Engineering topics

Nicaise, P. D.

Publications and source records attributed to Nicaise, P. D..

6 records

NASA NTRS1983

Space Station Attitude Control System Concept and Requirements

There is currently no single Space Station configuration which is accepted as a baseline. However, the latest approach is toward symmetry in both geometry and mass distribution. This minimizes aerodynamic and gravity gradient torques. Solar arrays and radiators drive the configuration strongly. One axis of the solar arrays needs to be perpendicular to the orbit plane, and the geometric and principal axis should remain common along this axis to minimize secular torques. The need for both inertial and earth-fixed modes drives the structure of the Station toward a disk-like shape in the orbital plane.

Nicaise, P. D.↗

NASA NTRS1975

Experiment Pointing Subsystems (EPS) requirements for Spacelab missions

The goal of the experiment pointing subsystems (EPS) is to accommodate a broad spectrum of instrument types by providing a number of stability and control functions that greatly exceed the capability of the shuttle. These functions include target acquisition, target tracking through wide gimbal ranges, stabilization, simultaneous pointing to one or more targets, instrument rastering, and on-orbit calibration. The experiments will vary widely in size, weight, geometry, and instrument types, and many have not been completely defined. This great diversity of requirements reflects the long term plans of the user community and establishes challenging performance requirements for the EPS.

Nein, M. E.↗

NASA NTRS1975

A miniaturized pointing mount for Spacelab missions

A Miniaturized Pointing Mount (MPM) for Spacelab missions is defined and simulation results are described. This mount is proposed to complement the Spacelab Instrument Pointing System (IPS). It uses the same mount isolator concept as the Spacelab IPS but is much more efficient and economical for the accommodation of small shuttle payloads. The MPM is built from star tracker assemblies left over from the Apollo Telescope Mount program thereby assuring low cost and development risk. Simulation results indicate a high level of instrument stability can be expected. The short development time of the MPM would permit it to serve as a precursor to the Spacelab IPS for verifying critical new concepts such as the mount isolation and hold down mechanisms.

Fritz, C. G.↗

NASA NTRS1974

An assessment of the Instrument Pointing Subsystems (IPS) requirements for spacelab missions

Instrument Pointing Subsystem requirements for Spacelab missions in solar physics, stellar astronomy, and earth observation are analyzed and design guidelines for fine pointing instrument platforms are presented. The requirements for the platforms are time-phased based on NASA projections of flight mission models and payload scheduling. The experiments used for these projections are to be viewed as representative payloads. Other experiments or experiment groupings within any one discipline may be accommodated by an Instrument Pointing Subsystem that meets these requirements.

Nein, M. E.↗

NASA NTRS1973

Simulation of an experiment pointing system for the space shuttle

The pointing and control of experiments during sortie missions are examined from the standpoint of accuracy and performance. The effect of gimbal characteristics, pallet stiffness, and variation in the servo control loop are described. Simulation results are shown for a number of pointing options under the disturbing influences of man motion, thruster firings, and experiment operations. One option of particular interest is the suspended pallet which offers the possibility of high accuracy pointing of very large payloads without using conventional gimbals. The pallet is suspended within the payload bay by nonrigid attachments such as springs, thereby isolating experiments from most shuttle disturbances. Control moment gyros apply torques directly to the pallet to maintain pointing accuracy within the arc second range. Spring torques constrain shuttle attitude so thruster operation is not required. The suspended pallet approach will meet the base stability requirements of any sortie experiment and offers the possibility of a standardized low weight, low cost alternative to gimbaled mounts.

Nicaise, P. D.↗

NASA NTRS1972

Experiment pointing control during space shuttle sortie missions

The pointing and stability problems of the space shuttle sortie mission are examined from the standpoint of basic shuttle capability and the techniques that could be used for improving this capability to accommodate a maximum number of experiments. Augmentation of the basic shuttle control system is proposed to provide an acceptable pointing environment. A stabilized reference base is recommended as a general pointing instrument for certain earth observation and astronomy experiments. Simulation results are presented which were obtained by modeling the Skylab Experiment Pointing Control (EPC) system on a thruster controlled shuttle.

Nicaise, P. D.↗