Search NASA⌕ Search

Engineering topics

Norman, J. M.

Publications and source records attributed to Norman, J. M..

Directional infrared temperature and emissivity of vegetation: Measurements and models

Directional thermal radiance from vegetation depends on many factors, including the architecture of the plant canopy, thermal irradiance, emissivity of the foliage and soil, view angle, slope, and the kinetic temperature distribution within the vegetation-soil system. A one dimensional model, which includes the influence of topography, indicates that thermal emissivity of vegetation canopies may remain constant with view angle, or emissivity may increase or decrease as view angle from nadir increases. Typically, variations of emissivity with view angle are less than 0.01. As view angle increases away from nadir, directional infrared canopy temperature usually decreases but may remain nearly constant or even increase. Variations in directional temperature with view angle may be 5C or more. Model predictions of directional emissivity are compared with field measurements in corn canopies and over a bare soil using a method that requires two infrared thermometers, one sensitive to the 8 to 14 micrometer wavelength band and a second to the 14 to 22 micrometer band. After correction for CO2 absorption by the atmosphere, a directional canopy emissivity can be obtained as a function of view angle in the 8 to 14 micrometer band to an accuracy of about 0.005. Modeled and measured canopy emissivities for corn varied slightly with view angle (0.990 at nadir and 0.982 at 75 deg view zenith angle) and did not appear to vary significantly with view angle for the bare soil. Canopy emissivity is generally nearer to unity than leaf emissivity may vary by 0.02 with wavelength even though leaf emissivity. High spectral resolution, canopy thermal emissivity may vary by 0.02 with wavelength even though leaf emissivity may vary by 0.07. The one dimensional model provides reasonably accurate predictions of infrared temperature and can be used to study the dependence of infrared temperature on various plant, soil, and environmental factors.

Norman, J. M.↗

Leaf gas exchange of Andropogon gerardii Vitman, Panicum virgatum L., and Sorghastrum nutans (L.) Nash in a tallgrass prairie

Net CO2 assimilation as a function of internal CO2 and stomatal conductance to water vapor were measured on blades of the C4 grasses Andropogon gerardii Vitman, Panicum virgatrum L., and Sorghastrum nutans (L.) Nash in northeast Kansas over two growing seasons to determine the comparative physiological responses of these dominant grasses of the tallgrass prairie to environmental variables. The response of dark respiration to temperature and of net assimilation to CO2 concentration and absorbed quantum flux differed little among species. A. gerardii had lower potential photosynthetic rates at internal CO2 concentrations below saturation than P. virgatum and S. nutans, but net assimilation under ambient conditions was similar in the three species. Net assimilation and both the initial slope of assimilation versus internal CO2 curves and the maximum potential assimilation rate decreased as leaf water potential declined in blades of A. gerardii and S. nutans. Changes in assimilation capacity were paralleled by changes in stomatal conductance that were similar in all three species. The strong correlations among processes regulating leaf CO2 assimilation and transpiration in A. gerardii, P. virgatum, and S. nutans suggest that the processes are tightly and similarly coupled in these grasses over a wide range of environmental conditions encountered in the tallgrass prairie.

Polley, H. W.↗

Soil surface CO2 fluxes and the carbon budget of a grassland

Measurements of soil surface CO2 fluxes are reported for three sites within the First International Satellite Land Surface Climatology Project (ISLSCP) Field Experiment (FIFE) area, and simple empirical equations are fit to the data to provide predictions of soil fluxes from environmental observations. A prototype soil chamber, used to make the flux measurements, is described and tested by comparing CO2 flux measurements to a 40-L chamber, a 1-m/cu chamber, and eddy correlation. Results suggest that flux measurements with the prototype chamber are consistent with measurements by other methods to within about 20 percent. A simple empirical equation based on 10-cm soil temperature, 0- to 10-cm soil volumetric water content, and leaf area index predicts the soil surface CO2 flux with a rms error of 1.2 micro-mol sq m/s for all three sites. Further evidence supports using this equation to evaluate soil surface CO2 during the 1987 FIFE experiment. The soil surface CO2 fluxes when averaged over 24 hours are comparable to daily gross canopy photosynthetic rates. For 6 days of data the net daily accumulation of carbon is about 0.6 g CO2 sq m/d; this is only a few percent of the daily gross accumulation of carbon by photosynthesis. As the soil became drier in 1989, the net accumulation of carbon by the prairie increased, suggesting that the soil flux is more sensitive to temperature and drought than the photosynthetic fluxes.

Norman, J. M.↗

Measurement of tree canopy architecture

The lack of accurate extensive geometric data on tree canopies has retarded development and validation of radiative transfer models. A stratified sampling method was devised to measure the three-dimensional geometry of 16 walnut trees which had received irrigation treatments of either 100 or 33 per cent of evapotranspirational (ET) demand for the previous two years. Graphic reconstructions of the three-dimensional geometry were verified by 58 independent measurements. The distributions of stem- and leaf-size classes, lengths, and angle classes were determined and used to calculate leaf area index (LAI), stem area, and biomass. Reduced irrigation trees have lower biomass of stems, leaves and fruit, lower LAI, steeper leaf angles and altered biomass allocation to large stems. These data can be used in ecological models that link canopy processes with remotely sensed measurements.

Martens, S. N.↗

Soil surface CO2 fluxes on the Konza Prairie

The utilization of a soil chamber to measure fluxes of soil-surface CO2 fluxes is described in terms of equipment, analytical methods, and estimate quality. A soil chamber attached to a gas-exchange system measures the fluxes every 5-15 min, and the data are compared to measurements of the CO2 fluxes from the canopy and from the soil + canopy. The soil chamber yields good measurements when operated in a closed system that is ported to the free atmosphere, and the CO2 flux is found to have a diurnal component.

Norman, J. M.↗

Leaf bidirectional reflectance and transmittance in corn and soybean

Bidirectional optical properties of leaves must be adequately characterized to develop comprehensive and reliably predictive canopy radiative-transfer models. Directional reflectance and transmittance factors of individual corn and soybean leaves were measured at source incidence angles (SIAs) 20, 45, and 70 deg and numerous view angles in the visible and NIR. Bidirectional reflectance distributions changed with increasing SIA, with forward scattering most pronounced at 70 deg. Directional-hemispherical reflectance generally increased and transmittance decreased with increased SIA. Directional-hemispherical reflectance factors were higher and transmittances were lower than the nadir-viewed reflectance component.

Walter-Shea, E. A.↗

Contrasts among bidirectional reflectance of leaves, canopies, and soils

Simple models are presented for predicting the bidirectional reflectance distribution functions (BRDFs) for soils and plant canopies viewed from various directions. BRDFs are predicted for bare soil, individual leaves, and plant canopies, and the results are compared with measurements and a three coefficient empirical equation. BRDF measurements for corn and soybean leaves are presented to contrast with canopy and soil distributions. Estimates of the soil, canopy, and leaf BRDFs are combined into a model called Cupid to predict BRDFs for complex natural surfaces.

Norman, J. M.↗

Modeling the radiant transfers of sparse vegetation canopies

The scattering dynamics of sparse vegetation canopies were studied within the framework of the three-dimensional radiative transfer model of Kimes (1984). The model was upgraded by including an algorithm for the anisotropic scattering of a soil boundary. Validation of the model was carried out using measured directional reflectance data for two canopies exhibiting typical scattering behavior with low and intermediate vegetation density. The canopies were: an orchard grass canopy; and a hard wheat canopy. A number of factors were found contributing to the final reflectance distribution of the canopies, including: (1) the strong anisotropic scattering properties of the soil; (2) the geometric effect of the vegetation probability gap function on the soil anisotropy and solar irradiance; and (3) the anisotropic scattering of vegetation which is controlled by the phase function and the layering of leaves. The application of the theoretical results to the development of earth-observing sensor systems is discussed.

Kimes, D. S.↗

Bidirectional Reflectance Modeling of Non-homogeneous Plant Canopies

The objective of this research is to develop a 3-dimensional radiative transfer model for predicting the bidirectional reflectance distribution function (BRDF) for heterogeneous vegetation canopies. The model (named BIGAR) considers the angular distribution of leaves, leaf area index, the location and size of individual subcanopies such as widely spaced rows or trees, spectral and directional properties of leaves, multiple scattering, solar position and sky condition, and characteristics of the soil. The model relates canopy biophysical attributes to down-looking radiation measurements for nadir and off-nadir viewing angles. Therefore, inversion of this model, which is difficult but practical should provide surface biophysical pattern; a fundamental goal of remote sensing. Such a model also will help to evaluate atmospheric limitations to satellite remote sensing by providing a good surface boundary condition for many different kinds of canopies. Furthermore, this model can relate estimates of nadir reflectance, which is approximated by most satellites, to hemispherical reflectance, which is necessary in the energy budget of vegetated surfaces.

Norman, J. M.↗

Simple equation to approximate the bidirectional reflectance from vegetative canopies and bare soil surfaces

A simple equation has been developed for describing the bidirectional reflectance of some vegetative canopies and bare soil surfaces. The equation describes directional reflectance as a function of zenith and azimuth view angles and solar azimuth angle. The equation works for simulated and field measured red and IR reflectance under clear sky conditions. Hemispherical reflectance can be calculated as a function of the simple equation coefficients by integrating the equation over the hemisphere of view angles. A single equation for estimating soil bidirectional reflectance was obtained using the relationships between solar zenith angles and the simple equation coefficients for medium and rough soil distributions. The equation has many useful applications such as providing a lower level boundary condition in complex plant canopy models and providing an additional tool for studying bidirectional effects on pointable sensors.

Walthall, C. L.↗

Bidirectional Reflectance Modeling of Non-homogeneous Plant Canopies

Efforts to develop a three dimensional model to predict canopy, bidirectional reflectance for heterogenous plant stands using incident radiation and canopy structural descriptions as inputs are described. Utility programs were developed to cope with the complex output from the 3 dimensional model. In addition an attempt was made to define leaf and soil properties, which are appropriate to the mode, by measuring leaf and soil bidirectional reflectance distribution functions; since almost no data exist on these distributions. In the process it was realized that most models probably are using the wrong leaf spectral properties, and that off-nadir reflectance measurements are difficult to make because of non-Lambertian properties of reference surfaces. Also, in the visible wavebands, rough soil may not be distinguishable from canopies when viewed from above.

Norman, J. M.↗

Field measurements, simulation modeling and development of analysis for moisture stressed corn and soybeans, 1982 studies

The experimental design, data acquisition and analysis procedures for agronomic and reflectance data acquired over corn and soybeans at the Sandhills Agricultural Laboratory of the University of Nebraska are described. The following conclusions were reached: (1) predictive leaf area estimation models can be defined which appear valid over a wide range of soils; (2) relative grain yield estimates over moisture stressed corn were improved by combining reflectance and thermal data; (3) corn phenology estimates using the model of Badhwar and Henderson (1981) exhibited systematic bias but were reasonably accurate; (4) canopy reflectance can be modelled to within approximately 10% of measured values; and (5) soybean pubescence significantly affects canopy reflectance, energy balance and water use relationships.

Blad, B. L.↗

Cargo/Logistics Airlift System Study (CLASS), Volume 1

Current and advanced air cargo systems are evaluated using industrial and consumer statistics. Market and commodity characteristics that influence the use of the air mode are discussed along with a comparison of air and surface mode on typical routes. Results of on-site surveys of cargo processing facilities at airports are presented, and institutional controls and influences on air cargo operations are considered.

Norman, J. M.↗

Cargo/Logistics Airlift System Study (CLASS), Volume 2

Air containerization is discussed in terms of lower freight rates, size and pallet limitations, refrigeration, backhaul of empties, and ownership. It is concluded that there is a need for an advance air cargo system as indicated by the industry/transportation case studies, and a stimulation of the air cargo would result in freight rate reductions.

Norman, J. M.↗

Cargo/Logistics Airlift System Study (CLASS), Executive Summary

The current air cargo system is analyzed along with advanced air cargo systems studies. A forecast of advanced air cargo system demand is presented with cost estimates. It is concluded that there is a need for a dedicated advance air cargo system, and with application of advanced technology, reductions of 45% in air freight rates may be achieved.

Norman, J. M.↗