Search NASA⌕ Search

Engineering topics

Obrien, P. J.

Publications and source records attributed to Obrien, P. J..

14 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1985

Simulation studies of time-control procedures for the advanced air traffic control system

The problem of mixing aircraft equipped with time-controlled guidance systems and unequipped aircraft in the terminal area has been investigated via a real-time air traffic control simulation. These four-dimensional (4D) guidance systems can predict and control the touchdown time of an aircraft to an accuracy of a few seconds throughout the descent. The objectives of this investigation were to (1) develop scheduling algorithms and operational procedures for various traffic mixes that ranged from 25% to 75% 4D-equipped aircraft; (2) examine the effect of time errors at 120 n. mi. from touchdown on touchdown time scheduling of the various mix conditions; and (3) develop efficient algorithms and procedures to null the initial time errors prior to reaching the final control sector, 30 n. mi. from touchdown. Results indicate substantial reduction in controller workload and an increase in orderliness when more than 25% of the aircraft are equipped with 4D guidance systems; initial random errors of up to + or - 2 min can be handled via a single speed advisory issued in the arrival control sector, thus avoiding disruption of the time schedule.

Tobias, L.↗
NASA NTRS1985

Simulation of time-control procedures for terminal area flow management

Simulations of a terminal area traffic-management system incorporating automated scheduling and time-control (four-dimensional) techniques conducted at NASA Ames Research Center jointly with the Federal Aviation Administration, have shown that efficient procedures can be developed for handling a mix of 4D-equipped and conventionally equipped aircraft. A crucial role in this system is played by an ATC host computer algorithm, referred to as a speed advisory, that allows controllers to maintain accurate time schedules of the conventionally equipped aircraft in the traffic mix. Results are of the most recent simulations in which two important special cases were investigated. First, the effects of a speed advisory on touchdown time scheduling are examined, when unequipped aircraft are constrained to follow fuel-optimized profiles in the near-terminal area, and rescheduling procedures are developed to handle missed approaches of 4D-equipped aircraft. Various performance measures, including controller opinion, are used to evaluate the effectiveness of the procedures.

Alcabin, M.↗
NASA NTRS1984

Mixing 4D-Equipped and Unequipped Aircraft in the Terminal Area

On-board 4D guidance systems, which predict and control the touchdown time of an aircraft to an accuracy of a few seconds throughout the descent, were developed and demonstrated in several flight test programs. However, in addition to refinements of the on board system, two important issues still need to be considered. First, in order to make effective use of these on-board systems, it is necessary to understand and develop the interactions of the airborne and air traffic control (ATC) system in the proposed advanced environment. Unless the total system is understood, the advanced on-board system may prove unusable from an ATC standpoint. Second, in planning for a future system in which all aircraft are 4D equipped, it is necessary to confront the transition situation in which some percentage of traffic must still be handled by conventional means. In terms of 4D, this means that some traffic must still be given radar vectors and speed clearances (that is, be spaced by conventional distance separation techniques), while the 4D-equipped aircraft need to be issued time assignments. These apparent differences are reconciled and efficient ATC operation is developed.

Tobias, L.↗
NASA NTRS1984

Simulation of time-control procedures for the advanced air traffic control system

The problem of mixing four-dimensional (4D) equipped aircraft - aircraft equipped with on-board guidance systems that can predict and control the touchdown time of an aircraft to an accuracy of a few seconds throughout the descent - with unequipped aircraft in the terminal area has been investigated via a real-time air traffic control simulation study. The objective of this study was to examine the effect of time errors (at 120 n. mi. from touchdown) on touchdown time scheduling, and to develop efficient algorithms and procedures to null the initial time errors prior to reaching the final control sector (30 n. mi. from touchdown). Results indicate that initial random errors of up to + or - 2 min can be handled via a single speed advisory issued in the arrival control sector, and thus the time schedule is not disrupted.

Tobias, L.↗
NASA NTRS1983

Mixing 4D equipped and unequipped aircraft in the terminal area

The problem of mixing four-dimensional (4D) equipped aircraft (aircraft equipped with on-board guidance systems that can predict and control the touchdown-time of an aircraft to an accuracy of a few seconds throughout the descent) with unequipped aircraft in the terminal area has been investigated via a real-time air traffic control simulation study. The objective of this study was to develop scheduling algorithms and operational procedures for various traffic mixes that ranged from 25 percent to 75 percent 4D equipped aircraft. Results indicate substantial reduction in controller workload and an increase in orderliness when more than 25 percent of the aircraft are 4D equipped. Moreover, this is accomplished without increasing the workload or adding delays for the unequipped aircraft.

Tobias, L.↗
NASA NTRS1982

Real-time simulation of helicopter IFR approaches into major terminal areas using RNAV, MLS, and CDTI

Helicopter IFR routes at hub airports have been investigated in an air-traffic-control system simulation involving a piloted helicopter simulator, computer-generated air traffic, and air traffic controllers. Problems studied included: (1) pilot acceptance of the approach procedure and tracking accuracy; (2) ATC procedures for handling a mix of helicopter and fixed-wing traffic; and (3) utility of the Cockpit Display of Traffic Information (CDTI) for the helicopter. Results indicate that the helicopter routes were pilot acceptable and were noninterfering with fixed-wing traffic. Merging and spacing maneuvers using CDTI were successfully carried out by the pilots, but controllers had some reservations concerning CDTI.

Tobias, L.↗
NASA NTRS1981

ATC simulation of helicopter IFR approaches into major terminal areas using RNAV, MLS, and CDTI

The introduction of independent helicopter IFR routes at hub airports was investigated in a real time air traffic control system simulation involving a piloted helicopter simulator, computer generated air traffic, and air traffic controllers. The helicopter simulator was equipped to fly area navigation (RNAV) routes and microwave landing system approaches. Problems studied included: (1) pilot acceptance of the approach procedure and tracking accuracy; (2) ATC procedures for handling a mix of helicopter and fixed wing traffic; and (3) utility of the cockpit display of traffic information (CDTI) for the helicopter in the hub airport environment. Results indicate that the helicopter routes were acceptable to the subject pilots and were noninterfering with fixed wing traffic. Merging and spacing maneuvers using CDTI were successfully carried out by the pilots, but controllers had some reservations concerning the acceptability of the CDTI procedures.

Tobias, L.↗
NASA NTRS1980

Effectiveness of advanced fuel-conservative procedures in the transitional ATC environment

The real time simulation (involving both the pilot and the air traffic controller) of fuel conservative approaches, profile descents, and four dimensional area navigation to assess the effectiveness of the procedures is discussed. Generally, results indicate some difficulties with the procedures tested in a mixed traffic environment and point to the need for computer assistance for effective implementation of candidate procedures.

Tobias, L.↗
NASA NTRS1979

Simulation study of the operational effects of fuel-conservative approaches

Fuel-conservative procedures have been investigated using real-time air traffic control simulations linked to two piloted simulators. The fuel-conservative procedures studied were profile descents and two types of landing approaches, delayed flap and IATA. The investigation determined the effect of these procedures on the ATC system operation. It examined the mixing of aircraft executing fuel-conservative approaches with those executing conventional approaches. The most difficult approach type mix of traffic was found to be 50% conventional and 50% delayed flap. However, for the test scenario chosen, arrival rates of at least 30 aircraft per hour were feasible and resulted in a net average fuel saving, even for the most difficult mix. Also, there is a fuel savings and reduced controller workload for the profile descent procedures.

Tobias, L.↗
NASA NTRS1978

Simulation study of the effect of fuel-conservative approaches on ATC procedures and terminal area capacity

Fuel-conservative procedures have been investigated using real-time air traffic control simulations linked to two piloted simulators. The fuel-conservative procedures studied were profile descents and two types of landing approaches. The investigation determined the effect of these procedures on the ATC system and terminal area capacity. It examined the mixing of aircraft executing fuel-conservative approaches with those executing conventional approaches. The results indicate a systems fuel savings for the landing approaches under all tested conditions except at, or near, maximum system capacity. Also, there is a fuel savings and reduced controller workload for the profile descent procedures.

Tobias, L.↗
NASA NTRS1978

Dynamic simulation studies of fuel conservation procedures used in terminal areas

A simulation program was devised to study the effects of fuel conservation procedures on ATC and terminal area operations. The FAA National Aviation Facilities Experimental Center and the Ames Research Center have interconnected ATC and piloted simulation facilities at both centers. A unique national simulation facility for the study of pilot/controller/system interactions was established. The present paper describes the simulation facilities and outlines aircraft operational procedures evaluated in the experiments. Two experiments studied are discussed: the first involves two types of landing approaches, while the second involves both landing approaches and profile descents.

Obrien, P. J.↗
NASA NTRS1977

Real-time manned simulation of advanced terminal area guidance concepts for short-haul operations

A real-time simulation was conducted of three-dimensional area navigation and four-dimensional area navigation equipped (STOL) aircraft operating in a high-density terminal area traffic environment. The objectives were to examine the effects of 3D RNAV and 4D RNAV equipped aircraft on the terminal area traffic efficiency, and to examine the performance of an air traffic control system concept and associated controller display proposed for use with advanced RNAV systems. Three types of STOL aircraft were simulated each with different performance capabilities. System performance was measured in both the 4D mode and in a 3D mode; the 3D mode, used as a baseline, was simply the 4D mode less any time specification. The results show that communications workload in the 4D mode was reduced by about 35 percent compared to the 3D, while 35 percent more traffic was handled with the 4D. Aircraft holding time in the 4D mode was only 30 percent of that required in the 3D mode. In addition, the orderliness of traffic was improved significantly in the 4D mode.

Tobias, L.↗