Engineering topics

Norris, M. A.

Publications and source records attributed to Norris, M. A..

10 records

NASA NTRS1989

Linear estimation and control studies of vibration suppression of SCOLE flexible mast

A Kalman filter and a controller are presented for vibration suppression of the Spacecraft Control Laboratory Experiment flexible mast mounted in the cantilevered configuration. Mode shapes and frequencies of the structure obtained from a finite element analysis are used to compute the controller and filter gains. The paper presents results and discussion from simulation and experimental studies. Comparison of experimental results with those obtained by simulation show close agreement.

Ghosh, D.↗

NASA NTRS1988

Parameter identification using modal data

Parameter identification using experimental modal data is examined. The following approaches are discussed: (1) Direct - using actual sensor measurements to obtain parameters (e.g., ERA, ITD); and (2) Indirect - identifies parameters using measured modal data. In this work, only the natural frequencies are used to identify physical parameters.

Meirovitch, L.↗

NASA NTRS1988

A perturbation technique for parameter identification in distributed structures

Structures are often characterized by parameters, such as mass and stiffness, that are spatially distributed. Parameter identification of distributed structures is subject to many of the difficulties involved in the modeling problem, and the choice of the model can greatly affect the results of the parameter identification process. Analogously to control spillover in the control of distributed-parameter systems, identification spillover is shown to exist as well and its effect is to degrade the parameter estimates. Moreover, as in modeling by the Rayleigh-Ritz method, it is shown that, for a Rayleigh-Ritz type identification algorithm, an inclusion principle exists in the identification of distributed-parameter systems as well, so that the identified natural frequencies approach the actual natural frequencies monotonically from above.

Meirovitch, L.↗

NASA NTRS1988

A Rayleigh-Ritz approach to structural parameter identification

This paper is concerned with the identification of parameter distributions in large space structures. The formulation is based on a Rayleigh-Ritz type approach working with the actual displacement at a given number of points in the structure. The parameter distributions are expanded in terms of known admissible functions multiplied by unknown coefficients, and the identification process reduces to the determination of these coefficients. The procedure uses a perturbation approach, beginning with a postulated set of parameters and iterating to the actual values in an incremental fashion.

Meirovitch, L.↗

NASA NTRS1987

Modeling and identification of SCOLE

Vector differential equations for distributed structures; discretization (in space) of distributed structures; and parameter identification for the Spacecraft Control Laboratory Experiment (SCOLE) are examined.

Meirovitch, L.↗

NASA NTRS1987

Control of SCOLE

A relatively low order model is used to control SCOLE. Drastic truncation of the discretized model is proposed by means of a modal expansion. An open loop eigenvalue problem is illustrated as is truncated modal equations, modal state equations, actual output vector and modal Kalman filter. Also illustrated is independent modal-space control.

Meirovitch, L.↗

NASA NTRS1986

Parameter identification in distributed spacecraft structures

This paper develops a new technique for the identification of parameters in distributed systems. The technique is based on the finite element method. An an illustration, the method is applied to the identification of the mass and stiffness distributions of a space structure, simulated by a nonuniform free-free beam.

Meirovitch, L.↗

NASA NTRS1985

Maneuvering of flexible spacecraft with application to SCOLE

This paper is concerned with the derivation of the equations of motion for the Spacecraft Control Laboratory Experiment (SCOLE). For future reference, the equations of motion of a similar structure orbiting the earth are also derived. The structure is assumed to undergo large rigid-body maneuvers and small elastic deformations. A perturbation approach is presented where the quantities defining the rigid-body maneuver are assumed to be relatively large, with the elastic deformations and deviations from the rigid-body maneuver being relatively small. The perturbation equations have the form of linear, non-self-adjoint equations with time-dependent coefficients. An active control technique can then be formulated to permit maneuvering of the spacecraft and simultaneously suppressing the elastic vibration.

Meirovitch, L.↗

NASA NTRS1984

Identification and control of structures in space

The derivation of the equations of motion for the Spacecraft Control Laboratory Experiment (SCOLE) is reported and the equations of motion of a similar structure orbiting the earth are also derived. The structure is assumed to undergo large rigid-body maneuvers and small elastic deformations. A perturbation approach is proposed whereby the quantities defining the rigid-body maneuver are assumed to be relatively large, with the elastic deformations and deviations from the rigid-body maneuver being relatively small. The perturbation equations have the form of linear equations with time-dependent coefficients. An active control technique can then be formulated to permit maneuvering of the spacecraft and simultaneously suppressing the elastic vibration.

Meirovitch, L.↗

NASA NTRS1984

Equations of motion for control of the SCOLE laboratory experiment

The objectives of this study are listed as follows: (1) to develop Lagrange's equations of motion for the shuttle antenna configuration in orbit; (2) to modify equations using the Lagrange multiplier method to develop equations of motion for the laboratory experiment; and (3) to discuss methods for simulation and control. The equations are presented in graph form.

Meirovitch, L.↗