Search NASA⌕ Search

Engineering topics

Oaida, Bogdan

Publications and source records attributed to Oaida, Bogdan.

14 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2025

SUDA: A SUrface Dust Analyser for Compositional Mapping of the Galilean Moon Europa

Abstract The Surface Dust Analyser (SUDA) is a mass spectrometer onboard the Europa Clipper mission for investigating the surface composition of the Galilean moon Europa. Atmosphereless planetary moons such as the Galilean satellites are wrapped into a ballistic dust exosphere populated by tiny samples from the moon’s surface produced by impacts of fast micrometeoroids. SUDA will measure the composition of such surface ejecta during close flybys of Europa to obtain key chemical signatures for revealing the satellite’s composition such as organic molecules and salts, history, and geological evolution. Because of their ballistic orbits, detected ejecta can be traced back to the surface with a spatial resolution roughly equal to the instantaneous altitude of the spacecraft. SUDA is a Time-Of-Flight (TOF), reflectron-type impact mass spectrometer, optimized for a high mass resolution which only weakly depends on the impact location. The instrument will measure the mass, speed, charge, elemental, molecular, and isotopic composition of impacting grains. The instrument’s small size of$268 ~\mathrm {mm} \times 250 ~\mathrm {mm} \times 171$ 268 mm × 250 mm × 171 $~\mathrm {mm}$ mm , radiation-hard design, and rather large sensitive area of 220 cm 2 matches well the challenging demands of the Clipper mission.

Astronomy & Astrophysics↗
NASA NTRS2021

Using Automated Scheduling for Mission Design: A Case Study for EMIT

The Earth Surface Mineral Dust Source InvesTigation (EMIT) is an Earth Ventures-Instrument (EVI-4) mission to map the surface mineralogy of arid dust source regions. EMIT used automated scheduling technology to analyze aspects of the mission design. The automated scheduling technology was used to construct schedules which were then automatically analyzed with respect to science acquired. These analyses can be performed for a range of spacecraft hardware configurations, observation strategies, and science requirements. By studying the effects of changes on the above inputs, better hardware configurations, observation strategies, and science requirements can be formulated. The use of a pointing mirror on EMIT was under consideration, and this analysis aided in determining whether or not to keep it as part of the design of the instrument. Clouds will also have a large impact on the coverage of science targets achievable by the mission. Analysis was done on how clouds could impact the coverage achievable as well as the data volume. This analysis with clouds also aided in determining the coverage criteria for the mission. It was necessary to find a criteria that was achievable with some margin as well as satisfies the science goals of the mission.

Thompson, David R.↗
NASA NTRS2020

The Earth Surface Mineral Dust Source Investigation: An Earth Science Imaging Spectroscopy Mission

The Earth Surface Mineral Dust Source Investigation, EMIT, is planned to operate from the International Space Station starting no earlier than the fall of 2021. EMIT will use visible to short wavelength infrared imaging spectroscopy to determine the mineral composition of the arid land dust source regions of the Earth to advance our knowledge of the radiative forcing effect of these aerosols. Mineral dust emitted into the atmosphere under high wind conditions is an element of the Earth system with many impacts to the Earth’s energy balance, atmosphere, surface, and oceans. The Earth’s mineral dust cycle with source, transport, and deposition phases are studied with advanced Earth System Models. Because the chemical composition, optical and surface properties of soil particles vary strongly with the mineral composition of the source, these models require knowledge of surface soil mineral dust source composition knowledge to accurately understand dust impacts on the Earth system now and in the future. At present, compositional knowledge of the Earth’s mineral dust source regions from existing data sets is uncertain as a result of limited measurements. EMIT will use spectroscopically derived surface mineral composition to update the prescribe boundary conditions for state-of-the-art Earth System Models. The EMIT-initialized models will be used to investigate the impact of direct radiative forcing in the Earth system that depends strongly on the composition of the mineral dust aerosols emitted into the atmosphere. These new measurements and related products will be used to address the EMIT science objectives and made available to the science community for additional investigations. An overview of the EMIT science, development, and mission is presented in this paper.

Green, Robert O.↗
NASA NTRS2016

Use of Model Payload for Europa Mission Development

This paper discusses the basis for the Model Payload and how it was used to develop the mission design, observation and data acquisition strategy, needed spacecraft capabilities, spacecraft-payload interface needs, mission system requirements and operational scenarios.

Lewis, Kari↗
NASA NTRS2013

The OPALS Plan for Operations: Use of ISS Trajectory and Attitude Models in the OPALS Pointing Strategy

This paper will discuss the OPALS pointing strategy, focusing on incorporation of ISS trajectory and attitude models to build pointing predictions. Methods to extrapolate an ISS prediction based on past data will be discussed and will be compared to periodically published ISS predictions and Two-Line Element (TLE) predictions. The prediction performance will also be measured against GPS states available in telemetry. The performance of the pointing products will be compared to the allocated values in the OPALS pointing budget to assess compliance with requirements.

Optical PAyload for Lasercomm Science (OPALS)↗
NASA NTRS2012

I-FORCAST: Rapid Flight Planning Tool

I-FORCAST (Instrument - Field of Regard Coverage Analysis and Simulation Tool) is a flight planning tool specifically designed for quickly verifying the feasibility and estimating the cost of airborne remote sensing campaigns (see figure). Flights are simulated by being broken into three predefined routing algorithms as necessary: mapping in a snaking pattern, mapping the area around a point target (like a volcano) with a star pattern, and mapping the area between a list of points. The tool has been used to plan missions for radar, lidar, and in-situ atmospheric measuring instruments for a variety of aircraft. It has also been used for global and regional scale campaigns and automatically includes landings when refueling is required. The software has been compared to the flight times of known commercial aircraft route travel times, as well as a UAVSAR (Uninhabited Aerial Vehicle Synthetic Aperture Radar) campaign, and was within 15% of the actual flight time. Most of the discrepancy is due to non-optimal flight paths taken by actual aircraft to avoid restricted airspace and used to follow landing and take-off corridors.

Oaida, Bogdan↗
NASA NTRS2012

OPALS: A COTS-based Tech Demo of Optical Communications

I. Objective: Deliver video from ISS to optical ground terminal via an optical communications link. a) JPL Phaeton/Early Career Hire (ECH) training project. b) Implemented as Class-D payload. c) Downlink at approx.30Mb/s. II. Flight System a) Optical Head Beacon Acquisition Camera. Downlink Transmitter. 2-axis Gimbal. b) Sealed Container Laser Avionics Power distribution Digital I/O board III. Implementation: a) Ground Station - Optical Communications Telescope Laboratory at Table Mountain Facility b) Flight System mounted to ISS FRAM as standard I/F. Attached externally on Express Logistics Carrier.

optical communications↗
NASA NTRS2009

Onboard Classification of Hyperspectral Data on the Earth Observing One Mission

Remote-sensed hyperspectral data represents significant challenges in downlink due to its large data volumes. This paper describes a research program designed to process hyperspectral data products onboard spacecraft to (a) reduce data downlink volumes and (b) decrease latency to provide key data products (often by enabling use of lower data rate communications systems). We describe efforts to develop onboard processing to study volcanoes, floods, and cryosphere, using the Hyperion hyperspectral imager and onboard processing for the Earth Observing One (EO-1) mission as well as preliminary work targeting the Hyperspectral Infrared Imager (HyspIRI) mission.

cryosphere↗