Search NASA⌕ Search

Engineering topics

Northam, G. B.

Publications and source records attributed to Northam, G. B..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1996

Effect of Cavity Injection on Wall Drag in a Supersonic Flow with Reflecting Shocks

The wall drag test tunnel at NASA Langley Research Center was used to evaluate simulated scramjet fuel injection into a wall cavity. In this tunnel, one wall consists of interchangeable aluminum plates attached to an air bearing suspension system. The plates were equipped with load cells to measure drag forces and static taps to determine pressure distributions. The plates were exposed to a Mach 2 air stream at a total pressure of 115 psia (793 kPa). This flow field contained a train of weak unsteady, reflecting shock waves that were produced in the nozzle assembly located upstream of the test section.

Castiglone, L. A.↗
NASA NTRS1996

Effect of Transpiration Injection on Skin Friction in an Internal Supersonic Flow

An experimental program was conducted at NASA Langley Research Center that included development and evaluation of an operational facility for wall drag measurement of potential scramjet fuel injection or wall cooling configurations. The facility consisted of a supersonic tunnel, with one wall composed of a series of interchangeable aluminum plates attached to an air bearing suspension system. The system was equipped with load cells that measured drag forces of 115 psia (793 kPa). This flow field contained a train of weak, unsteady, reflecting shock waves that were produced in the Mach 2 nozzle flows, the effect of reflecting shocks (which are to be expected in scramjet combustors) in internal flows has not previously been documented.

Castiglone, L. A.↗
NASA NTRS1994

Computational/experimental investigation of staged injection into a Mach 2 flow

The stage normal injection of two jets of air into a Mach 2 freestream behind a rearward-facing step has been investigated using laser-induced iodine fluorescence and laser doppler anemometry techniques. A detailed data set has been compiled that includes profiles of pressure, temperature, two components of velocity, and mole fraction of the injectant at 44 locations, plus planar surveys of pressure, temperature, velocity, and mole fraction. A companion numerical study was performed using the SPARK Navier-Stokes code. Good overall agreement was observed for this complex, highly three-dimensional flowfield. Discrepancies were observed in the computed and measured total temperatures, turbulent mixing, and shock strengths. The effect of grid resolution was investigated by calculating solutions on grids of 60,000 points, 200,000 points, and 450,000 points. Differences in the solutions on the two finer grids were small. The effect of turbulence modeling was investigated by calculating solutions with three different algebraic models for the jet turbulence. Overall, the turbulence models were found to have the greatest effect on the numerical solutions, followed by the grid resolution and the injectant Mach number.

Eklund, D. R.↗
NASA NTRS1993

Coherent anti-Stokes Raman spectroscopy temperature measurements in a hydrogen-fueled supersonic combustor

Coherent anti-Stokes Raman spectroscopy (CARS) thermometry has been used to obtain static temperature cross sections in a three-dimensional supersonic combustor flowfield. Data were obtained in three spanwise planes downstream of a single normal fuel injector which was located downstream of a rearward-facing step. The freestream flow was nominally Mach 2 and was combustion heated to a total temperature of 1440 K (yielding a static temperature of about 800 K in the freestream) to simulate the inflow to a combustor operating at a flight Mach number of about 5.4. Since a broadband probe laser was used an instantaneous temperature sample was obtained with each laser shot at a repetition rate of 10 Hz. Thus root-mean-square (rms) temperatures and temperature probability density functions (pdf's) were obtained in addition to mean temperatures.

Smith, Michael W.↗
NASA NTRS1993

Effects of compression and expansion ramp fuel injector configuration on scramjet combustion and heat transfer

A scramjet combustor with four wall-ramp injectors containing Mach-1.7 fuel jets in the base of the ramps was investigated experimentally. During the test program, two swept ramp injector designs were evaluated. One swept-ramp model had 10-deg compression-ramps and the other had 10-deg expansion cavities between flush wall ramps. The scramjet combustor model was instrumented with pressure taps and heat-flux gages. The pressure measurements indicated that both injector configurations were effective in promoting mixing and combustion. Autoignition occurred for the compression-ramp injectors, and the fuel began to burn immediately downstream of the injectors. In tests of the expansion ramps, a pilot was required to ignite the fuel, and the fuel did not burn for a distance of at least two gaps downstream of the injectors. Once initiated, combustion was rapid in this configuration. Heat transfer measurements showed that the heat flux differed greatly both across the width of the combustor and along the length of the combustor.

Stouffer, Scott D.↗
NASA NTRS1993

Evaluation of scramjet nozzle configurations and film cooling for reduction of wall heating

Experiments on relaminarization, or reverse transition of turbulent flow, have been conducted with a scramjet combustor and nozzle model. The Mach-2.7 direct-connect scramjet combustor employed swept-ramp fuel injectors, and the entering flow simulated Mach-6 to Mach-7 flight conditions. Tests were also conducted without combustor fuel to produce a higher nozzle entrance Mach number and lower pressures. Additional tests were conducted to evaluate the effectiveness of film cooling on the cowl region. At each test condition studied, the entrance radius had no significant effect on the measured downstream wall heating rates. Analysis of the data when fuel was injected into the combustor shows good agreement with turbulent theory; for the tests without fuel injection and combustion, the data downstream of the nozzle entrance radius are intermediate to the calculated turbulent and laminar solutions. Results of film-cooling tests, conducted with both hydrogen and nitrogen injectants, showed that, per unit mass, the hydrogen was approximately three to four times more effective than nitrogen in reducing the downstream wall heating rates.

Baker, N. R.↗
NASA NTRS1992

Workshop report - A validation study of Navier-Stokes codes for transverse injection into a Mach 2 flow

A CFD (Computational Fluid Dynamics) competition was held at the Third Scramjet Combustor Modeling Workshop to assess the current state-of-the-art in CFD codes for the analysis of scramjet combustors. Solutions from six three-dimensional Navier-Stokes codes were compared for the case of staged injection of air behind a step into a Mach 2 flow. This case was investigated experimentally at the University of Virginia and extensive in-stream data was obtained. Code-to-code comparisons have been made with regard to both accuracy and efficiency. The turbulence models employed in the solutions are believed to be a major source of discrepancy between the six solutions.

Eklund, Dean R.↗
NASA NTRS1992

The effect of entrance radius and film injection on wall heating in scramjet nozzles

An experimental study has been performed with a scramjet combustor and nozzle model to determine the effect of nozzle radii on relaminarization, and the effectiveness of film injection in reducing wall heat flux. The nozzle model was installed downstream of a swept-ramp scramjet combustor model, operated at Mach 2.7 with vitiated air, simulating Mach 6-7 flight enthalpies. Results from tests conducted with three nozzle radii, varying in curvature from a sharp Prandtl-Meyer expansion to a radius of two scramjet combustor exit heights, showed little or no effect on the downstream wall heat flux, which is not in agreement with both subsonic and supersonic relaminarization correlations in the available literature. In contrast, film injection upstream of all three radii produced reductions of 70 percent in the entire nozzle model heating rate, for the nominal film-to-free stream pressure matched condition. Results from film injection, with and without pressure gradient, but without wall curvature, show that the gradients appear to stabilize the film, with the resulting reductions in wall heat transfer rates apparent far downstream of the point of injection.

Baker, N. R.↗
NASA NTRS1992

A numerical study of the effects of geometry on the performance of a supersonic combustor

A numerical study is conducted to investigate the effects of two combustor scale parameters, the expansion angle and the length of the constant area combustor section, on the mixing and combustion within a supersonic combustor. This study uses the SPARK 3D Navier-Stokes code. Turbulence is modeled utilizing an algebraic eddy viscosity model and the chemical mechanism is modeled with a 7-reaction, 7-species finite-rate chemistry model. The calculations show that, even at the relatively low flight Mach numbers (5-7) associated with the conditions examined, the chemical constituents are far from equilibrium, and therefore that kinetics effects are important.

Eklund, Dean R.↗
NASA NTRS1992

Strain-induced extinction of hydrogen-air counterflow diffusion flames - Effects of steam, CO2, N2, and O2 additives to air

A fundamental study was performed using axisymmetric nozzle and tubular opposed jet burners to measure the effects of laminar plug flow and parabolic input velocity profiles on the extinction limits of H2-air counterflow diffusion flames. Extinction limits were quantified by 'flame strength', (average axial air jet velocity) at blowoff of the central flame. The effects of key air contaminants, on the extinction limits, are characterized and analyzed relative to utilization of combustion contaminated vitiated air in high enthalpy supersonic test facilities.

Pellett, G. L.↗
NASA NTRS1991

Finite-rate chemistry effects in a Mach 2 reacting flow

UV spontaneous vibrational Raman scattering and laser-induced predissociative fluorescence (LIPF) are combined and applied to a supersonic flame. For the first time, simultaneous measurements of temperature, major species (H2, O2, N2, H2O), and minor species (OH) concentrations are obtained with a 'single' excimer laser in a supersonic-lifted hydrogen-air diffusion flame. In the supersonic flame, a small amount of reaction occurs upstream of the lifted flame base, due to shock wave interactions and mixing with hot vitiated air. The strong turbulent mixing and high total enthalpy fluctuations lead to nonequilibrium values of temperature, and major and minor species concentrations. Combustion occurs farther downstream of the lifted region where slow three-body recombination reactions result in superequilibrium OH concentrations that depress the temperatures below their equilibrium values. Farther downstream, ambient air entrainment contaminates flame properties.

Cheng, T. S.↗
NASA NTRS1991

Mach 2 and Mach 3 mixing and combustion in scramjets

Experimental and theoretical studies are being conducted to explore techniques to enhance mixing in scramjet combustors using parallel fuel injection from the base of swept and unswept wall-mounted ramps. Parallel injection may be useful in high speed scramjets due to the thrust contributed by the momentum of expanding fuel that has been heated in the vehicle cooling cycle. The experiments reported herein were conducted using Mach 2 and 3 combustor inlet conditions. Supporting computational and cold flow studies indicated that the observed enhanced mixing for the swept ramp configuration is primarily due to the substantially higher degree of vorticity and entrainment generated by the swept trailing edges.

Northam, G. B.↗
NASA NTRS1991

Instantaneous planar visualization of reacting supersonic flows using silane seeding

A new visualization technique for reacting flows has been developed. This technique, which is suitable for supersonic combustion flows, has been demonstrated on a scramjet combustor model. In this application, gaseous silane (SiH4) was added to the primary hydrogen fuel. When the fuel reacted, so did the (SiH4), producing silica (SiO2) particles in situ. The particles were illuminated with a laser sheet formed from a frequency-doubled Nd:YAG laser (532 nm) beam and the Mie scattering signal was imaged. These planar images of the silica Mie scattering provided instantaneous 'maps' of combustion progress within the turbulent reacting flowfield.

Smith, Michael W.↗
NASA NTRS1991

UV Raman scattering measurements in a Mach 2 H2-air flame for assessment of CFD models

An UV narrowband tunable excimer laser is used for spontaneous Raman scattering measurements in hydrogen diffusion flames. The UV Raman system is characterized by a repetition rate of about 100 Hz, a temporal resolution of about 20 ns, and a spatial resolution of about 0.4 mm. It is concluded that a single KrF excimer laser based on spontaneous Raman scattering in conjunction with laser-induced predissociative fluorescence is capable of measuring instantaneously and simultaneously major species (H2, O2, N2, H2O), minor species (OH), and temperature.

Cheng, T. S.↗
NASA NTRS1991

Analysis of opposed-jet hydrogen-air counter flow diffusion flame

An opposed-jet counterflow diffusion-flame configuration is considered for the analysis of a nitrogen-diluted hydrogen-air diffusion flame. A boundary-layer similarity solution is employed in order to reduce the governing equations to a set of equations in one independent variable. The equation set is written in the time-dependent form and solved by the finite-volume time-marching technique. This model uses detailed chemistry and accounts for the variations of Prandtl number and Lewis number as well as the effect of thermal diffusion on the flame. It is noted that a one-step model can predict several features of the flame, while the detailed-chemistry model can be used for fine-tuning the results. The present results indicate that thermal diffusion has negligible effect on the characteristics of the flame.

Ho, Y. H.↗
NASA NTRS1991

Supersonic mixing and combustion in scramjets

Experimental and theoretical studies are being conducted to explore techniques to enhance mixing in scramjet combustors using parallel fuel injection from the base of swept and unswept wall-mounted ramps. The experiments reported herein were conducted using Mach 2 and 3 combustor inlet conditions. Supporting computational and cold flow studies indicated that the observed enhanced mixing for the swept ramp configuration is primarily due to the substantially higher degree of vorticity and entrainment generated by the swept trailing edges.

Northam, G. B.↗
NASA NTRS1991

CARS Temperature Measurements in Turbulent and Supersonic Facilities

This paper documents the development of the National Aeronautics and Space Administration s (NASA) Langley Research Center ( LaRC) Coherent Antistokes Raman Spectroscopy (CARS) systems for measurements of temperature in a turbulent subsonic or supersonic reacting hydrogen-air environment. Spectra data provides temperature data when compared to a precalculated library of nitrogen CARS spectra. Library validity was confirmed by comparing CARS temperatures derived through the library with three different techniques for determination of the temperature in hydrogen-air combustion and an electrically heated furnace. The CARS system has been used to survey temperature profiles in the simulated flow of a supersonic combustion ramjet (scramjet) model. Measurement results will be discussed.

Jarrett, O., Jr.↗