Engineering topics

Ofman, L.

Publications and source records attributed to Ofman, L..

23 records · Page 2

NASA NTRS1995

Heating of coronal holes by the resonant absorption and dissipation of Alfven waves and its relation to solar wind acceleration

Coronal hole regions are well known sources of high-speed solar wind, however to account for the observed properties of the solar wind a source of momentum and heat must be included. Alfven waves were suggested as the possible source of heating that accelerates the solar wind. We investigate the propagation of the Alfven waves in coronal holes via numerical solution of the linearized 2-D resistive MHD equations in slab geometry. The Alfven waves are driven at the lower boundary of the coronal hole and propagate into the corona. The waves are reflected at the coronal hole boundary and part of the wave energy leaks out of the coronal hole. We compare the calculated wavelengths and the attenuation rate of the fast mode Alfven waves in the leaky waveguide formed by the coronal hole with the analytical ideal MHD solutions. The formation of resonance heating layers is found to occur when shear Alfven waves propagate in an inhomogeneous coronal hole. The heating is enhanced when fast mode waves couple to the shear Alfven waves. The narrow heating layers are formed near the location of the ideal resonance, which might occur near the coronal hole boundary for a nearly constant density coronal hole, surrounded by a higher density plasma. We investigate the dependence of the heating on the driver frequency, the Lundquist number, and on the heliocentric distance. and find that the low frequency Alfven waves can be an efficient source of heating at large distances from the Sun. We discuss the relation of our results to the observed properties of high-speed solar wind and coronal holes.

Ofman, L.↗

NASA NTRS1995

Coronal heating by the resonant absorption of Alfven waves: Wavenumber scaling laws.

The importance of global modes in coronal loop heating is well established. In the present work the scaling of the global-mode resonant heating rate with the perturbation wavenumbers is studied with the numerical solution of the linearized time-dependent MHD equations for a full compressible, low-beta, resistive plasma using an implicit integration scheme. The numerical simulations demonstrate that the dissipation on inhomogeneties in the background Alfven speed occurs in narrow resonant layer with the highest heating rate at the global-mode frequency. The global-mode heating rate H (sub r) was found to scale as H (Sub r) approximately k (sub y) (exp 1.03) when k (sub z) = 0.1, and as H (sub r) approximately k (sub y) (exp -1.93) when k (sub z) = 0.75, where k (sub y) and k (sub z) are the wavenumbers in the perpendicular and parallel to the magnetic field directions, respectively, while the dependence of H (sub r) on k (sub z) is more complex. The quality factor Q of the MHD resonance cavity scales as Q approximately k (sub y) (exp -1.8) for k (sub z) = 0.75 and as Q approximately k (sub y) (exp -1.46) for k (sub z) = 0.1. The numerically determined heating rate scaling, the global-mode fequency, and the quality factor are in good agreement with the analytical linear theory. The magnitude of the perturbed velocities was found to decrease with k (sub y). Assuming typical coronal loop parameters (B (sub 0) = 100-200 G, upsilon (sub A) = 2000-4000 km/s), the Alfven waves can supply the required heating to a low-Q loops.

Ofman, L.↗

NASA NTRS1994

Coronal heating by the resonant absorption of Alfven waves: The effect of viscous stress tensor

The time-dependent linearized magnetohydrodynamics (MHD) equations for a fully compressible, low-beta, viscoresistive plasma are solved numerically using an implicit integration scheme. The full viscosity stress tensor (Braginskii 1965) is included with the five parameters eta(sub i) i = 0 to 4. In agreement with previous studies, the numerical simulations demonstrate that the dissipation on inhomogeneities in the background Alfven speed occurs in a narrow resonant layer. For an active region in the solar corona the values of eta(sub i) are eta(sub o) = 0.65 g/cm/s, eta(sub 1) = 3.7 x 10(exp -12) g/cm/s, eta(sub 2) = 4 eta(sub 1), eta(sub 3) = 1.4 x 10(exp -6) g/cm/s, eta(sub 4) = 2 eta(sub 3), with n = 10(exp 10)/cu cm, T = 2 x 10(exp 6) K, and B = 100 G. When the Lundquist number S = 10(exp 4) and R(sub 1) much greater than S (where R(sub 1) is the dimensionless shear viscous number) the width of the resistive dissipation layer d(sub r) is 0.22a (where a is the density gradient length scale) and d(sub r) approximately S(exp -1/3). When S much greater than R(sub 1) the shear viscous dissipation layer width d(sub r) scales as R(sub 1)(exp -1/3). The shear viscous and the resistive dissipation occurs in an overlapping narrow region, and the total heating rate is independent of the value of the dissipation parameters in agreement with previous studies. Consequently, the maximum values of the perpendicular velocity and perpendicular magnetic field scale as R(sub 1)(exp -1/3). It is evident from the simulations that for solar parameters the heating due to the compressive viscosity (R(sub 0) = 560) is negligible compared to the resistive and the shear viscous (R(sub 1)) dissipation and it occurs in a broad layer of order a in width. In the solar corona with S approximately equals 10(exp 4) and R(sub 1) approximately equals 10(exp 14) (as calculated from the Braginskii expressions), the shear viscous resonant heating is of comparable magnitude to the resistive resonant heating.

Ofman, L.↗

NASA NTRS1993

Nonlinear evolution of resistive tearing mode instability with shear flow and viscosity

The effect of shear flow on the nonlinear evolution of the tearing mode is investigated via numerical solutions of the resistive MHD equations in slab geometry, using a finite-difference alternative-direction implicit method. It was found that, when the shear flow is small (V less than 0.3), the tearing mode saturates within one resistive time, whereas for larger flows the nonlinear saturation develops on longer time scales. The magnetic energy release decreases and the saturation time increases with increasing values of V for both small and large resistivity. Shear flow was found to decrease the saturated magnetic island width and to generate currents far from the tearing layer. Results suggest that equilibrium shear flow may improve the confinement of tokamak plasma.

Ofman, L.↗

NASA NTRS1990

Thermally conductive magnetohydrodynamic flows in helmet-streamer coronal structures

The behavior of thermally conductive plasma flows in helmet-streamer coronal structures is investigated within the framework of the axisymmetric nonrotating one-fluid MHD model. Continuous subsonic-supersonic solutions satisfying observed boundary conditions at the sun as well as the vanishing of the temperature at infinity are obtained and presented. Special attention is paid to the combined effects of conductive flow (and corresponding thermal force) and rapidly diverging magnetic field on the critical points. In this, the heliocentric distance of the neutral point determining the separation between closed and open field lines (cusp) is treated as a free parameter. These thermally conductive solutions are contrasted with those provided by corresponding isothermal models.

Cuperman, S.↗