Search NASA⌕ Search

Engineering topics

Nishiyama, Norimasa

Publications and source records attributed to Nishiyama, Norimasa.

Structure and properties of densified silica glass: characterizing the order within disorder

The broken symmetry in the atomic-scale ordering of glassy versus crystalline solids leads to a daunting challenge to provide suitable metrics for describing the order within disorder, especially on length scales beyond the nearest neighbor that are characterized by rich structural complexity. Here, we address this challenge for silica, a canonical network-forming glass, by using hot versus cold compression to (i) systematically increase the structural ordering after densification and (ii) prepare two glasses with the same high-density but contrasting structures. The structure was measured by high-energy X-ray and neutron diffraction, and atomistic models were generated that reproduce the experimental results. The vibrational and thermodynamic properties of the glasses were probed by using inelastic neutron scattering and calorimetry, respectively. Traditional measures of amorphous structures show relatively subtle changes upon compacting the glass. The method of persistent homology identifies, however, distinct features in the network topology that change as the initially open structure of the glass is collapsed. The results for the same high-density glasses show that the nature of structural disorder does impact the heat capacity and boson peak in the low-frequency dynamical spectra. Densification is discussed in terms of the loss of locally favored tetrahedral structures comprising oxygen-decorated SiSi 4<:sub> tetrahedra.

36 MATERIALS SCIENCE↗

Picosecond amorphization of SiO 2 stishovite under tension

It is extremely difficult to realize two conflicting properties—high hardness and toughness—in one material. Nano-polycrystalline stishovite, recently synthesized from Earth-abundant silica glass, proved to be a super-hard, ultra-tough material, which could provide sustainable supply of high-performance ceramics. Our quantum molecular dynamics simulations show that stishovite amorphizes rapidly on the order of picosecond under tension in front of a crack tip. We find a displacive amorphization mechanism that only involves short-distance collective motions of atoms, thereby facilitating the rapid transformation. The two-step amorphization pathway involves an intermediate state akin to experimentally suggested “high-density glass polymorphs” before eventually transforming to normal glass. The rapid amorphization can catch up with, screen, and self-heal a fast-moving crack. This new concept of fast amorphization toughening likely operates in other pressure-synthesized hard solids.

36 MATERIALS SCIENCE↗

A combination of a Drickamer anvil apparatus and monochromatic X-rays for stress and strain measurements under high pressure

A modified Drickamer anvil apparatus has been developed to combine with monochromatic synchrotron radiation for high-pressure X-ray diffraction and radiography in the GSECARS bending-magnet station, 13-BM-D, at the Advanced Photon Source, Argonne, USA. Using this experimental set-up, deformation experiments can be carried out at pressures in excess of 30 GPa at high temperatures. Differential stresses and total axial strains of polycrystalline platinum and Mg{sub 2}SiO{sub 4} ringwoodite have been measured up to 32 GPa at room temperature using tungsten carbide anvils. The total axial strain of the platinum increases with pressure and reaches about 55% at the highest pressure. A test run using a composite sintered diamond anvil system was performed. The use of X-ray-tranparent anvils enables the entire Debye rings to be observed up to 10{sup o} 2{theta}. With high-energy photons (65-70 keV), this allows a coverage in Q (= 2{pi} sin{theta}/{lambda}) to about 3 {angstrom}{sup -1}, thus making it possible to evaluate hydrostatic pressure and differential stress in crystalline minerals using diffraction. This, coupled with the ability to determine axial strain, allows deformation studies to be performed to pressures above 30 GPa.

43 PARTICLE ACCELERATORS↗

The large-volume high-pressure facility at GSECARS: A 'Swiss-army-knife' approach to synchrotron-based experimental studies

A number of new techniques have been developed at the large-volume press (LVP) high-pressure facility at the GeoSoilEnviroCARS (GSECARS) sector of the advanced photon source (APS). This article describes the 10 MN (1000 T) and 2.5 MN (250 T) hydraulic presses in the insertion device (ID) and bending magnet (BM) beamlines, respectively, with several apparatus and various diffraction and imaging techniques developed since the inception of the facility. Several Kawai-type high-pressure modules, whose second-stage anvils range from 10 mm to 25.4 mm in edge lengths, are used in the hydraulic presses, with pressure (P) and temperature (T) capabilities up to 30 GPa and 3000 K. A DIA-type apparatus can be compressed in both presses for studies requiring large sample volumes. A deformation DIA (D-DIA) has been developed to allow controlled deformation studies on both crystalline and glass materials, using monochromatic diffraction and imaging, up to 20 GPa and 1800 K. A high-pressure tomography apparatus is available for conducting tomography studies at high P and T, with a typical spatial resolution of a few micrometers. Toroidal anvil modules provide large 2{theta} angles for studies of non-crystalline materials, and a new large D-DIA module is under construction for double-stage megabar pressure generation as well as deformation on large samples with the capability of acoustic emission detection. The flexible design of the monochromator at the BM beamline makes it feasible to switch between monochromatic and white-beam mode during an experiment, ideal for monochromatic imaging studies (e.g., high-P tomography) with energy-dispersive diffraction for pressure measurements. A new angle-dispersive diffraction technique has been developed for high P-T crystallography studies, where a solid-state detector is step-scanned, thereby collecting a large number of angle-dispersive spectra over a wide range of photon energies recorded in the multi-channel analyzer. An ultrasonic interferometer is available and has been used in several high-pressure modules for acoustic velocity measurements. These unique features allow world-wide users to select the best experimental techniques for tackling a wide range of problems relevant to earth and planetary science, materials science, physics, and chemistry. Scientific highlights are provided and future improvements and prospects are discussed.

43 PARTICLE ACCELERATORS↗

Deformation and texture development in CaIrO[subscript 3] post-perovskite

At near ambient conditions, CaIrO{sub 3} is isostructural with the high-pressure polymorph MgSiO{sub 3} 'post-perovskite' (pPv). MgSiO{sub 3} pPv is thought to be a major phase in the earth's lowermost mantle. CaIrO{sub 3} can thus serve as an analog for studying deformation of the pPv phase under conditions achievable with a multi-anvil deformation apparatus. Here we study the rheologic behavior of CaIrO{sub 3} pPv at a variety of pressure and temperature conditions from 2 GPa to 6 GPa and 300 K to 1300 K and various strain rates. Sintered, polycrystalline CaIrO{sub 3} pPv, cylindrical in shape, was deformed in the D-DIA multi-anvil press in several shortening cycles up to 20% axial strain at each temperature and pressure. Shortening cycles were followed by lengthening back to 0% strain. Quantitative texture information was obtained using in-situ synchrotron X-ray diffraction and the Rietveld method to analyze images. In all cases we find that (010) lattice planes align perpendicular to the compression direction upon shortening, and that there is little change in texture with temperature or pressure. This texture pattern is consistent with slip on (010)[100]. The texture observed here is different from that produced in room temperature diamond anvil cell (DAC) experiments on MgGeO{sub 3} and MgSiO{sub 3} pPv which both display textures of (100) and {l_brace}110{r_brace} lattice planes at high angles to the compression direction. This implies that CaIrO{sub 3} pPv may not be a good analog for the plastic behavior of MgSiO{sub 3} pPv.

58 GEOSCIENCES↗