Engineering topics

Oakley, Celia M.

Publications and source records attributed to Oakley, Celia M..

3 records

NASA NTRS1990

End-point controller design for an experimental two-link flexible manipulator using convex optimization

Recent results in linear controller design are used to design an end-point controller for an experimental two-link flexible manipulator. A nominal 14-state linear-quadratic-Gaussian (LQG) controller was augmented with a 528-tap finite-impulse-response (FIR) filter designed using convex optimization techniques. The resulting 278-state controller produced improved end-point trajectory tracking and disturbance rejection in simulation and experimentally in real time.

Oakley, Celia M.↗

NASA NTRS1990

Anatomy of an experimental two-link flexible manipulator under end-point control

The design and experimental implementation of an end-point controller for two-link flexible manipulators are presented. The end-point controller is based on linear quadratic Gaussian (LQG) theory and is shown to exhibit significant improvements in trajectory tracking over a conventional controller design. To understand the behavior of the manipulator structure under end-point control, a strobe sequence illustrating the link deflections during a typical slew maneuver is included.

Oakley, Celia M.↗

NASA NTRS1989

End-point control of a two-link manipulator with a very flexible forearm - Issues and experiments

For mechanical manipulators, a logical sensor location is at the manipulator end-point where tasks are performed. Unfortunately, when bending flexibility exists between an end-point sensor and a joint actuator, stability and performance are achieved only through sophisticated control design. Some of the issues involved in utilizing end-point sensing for two-link flexible manipulators are addressed. A modeling technique that properly represents the foreshortening of a flexible link undergoing deflections is presented. In order to realize fully the advantages of the assumed-modes modeling method, mode shapes are selected that allow a low-order model to be used effectively for simulation and control purposes. A nonlinear controller, incorporating state feedback and a constant-gain extended Kalman filter driven by end-point measurements, is designed and compared to a conventional proportional-plus-derivative controller that uses collocated sensors. Results from implementing these controllers on the experimental Stanford multilink flexible manipulator are given.

Oakley, Celia M.↗