Search NASA⌕ Search

Engineering topics

Norman W Schaeffler

Publications and source records attributed to Norman W Schaeffler.

4 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2020

Hover Validation and Acoustic Baseline Blade Set

The Hover Validation and Acoustic Baseline (HVAB) blade set has been jointly developed by the U.S. Army Combat Capabilities Development Command Aviation & Missile Center (CCDC AvMC) and the NASA Revolutionary Vertical Lift Technology (RVLT) Project. This Mach-scale, 66.50 in radius, blade set will ultimately be tested in both hover and forward-flight to provide key data for analysis validation. This paper provides comprehensive detail of the blade geometry, instrumentation, and structure for use in future analyses.

Hover,Rotor,Helicopter,Aerodynamics,HVAB,PSP,AIAA ↗
NASA NTRSDate not supplied

A Separation Control CFD Validation Test Case: Baseline and Steady Suction - Part 1

Low speed flow separation over a wall-mounted hump, and its control using steady suction, were studied experimentally in order to generate a data set for a workshop aimed at validating CFD turbulence models. The baseline and controlled data sets comprised static and dynamic surface pressure measurements, flow field measurements using Particle Image Velocimetry (PIV) and wall shear stress obtained via oil-film interferometry. In addition to the specific test cases studied, surface pressures for a wide variety of conditions were reported for different Reynolds numbers and suction rates. Stereoscopic PIV and oil-film flow visualization indicated that the baseline separated flow field was mainly two- dimensional. With the application of control, some three-dimensionality was evident in the spanwise variation of pressure recovery, reattachment location and spanwise pressure fluctuations. Part 2 of this paper, under preparation for the AIAA Meeting in Reno 2005, considers separation control by means of zero-efflux oscillatory blowing.

David Greenblatt↗
NASA NTRSDate not supplied

Fundamental Test of a Hovering Rotor: Comprehensive Measurements for CFD Validation

A model-scale hover test of a 4-bladed, 11.08-ft diameter rotor was recently completed inside the National Full-Scale Aerodynamics Complex 80- by 120-Foot Wind Tunnel test section. The primary objective of the test was to acquire key experimental data for a hovering rotor of sufficient quality and quantity to allow validation of state-of-the-art analysis codes. A comprehensive measurement set has been acquired, including rotor performance, blade airloads, flow transition locations, blade deflections, and wake geometry for a range of tip Mach numbers and collective settings. The present paper provides an overview of the test, including detailed descriptions of the hardware, instrumentation, and measurement systems. In addition, the specific test objectives, approach, and sample results are presented. The full test database, as well as detailed rotor geometry information, will ultimately be shared openly on a NASA-sponsored website to serve as a benchmark validation dataset.

Hover↗