineering topics

Ngai, Joseph

Publications and source records attributed to Ngai, Joseph.

Local rare-earth dopant structure in a complex-oxide/semiconductor heterojunction: Molecular beam epitaxy grown Yb-doped SrTiO3 on Si(001)

We have investigated the structural and electronic properties of Yb-doped SrTiO3/Si(001) grown by molecular beam epitaxy. Other rare-earth donor dopants that result in n-type conductivity typically substitute for Sr at the A-sites in the perovskite lattice. In contrast, Yb has been found to substitute predominantly for Ti at the perovskite B-sites based on data from atomically resolved scanning transmission electron microscopy and spectroscopy, as well as extended x-ray absorption fine structure. Yb exhibits two distinct charge states as determined by x-ray absorption spectroscopy and associated modeling, +2.7 and +2.1. These aliovalent substitutional dopants are compensated by donor electrons from oxygen vacancies that form during epitaxial film growth. An atom beam flux mismatch was present during film depositions because it was assumed that Yb would occupy A-sites, leading to a flux matching formula given by Yb + Sr = Ti. However, the formation of YbTi rather than YbSr results in Sr vacancies and extraneous (i.e. non-lattice) Ti atoms in the films, or on the film surfaces. The presence of these defects, together with oxygen vacancies, leads to deep-level electron traps that were detected by resonant photoemission and much higher sheet resistance than that associated with, for instance, La-doped films.

Chambers, Scott A. (ORCID:000000025415043X)↗

Handbook of Molecular Beam Epitaxy of Oxide Materials: Epitaxial Complex Oxide Growth on Semiconductors

This chapter covers the epitaxy of complex oxides on common inorganic semiconductors. The chapter opens with an introduction, motivating the subject and highlighting key general challenges (Section 6.1). We then proceed to describe the general steps of the growth procedure in Section 6.2, which concludes with an overall discussion about trade-offs and expectation management, with an emphasis on the oxide–semiconductor interface. From there, the text describes oxide growth on the common semiconductors, starting with silicon (Section 6.3), where surface reactions and oxidation are the most challenging aspects. Oxide epitaxy on germanium is described in Section 6.4, which is a less challenging oxide growth scheme on semiconductors. Section 6.5 describes oxide epitaxy on gallium arsenide, one of the more challenging schemes, where interface stability and surface preparation pose key challenges. Finally, in Section 6.6, oxide epitaxy on gallium nitride is described, where the lattice mismatch takes the stage as the key challenge. Altogether, this chapter aims to provide the reader with the practical knowledge, tactics and strategies for oxide epitaxy on semiconductors.

Demkov, Alexander A↗

Charge Transfer and Built-in Electric Fields between a Crystalline Oxide and Silicon

Built-in electric fields across heterojunctions between semiconducting materials underpin the functionality of modern device technologies. Heterojunctions between semiconductors and epitaxially grown crystalline oxides provide a rich setting in which built-in fields can be explored. Here, we present an electrical transport and hard X-ray photoelectron spectroscopy study of epitaxial SrNbxTi1-xO3-d / Si heterojunctions.

Lim, Zhenghui↗

Band-Gap Engineering at a Semiconductor-Crystalline Oxide Interface

The epitaxial growth of crystalline oxides on semiconductors provides a pathway to introduce new functionalities to semiconductor devices. Key to electrically coupling crystalline oxides with semiconductors to realize functional behavior is controlling the manner in which their bands align at interfaces. Here we apply principles of band gap engineering traditionally used at heterojunctions between conventional semiconductors to control the band offset between a single crystalline oxide and a semiconductor. Reactive molecular beam epitaxy is used to realize atomically abrupt and structurally coherent interfaces between SrZr x Ti 1-x O 3 and Ge, in which the band gap of the former is enhanced with Zr content x. We present structural, electrical and photoemission characterization of SrZr x Ti 1-x O 3 3-Ge heterojunctions for x = 0.2 to 0.75 and demonstrate the band offset can be tuned from type-II to type-I. The type-I band offset provides a platform to integrate the dielectric, ferroelectric and ferromagnetic functionalities of oxides with semiconducting devices.

42 ENGINEERING↗