Engineering topics

Ocko, Benjamin M.

Publications and source records attributed to Ocko, Benjamin M..

8 records

DOE OSTI2024

Enhanced rare earth element recovery with cross-linked glutaraldehyde-lanthanide binding peptides in foam-based separations

Lanthanide Binding Tag (LBT) peptides that coordinate selectively with lanthanide ions can be used to replace the energy intensive processes used for the separation of rare earth elements (REEs). These surface-active biomolecules, once selectively complexed with the trivalent REE cations, can adsorb to air/aqueous interfaces of bubbles for foam-based REEs recovery. Glutaraldehyde, an organic compound that is a homobifunctional crosslinker for proteins and peptides, can be used to enhance the adsorption and interfacial stabilization of lanthanide-bound peptides films. The stability of the interfacial cross-linked films was tested by measuring their dilational and shear surface rheological properties. Surface activity of the adsorbed species was analyzed using pendant drop tensiometry, while surface density and molecular arrangement were determined using x-ray reflectivity and x-ray fluorescence near total reflection. Glutaraldehyde cross-linked REE-peptide complexes enhance the adsorption of lanthanides to air-water interfaces, resulting in thicker interfacial structures. Subsequently, these thicker layers enhance the dilational and shear interfacial rheological properties. The interfacial film stabilization and REEs extraction promoted by the cross-linker presented in this work provides an approach to integrate glutaraldehyde as a substitute of common foam stabilizers such as polymers, surfactants, and particles to optimize the recovery of REEs when using biomolecules as extractants.

36 MATERIALS SCIENCE↗

DOE OSTI2024

Reconstructing the reflectivity of liquid surfaces from grazing incidence X-ray off-specular scattering data

The capillary wave model of a liquid surface predicts both the X-ray specular reflection and the diffuse scattering around it. A quantitative method is presented to obtain the X-ray reflectivity (XRR) from a liquid surface through the diffuse scattering data around the specular reflection measured using a grazing incidence X-ray off-specular scattering (GIXOS) geometry at a fixed horizontal offset angle with respect to the plane of incidence. With this approach the entire Q z -dependent reflectivity profile can be obtained at a single, fixed incident angle. This permits a much faster acquisition of the profile than with conventional reflectometry, where the incident angle must be scanned point by point to obtain a Q z -dependent profile. The XRR derived from the GIXOS-measured diffuse scattering, referred to in this paper as pseudo-reflectivity, provides a larger Q z range compared with the reflectivity measured by conventional reflectometry. Transforming the GIXOS-measured diffuse scattering profile to pseudo-XRR opens up the GIXOS method to widely available specular XRR analysis software tools. Here the GIXOS-derived pseudo-XRR is compared with the XRR measured by specular reflectometry from two simple vapor–liquid interfaces at different surface tension, and from a hexadecyltrimethylammonium bromide monolayer on a water surface. For the simple liquids, excellent agreement (beyond 11 orders of magnitude in signal) is found between the two methods, supporting the approach of using GIXOS-measured diffuse scattering to derive reflectivities. Pseudo-XRR obtained at different horizontal offset angles with respect to the plane of incidence yields indistinguishable results, and this supports the robustness of the GIXOS-XRR approach. The pseudo-XRR method can be extended to soft thin films on a liquid surface, and criteria are established for the applicability of the approach.

36 MATERIALS SCIENCE↗

DOE OSTI2024

Ionic-like Superlattices by Charged Nanoparticles: A Step Toward Photonics Applications

Controlling interactions among nanoparticles is paramount to achieving assemblies vital to technologies seeking to exploit their cutting-edge collective properties. Although various techniques have been advanced, robust ones are necessary for upscaling nanoparticle assembly and crystallization. Here, we show that by grafting gold nanoparticles (AuNPs) with charge-end-group-thiolated poly(ethylene glycol), we control the charge of each AuNP. Such control facilitates the formation of various two-dimensional structures of oppositely charged binary constituents at vapor/liquid interfaces. Using surface-sensitive synchrotron X-ray diffraction techniques, we established the formation of distinct checkerboard square lattice structures at a range of pH values and molar ratios of the constituents. By regulating pH, the superlattices can transform from a square to a hexagonal lattice, or vice versa, and to a single-component superstructure at the interface. In conclusion, our recipe for the control of charges and their consequent interactions among nanoparticles can be readily exploited in the assembly of photonics and plasmonics devices in two and three dimensions.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2023

Two-dimensional assembly of gold nanoparticles grafted with charged-end-group polymers

We introduced charged terminal groups to polymers that graft nanoparticles enable Coulombic control over their assembly by tuning the pH and salinity of their aqueous suspensions. Gold nanoparticles (AuNPs) are grafted with poly (ethylene glycol) (PEG) terminated with CH 3 (charge-neutral), COOH (negatively charged) or NH 2 groups (positively charged), and characterized with dynamic light scattering, ζ-potential, and thermal gravimetric analysis. Liquid surface X-ray reflectivity (XR) and grazing incidence small-angle X-ray scattering (GISAXS) are used to determine the density profile and in-plane structure of the AuNPs assembly at the aqueous surface. Assembly of PEG-AuNPs at the liquid/vapor interface is tunable by adjusting pH or salinity for COOH but less for NH 2 terminals. The distinct assembly behaviors are attributed to the overall charge of PEG-AuNPs as well as PEG conformation. COOH-PEG corona is more compact than those of the other terminal groups, leading to a crystalline structure with a smaller superlattice. The net charge per particle depends not only on the PEG terminal groups but also on the cation sequestration of PEG and the intrinsic negative charge of the AuNP surface. The closeness to overall charge neutrality, and hydrogen bonding in play, brought by NH 2 -PEG, drive NH 2 -PEG-AuNPs to assembly and crystallinity without additives to the suspensions.

36 MATERIALS SCIENCE↗

DOE OSTI2022

Counterions under a Surface-Adsorbed Cationic Surfactant Monolayer: Structure and Thermodynamics

The surface adsorption of ionic surfactants is fundamental for many widespread phenomena in life sciences and for a wide range of technological applications. However, direct atomic-resolution structural experimental studies of noncrystalline surface-adsorbed films are scarce. Thus, even the most central physical aspects of these films, such as their charge density, remain uncertain. Consequently, theoretical models based on contradicting assumptions as for the surface films' ionization are widely used for the description and prediction of surface thermodynamics. We employ X-ray reflectivity to obtain the angstrom Ångström-scale surface-normal structure of surface-adsorbed films of the cationic surfactant cetyltrimethylammonium bromide (CTAB) in aqueous solutions at several different temperatures and concentrations. In conjunction with published neutron reflectivity data, we determine the surface-normal charge distribution due to the dissociated surfactants' headgroups. The distribution appears to be inconsistent with the Gouy-Chapman model yet consistent with a compact Stern layer model of condensed counterions. Here, the experimental surfactant adsorption thermodynamics conforms well to classical, Langmuir and Kralchevsky, adsorption models. Furthermore, the Kralchevsky model correctly reproduces the observed condensation of counterions, allowing the values of the adsorption parameters to be resolved, based on the combination of the present data and the published surface tension measurements.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2022

Compact Peptoid Molecular Brushes for Nanoparticle Stabilization

Controlling the interfaces and interactions of colloidal nanoparticles (NPs) via tethered molecular moieties is crucial for NP applications in engineered nanomaterials, optics, catalysis, and nanomedicine. Despite a broad range of molecular types explored, there is a need for a flexible approach to rationally vary the chemistry and structure of these interfacial molecules for controlling NP stability in diverse environments, while maintaining a small size of the NP molecular shell. Here, we demonstrate that low-molecular-weight, bifunctional comb-shaped, and sequence-defined peptoids can effectively stabilize gold NPs (AuNPs). The generality of this robust functionalization strategy was also demonstrated by coating of silver, platinum, and iron oxide NPs with designed peptoids. Each peptoid (PE) is designed with varied arrangements of a multivalent AuNP-binding domain and a solvation domain consisting of oligo-ethylene glycol (EG) branches. Among designs, a peptoid (PE5) with a diblock structure is demonstrated to provide a superior nanocolloidal stability in diverse aqueous solutions while forming a compact shell (similar to 1.5 nm) on the AuNP surface. We demonstrate by experiments and molecular dynamics simulations that PE5-coated AuNPs (PE5/AuNPs) are stable in select organic solvents owing to the strong PE5 (amine)-Au binding and solubility of the oligo-EG motifs. At the vapor-aqueous interface, we show that PE5/AuNPs remain stable and can self-assemble into ordered 2D lattices. The NP films exhibit strong near-field plasmonic coupling when transferred to solid substrates.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2022

Binary Superlattices of Gold Nanoparticles in Two Dimensions

Here, we have created two-dimensional (2D) binary superlattices by cocrystallizing gold nanoparticles (AuNPs) of two distinct sizes into √3 x √3 and 2 x 2 complex binary superlattices, derived from the hexagonal structures of the single components. The building blocks of these binary systems are AuNPs that are functionalized with different chain lengths of poly(ethylene glycol) (PEG). The assembly of these functionalized NPs at the air–water interface is driven by the presence of salt, causing PEG-AuNPs to migrate to the aqueous surface and assemble into a crystalline lattice. We have used liquid surface X-ray reflectivity (XR) and grazing incidence small-angle X-ray scattering (GISAXS) to examine the assembly and crystallization at the liquid interface.

36 MATERIALS SCIENCE↗

DOE OSTI2021

Structure of Molten Alkali Chlorides at Charged Interfaces and the Prediction and Interpretation of Their X-ray Reflectivity

The fundamental properties of molten salts have been the subject of research that spans a century. Yet, in the past few years, there has been an unprecedented surge in interest for these systems in the bulk and under confinement by walls and interfaces including under applied potentials. This is driven by the prospect of exciting and very practical energy technologies, including those in the solar and nuclear fields. This article sets to answer two simple but fundamental questions. How does the liquid structure of alkali chlorides change at a real interface when it is charged? Also, how would such changes on the liquid side of the interface be detected in X-ray reflectivity experiments? We use an interface mimicking conductive diamond, which because of its lattice spacing, is an excellent choice for reflectivity experiments. The reason for our interest in X-ray reflectivity is that, as opposed to electrochemical measurements alone, this is likely the only technique in which atomic level information at the liquid side of the interface can be gained under the extreme temperature environments of molten salts. As it will become apparent, the interpretation of reflectivity results in terms of atomic positions is complex when multiple species with different X-ray contrasts on the liquid side are considered. A theoretical scheme termed “the peaks and antipeaks analysis of reflectivity” originally introduced in our prior work (J. Phys. Chem. C2019, 123 (8), 4914–4925) is expanded to interpret the structural changes at the interface as a function of applied electrical bias.

36 MATERIALS SCIENCE↗