Engineering topics
Publications and source records attributed to Niklas, Jens.
One electron at a time, photosynthetic biohybrids enable charge accumulation via the flavin semiquinone of ferredoxin-NADP + reductase.
The development of general strategies for the electronic tuning of a catalyst’s active site is an ongoing challenge in heterogeneous catalysis. To this end, herein, we describe the application of Li-ion battery cathode and anode materials as redox non-innocent catalyst supports that can be continuously modulated as a function of lithium intercalation. A zero-valent nickel complex was oxidatively grafted onto the surface of lithium manganese oxide (Li x Mn 2 O 4 ) to yield isolated Ni2+ occupying the vacant interstitial octahedral site in the Li diffusion channel on the surface and subsurface of the spinel structure (Ni/Li x Mn 2 O 4 ). Additionally, the activity of Ni/Li x Mn 2 O 4 for olefin hydrogenation, as a representative probe reaction, was found to increase monotonically as a function of support reductive lithiation. Simulation of Ni/Li x Mn 2 O 4 reveals the dramatic impact of surface redox states on the viability of the homolytic oxidative addition mechanism for H 2 activation. Catalyst control through support lithiation was extended to an organotantalum complex on Li x TiO 2 , demonstrating the generality of this phenomenon.
Polymeric mixed ionic-electronic conductors (MIECs) are of broad interest in the field of energy storage and conversion, opto-electronics, and bioelectronics. A class of polymeric MIECs are conjugated polyelectrolytes (CPEs), which possess a p-conjugated backbone imparting electronic transport characteristics along with side chains comprised of a pendant ionic group to allow for ionic transport. Here, our study focuses on the humidity-dependent structure-transport properties of poly[3-(potassium-n-alkanoate) thiophene-2,5-diyl] (P3KnT) CPEs with varied side-chain lengths of n = 4, 5, 6, and 7. UV-Vis spectroscopy along with electronic paramagnetic resonance (EPR) spectroscopy reveal the infiltration of water leads to a hydrated, self-doped state that allows for electronic transport. The resulting humidity-dependent ionic conductivity (σ i ) of the thin films shows a monotonic increase with relative humidity (RH) while electronic conductivity (σ e ) follows a nonmonotonic profile. The values of σ e continue to rise with increasing RH reaching a local maximum after which σ e begins to decrease. P3KnTs with higher n values demonstrate greater resiliency to increasing RH before suffering decrease in σ e . This drop in σ e is attributed to two factors. First, disruption of the locally-ordered π-stacked domains observed through in situ humidity-dependent grazing incidence wide angle X-ray scattering (GIWAXS) experiments can account for some of the decrease in σ e . A second and more dominant factor is attributed to the swelling of the amorphous domains where electronic transport pathways connecting ordered domains are impeded. P3K7T is most resilient to swelling (based on ellipsometry and water uptake measurements) where sufficient hydration allows for high σ i (1.0 × 10 -1 S/cm at 95% RH) while not substantially disrupting σ e (1.7 × 10 -2 S/cm at 85% RH and 8.0 × 10 -3 S/cm at 95% RH). Overall, our study highlights the complexity of balancing electronic and ionic transport in hydrated CPEs.
The photoexcited triplet state of the “primary donors” in the two photosystems of oxygenic photosynthesis has been investigated by means of electron-nuclear double resonance (ENDOR) at Q-band (34 GHz). The data obtained represent the first set of 1 H hyperfine coupling tensors of the 3 P700 triplet state in PSI and expand the existing data set for 3 P680. We achieved an extensive assignment of the observed electron-nuclear hyperfine coupling constants (hfcs) corresponding to the methine α-protons and the methyl group β-protons of the chlorophyll (Chl) macrocycle. The data clearly confirm that in both photosystems the primary donor triplet is located on one specific monomeric Chl at cryogenic temperature. In comparison to previous transient ENDOR and pulse ENDOR experiments at standard X-band (9–10 GHz), the pulse Q-band ENDOR spectra demonstrate both improved signal-to-noise ratio and increased resolution. The observed ENDOR spectra for 3 P700 and 3 P680 differ in terms of the intensity loss of lines from specific methyl group protons, which is explained by hindered methyl group rotation produced by binding site effects. Contact analysis of the methyl groups in the PSI crystal structure in combination with the ENDOR analysis of 3 P700 suggests that the triplet is located on the Chl a' (P A ) in PSI. The results also provide additional evidence for the localization of 3 P680 on the accessory Chl D1 in PSII.
For billions of years, nature has optimized the photosynthetic machinery that converts light energy into chemical energy. Key primary reactions of photosynthesis occur in large membrane protein-cofactor complexes. The light-induced sequential electron transfer reactions occur through a chain of donor/acceptor cofactors embedded in the protein matrix resulting in a long-lived transmembrane charge-separated state. EPR is the method of choice to study electron transfer and the interaction of protein environment with redox-active cofactors. However, the spectra of organic cofactor radicals typically are not fully resolved and severely overlap at conventional X-band EPR. Even at Q-band EPR, this overlap is present and often a serious problem. As a result, there is a large variation of the reported EPR data and limited understanding of electronic structures of several redox-active cofactors. These serious problems can often be overcome by the excellent spectral resolution provided by high-frequency EPR (HF EPR). In this work, we study the electronic structure of the primary electron donor P 700 and the secondary electron acceptor A 1 of Photosystem I (PSI) using 130 GHz (D-band) EPR and Electron-Nuclear-Double-Resonance (ENDOR) spectroscopy. PSI was isotopically labeled with 15 N (I = $\frac{1/2}$) to avoid quadrupolar interactions in the most abundant nitrogen isotope 14 N (I = 1) and simplify the ENDOR spectra. ENDOR spectroscopy is central for determining the hyperfine coupling of nitrogen atoms of the two chlorophyll molecules comprising oxidized P 700 and the involvement of protein nitrogen atoms with reduced A 1 . While HF ENDOR of A 1 - allows identification of two nitrogen atoms, HF ENDOR of P 700 + still does not permit unique assignment of the recorded hyperfine couplings.
Molecular doping of conjugated polymers (CPs) plays a vital role in optimizing organic electronic and energy applications. For the case of organic thermoelectrics, it is commonly believed that doping CPs with a strong dopant could result in higher conductivity (σ) and thus better power factor (PF). Herein, by investigating thermoelectric performance of a polar side-chain bearing CP, poly(3- (methoxyethoxyethoxy)thiophene) (P3MEET), vapor doped with fluorinatedderivative of tetracyanoquinodimethane FnTCNQ (n = 1, 2, 4), we show that using strong dopants can in fact have detrimental effects on the thermoelectric performance of CPs. Despite possessing higher electron affinity, doping P3MEET with F4TCNQ only results in a σ (27.0 S/cm) comparable to samples doped with other two weaker dopants F2TCNQ and F1TCNQ (26.4 and 20.1 S/cm). Interestingly, F4TCNQ-doped samples display a marked reduction in the Seebeck coefficient (α) compared to F1TCNQ- and F2TCNQ-doped samples from 42 to 13 μV/ K, leading to an undesirable suppression of the PF. Additionally, structural characterizations coupled with Kang-Snyder modeling of the α–σ relation show that the reduction of α in F4TCNQ-doped P3MEET samples originates from the generation of low mobility carrier within P3MEET's amorphous domain. Our results demonstrate that factors such as dopant distribution and doping efficiency within the crystalline and amorphous domains of CPs should play a crucial role in advancing rational design for organic thermoelectrics.
Using aerobic oxidative coupling of thiophenol in organic media as a model reaction, we show that photogenerated holes in CdSe/CdS core–shell nanorods can be efficiently extracted. As a result, CdSe/CdS nanorods can serve as an efficient visible-light photocatalyst at a very low concentration (~1.5 × 10 -4 mol%). We show that primary amines play an important role in the transformation of thiols into disulfides by forming a soluble thiolate in nonpolar solvent. Using time-resolved optical spectroscopy and electron paramagnetic resonance spectroscopy, we show that thiolate can efficiently extract the photogenerated holes from CdSe/CdS nanorods and transform into disulfide in organic solvent. Overall, our data indicate that there are two reaction pathways responsible for S–S coupling of thiolate upon illumination of CdSe/CdS nanorods. We demonstrate that instead of scavenging of photogenerated holes by sacrificial species for prevention of photo corrosion of CdSe/CdS nanorods, the photogenerated holes can be efficiently used for oxidative organic synthesis.
Four new molecular Co(II)tetrapyridyl complexes were synthesized and evaluated for their activity as catalysts for proton reduction in aqueous environments. The pyridine groups around the macrocycle were substituted for either one or two pyrazine groups. Single crystal X-ray analysis shows that the pyrazine groups have minimal impact on the Co(II)–N bond lengths and molecular geometry in general. X-band EPR spectroscopy confirms the Co(II) oxidation state and the electronic environment of the Co(II) center are only very slightly perturbed by the substitution of pyrazine groups around the macrocycle. The substitution of pyrazine groups has a substantial impact on the observed metal- and ligand-centered reduction potentials as well as the overall H2 catalytic activity in a multimolecular system using the [Ru(2,2′-bipyridine)3]Cl2 photosensitizer and ascorbic acid as a sacrificial electron donor. The results reveal interesting trends between the H2 catalytic activity for each catalyst and the driving force for electron transfer between either the reduced photosensitizer to catalyst step or the catalyst to proton reduction step. The work presented here showcases how even the difference of a single atom in a molecular catalyst can have an important impact on activity and suggests a pathway to optimize the photocatalytic activity and stability of molecular systems.
Molecularly doped conjugated polymers with polar side chains are an emerging class of conducting materials exhibiting enhanced and thermally stable conductivity. In this work, we study the electronic conductivity (σ) and the corresponding thermal stability of two polythiophene derivatives comprising oligoethylene glycol side chains: one having oxygen attached to the thiophene ring (poly(3-(methoxyethoxyethoxy)thiophene) (P3MEET)) and the other having a methylene spacer between the oxygen and the thiophene ring (poly(3-(methoxyethoxyethoxymethyl)thiophene) (P3MEEMT)). Thin films were vapor-doped with fluorinated derivatives of tetracyanoquinodimethane (FnTCNQ, n = 4, 2, 1) to determine the role of dopant strength (electron affinity) in maximum achievable σ. Specifically, when vapor doping with F 4 TCNQ, P3MEET achieved a substantially higher σ of 37.1 ± 10.1 S/cm compared to a σ of 0.82 ± 0.06 S/cm for P3MEEMT. Structural characterization using a combination of X-ray and optical spectroscopy reveals that the higher degree of conformational order of polymer chains in the amorphous domain upon doping with F 4 TCNQ in P3MEET is a major contributing factor for the higher σ of P3MEET. Additionally, vapor-doped P3MEET exhibited superior thermal stability compared to P3MEEMT, highlighting that the presence of polar side chains alone does not ensure higher thermal stability. Molecular dynamics simulations indicate that the dopant–side-chain nonbond energy is lower in the P3MEET:F 4 TCNQ mixture, suggesting more favorable dopant–side-chain interaction, which is a factor in improving the thermal stability of a polymer/dopant pair. Our results reveal that additional factors such as polymer ionization energy and side-chain–dopant interaction should be taken into account for the design of thermally stable, highly conductive polymers.
Chemical functionalization-introduced sp 3 quantum defects in single-walled carbon nanotubes (SWCNTs) have shown compelling optical properties for their potential applications in quantum information science and bioimaging. Here, we utilize temperature- and power-dependent electron spin resonance measurements to study the fundamental spin properties of SWCNTs functionalized with well-controlled densities of sp 3 quantum defects. Signatures of isolated spins that are highly localized at the sp 3 defect sites are observed, which we further confirm with density functional theory calculations. Applying temperature-dependent line width analysis and power-saturation measurements, we estimate the spin–lattice relaxation time T 1 and spin dephasing time T 2 to be around 9 μs and 40 ns, respectively. Furthermore, these findings of the localized spin states that are associated with the sp 3 quantum defects not only deepen our understanding of the molecular structures of the quantum defects but could also have strong implications for their applications in quantum information science.
Abstract The storage of solar energy in chemical bonds will depend on pH‐universal catalysts that are not only impervious to acid, but actually thrive in it. Whereas other homogeneous water oxidation catalysts are less active in acid, we report a catalyst that maintained high electrocatalytic turnover frequency at pH values as low as 1.1 and 0.43 ( k cat =1501±608 s −1 and 831±254 s −1 , respectively). Moreover, current densities, related to catalytic reaction rates, ranged from 15 to 50 mA cm −2 mM −1 comparable to those reported for state‐of‐the‐art heterogeneous catalysts and 30 to 100 times greater than those measured for two prominent literature homogeneous catalysts at pH 1.1 and 0.43. The catalyst also exhibited excellent durability when a chemical oxidant was used (Ce IV , 7400 turnovers, TOF 0.88 s −1 ). Preliminary computational studies suggest that the unusual active‐site sulfonate group acts a proton relay even in strong acid, as intended.